Homework Help Question & Answers

Given: There is a wastewater treatment plant that has a Primary Clarifier, Activated Sludge, Secondary clarifier...

Given: There is a wastewater treatment plant that has a Primary Clarifier, Activated Sludge, Secondary clarifier and the aver

Given: There is a wastewater treatment plant that has a Primary Clarifier, Activated Sludge, Secondary clarifier and the average daily flow was 1 mgd. Calculate the volume needed if the activated sludge is 24 hours 10 Mgal 100 Mgal 1 Mgal 1000 Mgal
0 0
Add a comment
Answer #1

Average daily flow rate =Q=1 million gallon /day =1 million gallon/24hours.=1/24 million gallons/ hour

As1 day =24 hours.

Time given =t= 24 hours

Volume needed =V = Q×t = 1/24(Mgal/hrs) × 24 (hrs)

V=1Mgal

Correct answer- C) 1 Mgal

Add a comment
Know the answer?
Add Answer to:
Given: There is a wastewater treatment plant that has a Primary Clarifier, Activated Sludge, Secondary clarifier...
Your Answer:

Post as a guest

Your Name:

What's your source?

Earn Coin

Coins can be redeemed for fabulous gifts.

Not the answer you're looking for? Ask your own homework help question. Our experts will answer your question WITHIN MINUTES for Free.
Similar Homework Help Questions
  • A wastewater treatment plant that treats wastewater to secondary treatment standards uses a primary sedimentation process...

    A wastewater treatment plant that treats wastewater to secondary treatment standards uses a primary sedimentation process followed by conventional activated sludge process composed of covered aeration tanks and secondary clarifiers. You are asked to calculate the different operation parameters to make sure that the system is operated within normal process ranges listed in the reference tables below. Table 5-20 Typical design information for primary sedimentation tanks U.S. customary units Item Unit Range Typical Primary sedimentation tanks followed by secondary treatment...

  • Penn State’s wastewater treatment plant handles 10 MGD. The influent to the primary clarifier has 400...

    Penn State’s wastewater treatment plant handles 10 MGD. The influent to the primary clarifier has 400 mg/L solids. The primary clarifier does a great job of removing solids, taking out 27%. The sludge flows at a rate of 0.01 MGD. a. What is the solids concentration of the primary clarifiers sludge? B. What total mass of solids (in kg/year) heads to the landfill from the primary clarifier?

  • Secondary Treatment Based on a plant flow rate of 40 mgd, design an activated sludge, secondary t...

    Secondary Treatment Based on a plant flow rate of 40 mgd, design an activated sludge, secondary treatment system with recycle which maintains a MLVSS = 2,000 mg/L in the aeration reactor and has an average Solids Retention Time (SRT)-4 days. The biota kinetic constants are Kinetic Coefficients for the Activated-sludge Process for the Removal of Organic Matter from Domestic Wastewater Endogenous Decay Coefficient- k(d) 0.1 Half-velocity constant- K(s VSS/qVss-da 15 Mg/L bsCOD Max. Specific Substrate Utilization Rate-k 6 G bsCOD/gVSS-da...

  • 1. A circular secondary clarifier (a.k.a. a final clarifier) is to be designed for an activated...

    1. A circular secondary clarifier (a.k.a. a final clarifier) is to be designed for an activated sludge treatment plant serving a municipality. The state regulatory agency criteria for final clarifiers used for activated sludge are: Peak SOR = 1,200 gal/day-ft2 Average SOR = 500 gal/day-ft2 Peak solids loading 50 lb/day-ft Peak weir loading-30,000 gal/day.ft The average flow to the aeration basin prior to junction with the recycle line is 3.5 MGD ·The recycled sludge flow is 30 percent of the...

  • A wastewater treatment plant receives an average of 4.5 MGD of wastewater flow. Two rectangular primary...

    A wastewater treatment plant receives an average of 4.5 MGD of wastewater flow. Two rectangular primary clarifiers operating in parallel will treat the flow. If the overflow rate is 700 gpd/ft2 and the depth of the clarifier is 10 ft, Determine: a) the dimensions of each clarifier assuming L:W ratio = 5:1. b) the detention time of each clarifier (in days).

  • A single primary clarifier is being designed for a new 3 MGD wastewater treatment plant. The...

    A single primary clarifier is being designed for a new 3 MGD wastewater treatment plant. The clarifier is being designed with an overflow rate of 1,000 gal/day-ft?, a depth of 12 ft, and a length of 100 ft. Determine the width of the primary clarifier. 20 ft 30 ft 40 ft 50 ft

  • A completely mixed activated sludge plant is designed to treat 10,000 m3/d of an industrial wastewater....

    A completely mixed activated sludge plant is designed to treat 10,000 m3/d of an industrial wastewater. The wastewater has a BOD5 of 1200 mg/L. Pilot plant data indicates that a reactor volume of 6090 m3 with an MLSS concentration of 5000 mg/L should produce 83% BOD5 removal. The value for Y is determined to be 0.7 kg/kg and the value of kd is found to be 0.03 d–1. Under ow solids concentra- tion is 12,000 mg/L. The ow diagram is...

  • Describe in detail the function of the wastewater treatment plant components below and what stage of treatment they are...

    Describe in detail the function of the wastewater treatment plant components below and what stage of treatment they are (primary, secondary, tertiary) use the lines provided for the second part of this question. For the descriptions use any space on the next page. In the descriptions you must state what is specifically being treated, and if compounds are generated in a particular treatment stage you must describe that as well. In addition, if a particular process has two stages -...

  • (30 points) A completely mixed activated sludge system comprised of an aerated reactor and a secondary clarifier with sludge return is going to treat 15,000 m/d of industrial wastewater. Th...

    (30 points) A completely mixed activated sludge system comprised of an aerated reactor and a secondary clarifier with sludge return is going to treat 15,000 m/d of industrial wastewater. The primary effluent going to the reactor has a BODs of 1,100 mg/L that must be reduced to 150 mg/L prior to discharge to a municipal sewer. The pilot study was conducted and generated the following results: 3. Mean cell residence time- 5 day, MLSS concentration in the reactor 7.200 mg/L...

  • 2. (40 pts) A wastewater treatment plant has an activated sludge system. The aeration tank is...

    2. (40 pts) A wastewater treatment plant has an activated sludge system. The aeration tank is 252 ft long, 25 ft wide, and 18 ft deep. An engineer will model the steady-state performance as first order (k= 8.3 d ?) as a series of 9 equal-volume CFSTRs. The flow rate is 3.1 MGD and the influent BODS is 165 mg/L. a) If the engineer's model is correct, what is the outlet BOD5 concentration (mg/L)? b) If the model is correct,...

ADVERTISEMENT
Free Homework Help App
Download From Google Play
Scan Your Homework
to Get Instant Free Answers
Need Online Homework Help?
Ask a Question
Get Answers For Free
Most questions answered within 3 hours.
ADVERTISEMENT
ADVERTISEMENT