Machine Layout

Question

Question

Bending stress in graduated length leaves are more than that in full length leaves.
a) Yes
b) No
c) In some cases
d) Can’t be stated

Answer 1

Answer #1

Answer: b
Explanation: Bending stress in full length leaves is around 50% higher than graduated length leaves.

answered by: eleirose3377

Answer 2

Answer #2

Option b.

Bending stress in. full length leaves is around 50% higher compared to that in graduated length leaves.

answered by: Tulsiram Garg

Answer 3

Similar Homework Help Questions

Machine Layout

A leaf spring consists of 3 extra full length leaves and 14 graduated length leaves. The maximum force that can act on the spring is 70kN and the distance between eyes of the spring is 1.2m. Width and thickness of the leaves are 100mm and 12mm respectively. Calculate the initial pre load required to close the nip.a) 4332.2Nb) 4674.1Nc) 4985.4Nd) Can’t be determined
Machine Layout

Velocity ratio for chain drive is lesser than that for belts.a) Yesb) Noc) In some casesd) Can’t be determined
Machine Layout

There is problem of alignment in deep groove ball bearings.a) Yesb) No, it is self-aligningc) It aligns itself only in some particular casesd) Can’t be determined

Machine Layout

A leaf spring consists of 3 extra full length leaves and 14 graduated length leaves. The maximum force that can act on the spring is 70kN and the distance between eyes of the spring is 1.2m. Width and thickness of the leaves are 100mm and 12mm respectively. If modulus of elasticity is 207000N/mm², calculate the initial nip.a) 26.8mmb) 24.9mmc) 22.5mmd) 23.1mm
Machine Design

V threads are highly recommended for fastening as well as power transmission purpose.a) Yesb) Neverc) In some casesd) Can’t be stated
Machine Layout

Are the bolts 2 and 3 under same force?a) Yesb) Noc) Depends on nature of force whether it is of shear or bending in natured) Can’t be determined

Machine Layout

The velocity of the chain is always constant in case of chain drive.a) Yesb) No, it can never be constantc) It is constant above a particular valued) Can’t be stated
Machine Layout

The angular play bearing must be mounted without axial play.a) Yesb) Little tolerance is adjustedc) Little tolerance is necessaryd) Can’t be stated
Machine Layout

Fitted bearing must be partial bearing.a) Trueb) Noc) No lubricating space is requiredd) Can’t be stated

Machine Layout

Nipping is defined as leaving the gap between full length leaf and graduated length leaf.a) Trueb) False