A brick of mass m=0.49 kg is set against a spring with a spring constant of k1 = 639 N/m which has been compressed by a distance of 0.1 m
A brick of mass m=0.49 kg is set against a spring with a spring constant of k1 = 639 N/m which has been compressed by a distance of 0.1 m. Some distance in front of it, along a frictionless surface, is another spring with a spring constant of k2 = 261 N/m.
Part (a) How far, d2 in meters, will the second spring compress when the brick runs into it?
Part (b) How fast, v in meters per second, will the brick be moving when it strikes the second spring?
Part (c) Now assume that the surface is rough (that is, not frictionless). You perform the experiment and observe that the second sprig only compresses a distance dy/2. How much energy, in joules, was lost to friction?
Homework Answers
Add Answer to:
A brick of mass m=0.49 kg is set against a spring with a spring constant of k1 = 639 N/m which has been compressed by a distance of 0.1 m
Please show all work 1. A horizontal massless spring with spring constant 300 N/m is compressed...
Please show all work
1. A horizontal massless spring with spring constant 300 N/m is compressed 20 cm. The spring launches the block of mass 1 kg. When the block reaches the other side of the room it compresses a massless spring 600 N/m as shown in the figure. The surface is frictionless except the small part of length 2m, which has a coefficient of kinetic friction 0.2. Find the maximum compression of the spring 600 N/m. 300 N/m 600N/m...
A 12 kg block is pressed against a spring with spring constant k = 1424 N/m....
A 12 kg block is pressed against a spring with spring constant k = 1424 N/m. The spring is normally 65 cm long but the block is pressed against it to compress the spring until it is only 27 cm long. The block is then released and the spring pushes it forward onto a frictionless surface. a)How fast is the block moving immediately after it leaves the spring? b) The mass then slides across a 2.5 m wide surface with...
A horizontal spring with spring constant 130 N/m is compressed 19 cm and used to launch...
A horizontal spring with spring constant 130 N/m is compressed 19 cm and used to launch a 2.8 kg box across a frictionless, horizontal surface. After the box travels some distance, the surface becomes rough. The coefficient of kinetic friction of the box on the surface is 0.15. Use work and energy to find how far the box slides across the rough surface before stopping. Express your answer to two significant figures and include the appropriate units.
3. (10pts) A spring, with a spring constant of 5710 N/m, is compressed by 0.45 m...
3. (10pts) A spring, with a spring constant of 5710 N/m, is compressed by 0.45 m and used to launch a 15.5 kg mass from rest from point A across a frictionless surface and down a short hill that is H = 1.73 m high. The surface becomes rough at point B, and the mass comes to a stop at point C. (a) (5pts) How much work was done by friction between B and C? (b) (5pts) If the coefficient...
A block of mass 3 kg is pushed against a spring of spring constant 3000 N/m....
A block of mass 3 kg is pushed against a spring of spring constant 3000 N/m. Initially, the spring is compressed by a distance of 0.220 m, when the block is released from rest and travels along a horizontal frictionless surface before encountering a frictionless ramp, inclined at an angle of 37° above the horizontal. How far along the ramp does the block travel before momentarily coming to rest?
A block of mass m is pushed against a spring of spring constant k. The spring...
A block of mass m is pushed against a spring of spring constant k. The spring is compressed by a distance d, the block is then released. It is launched by the spring along a horizontal frictionless surface with a final speed v. A second block, this one having mass 9m is pushed against the same spring and released, gaining a final speed 3v. By what distance was the spring compressed in the second case?
spring You have a spring, with spring constant K - 50.0 N/m. A mass, m 0.44...
spring You have a spring, with spring constant K - 50.0 N/m. A mass, m 0.44 kg is attached to the (a) Calculate the work required to compress the spring from x 0 to x-. 0.10 meters. (b) Calculate the work required to compress the spring from x =-0.10 tox·-0.20 meters (it's NOT the same as (an (c) ok, so you've compressed it a total distance of 0.20 meters (Point A on figure). speed at point A is zero. Now...
The spring in the figure has a spring constant of 1000 N/m. It is compressed 13.0...
The spring in the figure has a spring constant of 1000 N/m. It is compressed 13.0 cm, then launches a 200 g block. The horizontal surface is frictionless, but the block's coefficient of kinetic friction on the incline is 0.210. (Figure 1) - Part A What distance d does the block sail through the air? Express your answer with the appropriate units. C: A 0 = ? Value Units Submit Request Answer Figure 1 of 1 > < Return to...
A spring with spring constant 28 N/m is compressed a distance of 7.5 cm by a...
A spring with spring constant 28 N/m is compressed a distance of 7.5 cm by a ball with a mass of 201.5 g (see figure below). The ball is then released and rolls without slipping along a horizontal surface, leaving the spring at point A. The process is repeated, using a block instead, with a mass identical to that of the ball. The block compresses the spring by 7.5 cm and is also released, leaving the spring at point A....
23. A block (m = 1.0 kg) is compressed against a spring (k = 800 N/m)...
23. A block (m = 1.0 kg) is compressed against a spring (k = 800 N/m) a distance of 25 cm on a rough surface with uk = 2 and released from rest. If ø= 18°, find the speed of the block once it has traveled a distance d = 3.0 m up the incline. m
Please show all work
1. A horizontal massless spring with spring constant 300 N/m is compressed 20 cm. The spring launches the block of mass 1 kg. When the block reaches the other side of the room it compresses a massless spring 600 N/m as shown in the figure. The surface is frictionless except the small part of length 2m, which has a coefficient of kinetic friction 0.2. Find the maximum compression of the spring 600 N/m. 300 N/m 600N/m...
spring You have a spring, with spring constant K - 50.0 N/m. A mass, m 0.44 kg is attached to the (a) Calculate the work required to compress the spring from x 0 to x-. 0.10 meters. (b) Calculate the work required to compress the spring from x =-0.10 tox·-0.20 meters (it's NOT the same as (an (c) ok, so you've compressed it a total distance of 0.20 meters (Point A on figure). speed at point A is zero. Now...
The spring in the figure has a spring constant of 1000 N/m. It is compressed 13.0 cm, then launches a 200 g block. The horizontal surface is frictionless, but the block's coefficient of kinetic friction on the incline is 0.210. (Figure 1) - Part A What distance d does the block sail through the air? Express your answer with the appropriate units. C: A 0 = ? Value Units Submit Request Answer Figure 1 of 1 > < Return to...
A spring with spring constant 28 N/m is compressed a distance of 7.5 cm by a ball with a mass of 201.5 g (see figure below). The ball is then released and rolls without slipping along a horizontal surface, leaving the spring at point A. The process is repeated, using a block instead, with a mass identical to that of the ball. The block compresses the spring by 7.5 cm and is also released, leaving the spring at point A....
23. A block (m = 1.0 kg) is compressed against a spring (k = 800 N/m) a distance of 25 cm on a rough surface with uk = 2 and released from rest. If ø= 18°, find the speed of the block once it has traveled a distance d = 3.0 m up the incline. m
Most questions answered within 3 hours.
-
Where is the error in this code sequence?
String s1 = "Hello";
String s2 = "ello";...
asked 11 months ago -
Financial data for Joel de Paris, Inc., for last year
follow:
Joel de Paris, Inc.
Balance...
asked 11 months ago -
Consider this reaction:
Al2(SO4)3 (aq)+ BaCl3
(aq) Al2Cl6 (aq)- +
3BaSO4(s) . What is the...
asked 11 months ago -
Suppose that Savneet is considering increasing her
recent random sample from 20 car rentals to 40...
asked 11 months ago -
Trucks arrive at an unloading terminal at an average rate of 120
per hour.
Trucks arrive...
asked 11 months ago -
Why are methanol and ethanol completely soluble in water while
octanol is not very little soluble....
asked 11 months ago -
A facilities manager at a university reads in a research report
that the mean amount of...
asked 11 months ago -
When the CuSO4 is rehydrated by adding water to the anhydrous
compound, is this an endothermic...
asked 11 months ago -
A ray of sunlight is passing from diamond into crown glass; the
angle of incidence is...
asked 11 months ago -
A block of mass 0.249 kg is placed on top of a light, vertical
spring of...
asked 11 months ago -
how do the kidneys compensate in the presences of acidosis
a) trigger hyperventilate
b) reserve acid...
asked 11 months ago -
Question 501 pts
The rental rate of capital to the firm increases. Which of the
following...
asked 11 months ago