A)
Correct answer is option (b)
The pressure remains constant regardless of the level of the liquid in the delivery vessel.
B)
Pressure, P1 = P2 = P_atm
0.5 ρ v22 = ρ g b
Velocity, v = (2 g b)(1/2)
Comment in case any doubt please rate my answer...
Part A and B please! Thabk You! (Figure 1) shows a device called Mariotte's bottle that...
For the vectors given in the figure, determine (Figure 1) | Part A Part B the direction of A - B+C Express your answer using three significant figures. VALO A O O ? = below x axis Submit Request Answer Figure < 1 of 1 > Part C B (B = 26.5) the magnitude of A+B-C Express your answer using three significant figures. 5609 A (A = 44.0) 128.00 O ADD R o B ? C(C= 31.0) |Ā+B – 1...
part a-d
2 A paint sprayer pumps air through a constriction in a 0.025- m diameter pipe, as shown in the figure. The flow causes the pressure in the constricted area to drop and paint rises up the feed tube and enters the air stream. The speed of the air stream in the 0.025-m diameter sections is 5.00 m/s. The density of the air is 1.29 kg/m3, and the density of the paint is 1200 kg/m3. We can treat the...
I can't figure out part b. Please help me!
How much work is required to accelerate a proton from rest up to a speed of 0.993 c? Express your answer with the appropriate units. W = 7010 MeV Submit Previous Answers ✓ Correct Part B What would be the momentum of this proton? Express your answer with the appropriate units. IVO ADO A o 2 ? p= MeV/c P Pearson
98 *°* When the hydrometer of Problem 48 (Figure 13-34) is placed in a liquid whose specific gravity is greater than some minimum value, the device floats with part of the glass tube above the liquid level. Consider a hydrometer that has a spherical bulb 2.4 cm in diameter. The glass tube attached to the bulb is 20 cm long and has a diameter of 7.5 mm. The mass of the hydrometer before lead pellets are dropped into the bulb...
Review The figure(Figure 1) shows a zero resistance rod sliding to the right on two zero-resistance rails separated by the distance L = 0.515 m. The rails are connected by a 13.522 resistor, and the entire system is in a uniform magnetic field with a magnitude of 0.822 T Part A Find the force that must be exerted on the rod to maintain a constant current of 0.149 A in the resistor Figure 1 of 1 19 | A20 ?...
Part A Consider an ideal two-stage refrigeration system (Figure 1) that uses R-12 as the working fluid. Saturated liquid leaves the condenser at 40 °C and is throttled to -20 °C. The liquid and vapor at this temperature are separated, and the liquid is throttled to the evaporator temperature at -70 °C. Vapor leaving the evaporator is compressed to the saturation pressure corresponding to -20 °C, after which it is mixed with the vapor leaving the flash chamber. Use TESTCalc...
Revie Part A In a carnival booth, you win a stuffed giraffe if you toss a quarter into a small dish. The dish is on a shelf above the point where the quarter leaves your hand and is a horizontal distance of 2.45 m from this point (the figure (Figure 1)). If you toss the coin with a velocity of 5.23 m/s at an angle of 55.2° above the horizontal, the coin lands in the dish. You can ignore air...
need pls complete steps thaaanks
Part B-Fluids Attempt any two of the following three problems Evangelista Torricelli (1608-1647) was the first to put forward the idea that we live at the bottom of an ocean of air. Given the value of atmospheric pressure at the surface of the Earth, and the fact that there is zero pressure in the vacuum of space, determine the depth of the atmosphere, assuming that the density of air and the acceleration of gravity are...
Liquid saline flows steadily along the duct in Figure 1, which is part of an infusion set. The duct has constant cross-sectional area Ao-18 mm. The fluid velocity at the inlet section is Vo 0.35 m/s. A drug is added to the saline through a side port connected to the main duct at an angle θ 45°. The cross-sectional area of the side access is A1-10 mm2 and the drug is injected with velocity V,-0.8 m/s. The drug has the...
please answer all of part i really need them ASAP ...
The level ho of liquid in a vertical cylindrical tank as shown in Figure 4 is related to the inflow of liquid qi by the time domain equation d h dt where τ RLGL, the steady state gain of the system is G RL/pg and the tank capacitance, inlet ine ho outlet vave Tank Figure 4: Tank Level Process (a) You carry out some measurements on the tank and...