
The noise level due to a compressor located outdoors is 89 dB at 15 m with...
5. The noise level caused by a compressor located outdoors is 77 dB at 20 m. Determine the level at 80 m if there are no intervening structures
The decibel level of the noise from a jet aircraft is 130 dB when measured 24.8 m from the aircraft. How much sound power does the jet aircraft emit? Answer in units of W. How much sound power would strike the eardrum of an airport worker 24.8 m from the aircraft? Assume the diameter of the worker’s eardrum is 1.7 × 10−2 m. Answer in units of W.
Three Honda snowblowers are located equal 3.00 m distances from
Harry. Harry measures a sound level of 104 dB.
a. What is the sound intensity of a single snowblower?
b. What is the sound power output of each snowblower?
c. What sound level would Harry measure if two more snowblowers
started up at this same distance?
Three Honda snowblowers are located equal 3.00 m "distances from Harry. Harry measures a sound level Homework #4 Due Tuesday Jan 29 of 104...
Three Honda snowblowers are located equal 3.00 m distances from
Harry. Harry measures a sound level of 104 dB.
a. What is the sound intensity of a single snowblower?
b. What is the sound power output of each snowblower?
c. What sound level would Harry measure if two more snowblowers
started up at this same distance?
Three Honda snowblowers are located equal 3.00 m "distances from Harry. Harry measures a sound level Homework #4 Due Tuesday Jan 29 of 104...
7. Sound pressure level measurements were taken in a semi-anechoic chamber at 5 m from the source. A ten point hemispherical array was utilized in this process. The following data was obtained: (1) L,-94 dB, (2) Lp-96 dB, (3) L,-97 dB, (4) L,-93 dB, (5) Lp-92 dB, (6) L,-90 dB, (7) L,-91 dB, (8) L,-95 dB, (9) L,-93 dB, (10) Lp-94 dB From these values a) Determine the sound power level of the noise source b) The maximum directivity index...
For a 400 m-area concrete middle floor office space of a muti-story office building located in Barcelona, Spain; that is operating from 8:00 a.m. till 4:00 p.m. with 100 m west facing glass and 40 occupants. The space has carpeted floor, one exposed wall, interior gypsum partitions, and drop ceiling find the following @ 3:00 p.m.: a). Cooling load due to Glass (conduction, solar, total). b). Cooling load due to Occupants (sensible and latent). c). Cooling load due to Lighting...
I. The drawdown data shown below is from a monitoring well located a distance 25 m from the pumping well in the direction of a surface water reservoir. The data shows that the confined aquifer is in hydraulic communication with the reservoir. If the average pumping rate is 550 m/d, estimate the transmissivity (8 pts) and storage coefficient (7 pts) of the aquifer Time (d) Drawdown (m) Time (d) 0.012 1 0.020 1.6 0.050 0.09 0.12 0.14 Drawdown (m) Time...
QUESTION 2(15 minutes) A well has provided 3.5m3/s of water for a small community for 50 years, but due to water quality issues the well will be relocated. In recent years, several residents have built underground extensions e.g. wine cellars in 1km distance to the well. From historical records, it is known that the groundwater table before the construction of the well was located 2 m below ground. Estimate how long (in days) it would take for the groundwater table...
6. Two identical speakers are emitting sound of the same frequency. Speaker 1, located 5 m away, has a sound level of 76 dB. Speaker 2, located 10 m from you, has a sound level of 73 dB. Assuming spherically radiating sound waves, which of the two speakers is producing the sound at higher power? 7a. Express the fundamental frequency of a piano wire fixed at both ends in terms of its tension FT, length L, radius r, and the...
2. A major home appliances company produces compressors for their refrigerators in one of their plants. The most critical part of a compressor is called crank which is made from cast iron. The surface quality of the crank directly affects the energy consumption and the noise level of the refrigerator Therefore, it has utmost importance in the compressor production. The process of crank manufacturing starts with sand casting process. Casting department is a separate building only dedicated to casting and...