How do I use the surface area of a rectangle to determine the steel mesh size that is needed?
Surface area of rectangle=2(lw+wh+hl)
The surface area so obtained gives length and width and height of mesh to be manufactured so that it suits our requirement.
How do I use the surface area of a rectangle to determine the steel mesh size...
I need the surface area too!
Determine the volume and the surface area of the
three-dimensional figure.
Use the piπ key on your calculator.
Determine the volume and the surface area of the three-dimensional figure. Use the a key on your calculator. 6 cm a) The volume is (Simplify your answer. Type an integer or a decimal rounded to the nearest hundredth as needed.) 3 cm
The measures of volume and surface area depend on the size the unit for measuring. Use each of the following cubic units to find the volume and surface area of each figure. Cubic unit (1) Cubic unit (ii) Part 1 out of 2 a. The volume in terms of unit (i) is The surface area in terms of (i) is The volume in terms of unit (ii) is The surface area in terms of (ii) is 5 attempts left Check...
please DO NOT use mesh analysis for it I need Z11 .. Z22 and
just use the formula , thanks
Problem 2 Determine the z parameters of the circuits below. 202 WWW O 102 AMM 322 49 WW
Using mesh method only
2. For the following circuit, determine the current I (Hint: use mesh-equations method.) ?? 2? (A) 0.2 A (B)-1.5A (C)-0.25 A (D)-0.6A (E)-1.2 A
5. Specific Surface Area: Determine the specific surface area of the following objects: a. A Montmorillonite clay particle: 100nm in diameter, 1nm thick b. A 1" Steel Rod, 6 inches long c. A 5" diameter orange cut into 4 slices
Reinforced concrete
2 For the section in Problem i) determine the area of steel such that the depth of the equivalent rectangular concrete stress distribution (block) is 4", and ii) determine the nominal moment strength and capacity if the steel area is 25% higher than balanced steel condition. Assume d 23.5", f.-3,000 psi, and f 60,000 psi. Hole 5-88 8 16
I'm trying to write a program in C that calculates the area of a rectangle. I need to have a function that gets dimensions from a user and stores them with pointers and addresses and another function that calculates the area... my question is how do i access that values from the dimension function so that I can use it in my calculation and main function.. for example. void userDimensions(float *base, float *height){ scanf("%lf" , base); scanf("%lf", height); } float...
Use Pappus's theorem for surface area and the fact that the surface area of a sphere of radius bis 4mb to find the centroid of the semicircle y The centroid of the semkircle y = 162-x? is (wy).wheex= andy (Type exact answers, using as needed)
2. The area of a rectangle with vertices (±x, ±y) is 4xy. Use
Langrange multipliers to find the maximum area of such a rectangle
with vertices on the ellipse 4x 2 + y 2 = 32
2. The area of a rectangle with vertices (trty) is 4xy. Use Langrange multipliers to find the maximum area of such a rectangle with vertices on the ellipse 412 + y2-32.
2. The area of a rectangle with vertices (trty) is 4xy. Use Langrange...
Use mesh analysis to determine the voltage across current source
(vx).
4. Use mesh analysis to determine the voltage across current source (%). ΙΩ 2Ω 2Ω