Question: The vapor pressure of Hg in a smaple of air is 0.002mmHg at 300K and the density of this air at 300K is 1.18g/L. Calcuate the number of parts per million (PPM) on a mass basis of Hg in the sample of air. - so I found the mol for Hg =0.09mol using PV=nRT and I multiplied this to the molar mass of Hg (200g/mol) and I got 18.05 g and I know that I did this right up to here but I don't know how to find PPM with this.
Question: The vapor pressure of Hg in a smaple of air is 0.002mmHg at 300K and...
Barometric Pressure 0.992 atm Mass of Flask + Foil 56 g Mass of Flask + Foil + Condensed Liquid 59 g Mass of Condensed Liquid 3 g Volume of Flask 300 ml Temperature of Water Bath when Vaporization Begins 333 K Temperature of Water Bath when Water Begins to Boil 363 K Molar Mass 46 g mol Ideal gas law PV=nRT P=pressure V=volume of gas n=number of moles R=gas constant T=temperature Molar volume V=RT/P Density of gas D=PM x RT Molar mass M=(mRT)/(PV) I...
Be sure to answer all parts. Calculate the vapor pressure of a solution made by dissolving 87.8 g of urea (molar mass = 60.06 g/mol) in 224.5 mL of water at 35°C. (Hint: The vapor pressure of pure water at 35°C is given in the table below. Assume the density of the solution is 1.00 g/mL.) I nHg What is the magnitude of vapor-pressure lowering? D nHg
A combined gas turbine-vapor power plant has a net power output of 100 MW. Air enters the compressor of the gas turbine at 100kPa, 300K, and is compressed to 1200kPa. The isentropic efficiency of the compressor is 84%. The conditions at the inlet to the turbine are 1200kPa and 1400 K. Air expands through the turbine, which has an isentropic efficiency of 88%, to a pressure of 100kPa. The air then passes through the interconnecting heat exchanger, and is finally...
(6 pts.) 1. The air pressure in the inner tube of a tire on a typical racing bike is held at a pressure of 115 psi (pounds! per square inch). Convert this pressure to atm and mm Hg. (3 pts. each) The atmospheric pressure is 0.978 atm. Determine the pressure of the enclosed gas in each of the cases depicted below. Gas Gas (6 pts.) 3. A 5.90 L bottle contains 1070 g of oxygen at 25.0°C. Calculate the pressure...
Need help filling in my data sheet from a lab. My professor said
the pressure was 24.6 inches of Hg and that we needed to convert
that to moles. Im not sure i put that in the correct spot. I
included the lab protocol. Plz plz plz help me fill in the blanks
and let me know if i did something wrong Im very confused haha.
THANKS!!
Equivalent Mass by Electrolysis If the two terminals on any source of DC...
With the data given, help on the calculations please
- Tes Name Determination of the Gas Constant, R, and the Purity of KCIO, Data Unknown number or letter Mass of test tube and iron (IIT) oxide 44.5928 Mass of test tube, iron (III) oxide and sample 44.979 8 Mass of test tube and contents after heating 44.8488 Volume of water displaced Barometric pressure 976 mbar Temperature of water temperature of O, 23 Vapor pressure of water at this temperature 21.068_mm...
Mass of Magnesium strip Use the length of your magnesium strip and the mass per m provided by your TA to calculate the mass of your magnesium strip. Make sure to convert so that your units match! Mass of magnesium strip Moles of magnesium used Convert the mass of each magnesium strip into moles using the molar mass. Moles of magnesium Moles of hydrogen produced (n) Use the mole ratio from the balanced chemical equation to convert the moles magnesium...
Please answer all the blanks (volume if H2 and
everything in analysis). TIA!
Data 5 1 oong 0.00 10.5ml 2 o.olag 0.00 11.0 Trial 3 o.org 0.00 12.00 o Daag o.albg 0.00 10.0 ml 11.5ml Mass of Mg (g) Initial volume of Syringe (mL) Final volume of Syringe (mL) Volume of H (mL) Barometric pressure (torr) Ambient temperature (°C) Vapor pressure of H2O (torr) 779.314har 23. Oi 21.0 forr TA.314tar 23.0c 179.3 14ton 23.0¢ 779.314 ton 23.0c 779.31472 23.0c 21.0...
I need help on how to find the atmospheric pressure from the
scatter plot and trend line I made with the results from my Boyle's
Law lab. I don't know if my scatter plot is correct. I need the
atmospheric pressure in order to fill in Table 5 and answer some
questions.
24. Use the data in Data Table 1 and Data Table 3 to create a
scatter-plot graph of 1/Average Volume vs. Pressure; with
“1/Average Volume (mL-1)” on the...