



A coil is supplied from an AC source.... all the previous answers doesn’t show or state...
inductance = .1 H
Line = 20 Ohm
3. (30 points total) The load from a plant is equivalent to a resistor in series with an inductor as shown. The plant is supplied by a source through a long line which has a resistance of 20 ohms as shown in the circuit below. You decide to place a capacitor in parallel with the load so that the reactive power by the source is reduced to zero. (a) What capacitance value...
I need all the answers please. Thanks
If a 15-V battery delivers 72.000 J in 6 s, find (a) the amount of charge delivered and (b) the current produced. (a)TT4.8 (b)To.8 ori We were unable to transcribe this imageChapter 1, Problem 1.11 The charge entering the positive terminal of an element is given by the expression qt)20e5.00t mC. The power delivered to the element is p(t)-9.2e8t w. Compute the current in the element as a function of time, the voltage...
In the figure below a thin coil of radius r1= 4 cm, containing
N1= 5300 turns, is connected through a resistor R = 100 Ω to an AC
power supply running at a frequency f= 2100 so that the current
through the resistor (and coil) is I1sin(2π×2100t). The voltage
across the resistor triggers an oscilloscope that also displays
this voltage, which is 10 V peak-to-peak and therefore has an
amplitude of 5 V (and therefore the amplitude of the current...
A single-phase full bridge thyristor rectifier is supplied from a 200vrm 50HZ AC source, and supplies a series R-L load comprising a 202 resistance and a 36.8mH inductance 2.a. Sketch the circuit diagram for this rectifier Q2. [4 marks] [Refer to lecture notes] 2.b. Determine the maximum possible average DC voltage that can be achieved across the load resistor [4 marks] [VDC (avg) = 180V] 2.c. Determine the SCR firing angle at which the rectified output curent will just be...
I would like some help with this question and please be
clearer also show all the steps if you do I will read you a good
rate and a good feedback thank you. i need part 4,5 ,6,7 only
please fast i need it.
[C] An RLC circuit has L- 400mH, R- 20O2, C-250HF (1)Calculate the resonance frequency for this circuit. (2) For a frequency o-400 rad/s, draw the phasor diagram with the current along the real axis, determine the...
From the Given Circuit Bellow, Find:
a. line voltage
b. line current
c. total complex power, average power, and reactive power at the
source
(bottom part of the circuit looks fuzzy it has a clear view at
pic3, they are the same circuit)
3. From the Given Circuit Bellow, Find: a. Line Voltage b. Line Current c. Total Complex power, Average power and Reactive Power at the Source d. Total Complex power, Average power and Reactive Power at the Load...
Answer:
Please help! Electrical series circuits never make
sence to me. I included the answer so that you can check your
work.
Hope that helps.
19. An electrical series circuit contains a resistor with a resistance of R- 20 ohms, a capacitor with a capacitance of C 0.01 farads, and an inductor with an inductance of L 1 henry. The initial current in the circuit is 0 amperes. A variable voltage of E(t) 120 sin volts of is applied to...
The near-simultaneous, yet independent works of Faraday and
Henry have shown, in 1831 and 1832, respectively, that a change in
magnetic flux through a spiral coil results in an induced
electromotive force. Examine the qualitative and quantitative
aspects of induction, as predicted by those two
physicists.
A magnetic field produced by a solenoid is proportional to
current; therefore, we can infer that for two stationary coaxial
solenoids, the flux through the secondary is proportional to the
current passing through the...
find all the DC collector currents of the 741 circuit. answers are
shown in the table. just need to show the work for them all. please
answer this question in full detail, showing all work neatly.
4. First self-study Sections 13.3.1 and 13.3.2 (pp. 1028- Table 13.1 DC Collector Currents of the 741 Circuit (uA) pp.1038), including Exercises and Examples. Then, find all 9.5 DC collector currents of the 741 circuit yourself, although 9.5 the answer is listed in Table...
b) How does the magnitude of the induced current depend on the strength of the bar magnet? PHY290 c) If the secondary solenoid is in a circuit with resistance R, there will be an induced current, 12 = Discuss how the equations predict the direction of the current in the secondary coil depending on whether the current in the primary coil, 71, is increasing or decreasing. Is it increasing or d) Does this match your decreasing?) s this match your...