answer only if you know otherwise leave for others
Homework Answers
Turbojet :
Components- Intake section, Compressor, Combustion chamber, Turbine and Exhaust nozzle.
Compression device - Combustion chamber
Propulsion device - Exhaust nozzle i.e. gas turbine with propelling nozzle
Fuel used - Jet A-1 (JP A-1) Or naphtha kerosene (Jet B)
Ramjet :
Components - Diffuser, Combustion chamber and Exhaust nozzle.
Compression device - No addtional device like compressor, isentropic compression takes place at the inlet diffuser.
Propulsion device - Exhaust nozzle
Fuel used - Solid fuel
C)
Rocket :
Components - structural system, payload system, guidance system and propulsion system.
Compression device - Not used
Propulsion device - Exhaust nozzle
Fuel used - Highly refined kerosene (RP-1)
Add Answer to:
answer only if you know otherwise leave for others
Fill the table. propulsion rel rused Compressive...
answer onlt if you know perfect otherwise leave for others derei derive elvation of maximum COP...
answer onlt if you know perfect otherwise leave for
others
derei derive elvation of maximum COP from the eluation of cop, & I To (THPTC) k - I²R e LI (THTc) + I²R and derive it for the mal conductivity to electrical resistance to
and fill the table CONSTRUCTION ENGINEERING please if you don't know the answer leave it for...
and fill the table
CONSTRUCTION ENGINEERING
please if you don't know the answer leave it for who knows since
its very important do not copy anther sulution
Question 1. 35 Points Determine mass ordinate data for the given information in the table below. Assume shrinkage factor as 0.85 Station EndEnd Volume Volume StrippingStripping TotalTotal Adj Algebraic Mass cut (byc) il Area Area of Cut Cut Fill (bcy) (ccy) (sf) (sf) Col 2 Col 3 Col 4 105 0 79 of...
Pls only answer if you are 100% sure about the answer for both question, otherwise i...
Pls only answer if you are 100% sure about the answer for both
question, otherwise i will rate the answer negatively.
5. a steel bar of 40 mm x 40 mm square cross section is subjected with an axial compressive load of 200 kn, if the length of bar is 2 m and e 200 gpa, the elongation of the bar will be in mm O 1.25 O 2.7 0 4.05 O 5.4
Please do not answer if you are going to copy the answers of others. Only do...
Please do not answer if you are going to copy the answers of
others. Only do it if you know how. The others are wrong.
8. Consider the circuit shown in Figure A Q-point value for Ic between a minimum of 4 mA and a maximum of 5 mA is required. Assume that resistor values are constant and that ranges from 100 to 300. It is We were unable to transcribe this image
Please answer only if your answer is fully sure, otherwise please don’t answer the question leave...
Please answer only if your answer is fully sure, otherwise
please don’t answer the question leave it for a capable
personal.
PLEASE!! Don't copy incorrect answers from
online.
3. Consider rolling (independently) one fair six-sided die and one loaded six-sided die. Let Xi and X2 denote, respectively, the number of spots from one roll of the fair die and one roll of the loaded die. Suppose the distribution for the loaded die is 16 Pr(X,-5) = Pr(X2 = 6) =...
Please Only attempt to solve, if you know the Answer., Otherwise I will down vote and report Plea...
Please Only attempt to solve, if you know the Answer., Otherwise I will down vote and report Please write clearly. (10 points) If a constant number h of fish are harvested from a fishery per unit time, then a model for the population P(t) of the fishery at time t is given by = P (a-bP) _ h, P(0) = Po, where a, b, h and Po are positive constants. Since the DE is autonomous, use the phase portrait concept...
fill in the blanks Type your answer in the box. A buffer solution undergoes only slight...
fill in the blanks
Type your answer in the box. A buffer solution undergoes only slight changes in PH strong base is added. It contains similar amounts of a when either strong acid or acid and its conjugate Do you know the answer? No idea I know it
Please fill in table below and answer question 2+3. Thank you very much and I hope you have a gre...
Please fill in table below and answer question 2+3.
Thank you very much and I hope you have a great day!
1. A circuit that contains one battery, two switches (labeled S, and S2) and two lamps (labeled Li and L2) is to be designed so that it does the following: 1) If only S is closed, nothing will happen. 2) If only S2 is closed, only L2 will light. 3) If both switches are closed, both lamps will light....
Please answer all please only If you know it. Directionsi Write out your legible answers in...
Please answer all please only
If you know it.
Directionsi Write out your legible answers in the space provided. 1. If a wright is hung from a string which has a teusion of 100 N, whuat i the mass of the weight 2. A rocket moving with a constant accleration that has a mass of 45 kg and an initial velocity of Om/s traveled 300 m in 10 . What is the force of the rocket? Chate the anavity of...
please answer 1b only with clear steps please I need you to answer only the sub...
please answer 1b only with clear steps
please I need you to answer only the sub question (b)
for me.
l(a) Consider the Linear Programming (LP) problem below, Max Z = 5x + 4y s.t 6x + 4y = 24 6x + 3y < 22.5 x + y = 5 x + 2y 56 -x+ys1 y <2. x, y 2 0. Solve the problem. AN[10] (b) Out of a stock of three engineering components A,B and C given as 200,...
answer onlt if you know perfect otherwise leave for
others
derei derive elvation of maximum COP from the eluation of cop, & I To (THPTC) k - I²R e LI (THTc) + I²R and derive it for the mal conductivity to electrical resistance to
and fill the table
CONSTRUCTION ENGINEERING
please if you don't know the answer leave it for who knows since
its very important do not copy anther sulution
Question 1. 35 Points Determine mass ordinate data for the given information in the table below. Assume shrinkage factor as 0.85 Station EndEnd Volume Volume StrippingStripping TotalTotal Adj Algebraic Mass cut (byc) il Area Area of Cut Cut Fill (bcy) (ccy) (sf) (sf) Col 2 Col 3 Col 4 105 0 79 of...
Pls only answer if you are 100% sure about the answer for both
question, otherwise i will rate the answer negatively.
5. a steel bar of 40 mm x 40 mm square cross section is subjected with an axial compressive load of 200 kn, if the length of bar is 2 m and e 200 gpa, the elongation of the bar will be in mm O 1.25 O 2.7 0 4.05 O 5.4
Please do not answer if you are going to copy the answers of
others. Only do it if you know how. The others are wrong.
8. Consider the circuit shown in Figure A Q-point value for Ic between a minimum of 4 mA and a maximum of 5 mA is required. Assume that resistor values are constant and that ranges from 100 to 300. It is We were unable to transcribe this image
Please answer only if your answer is fully sure, otherwise
please don’t answer the question leave it for a capable
personal.
PLEASE!! Don't copy incorrect answers from
online.
3. Consider rolling (independently) one fair six-sided die and one loaded six-sided die. Let Xi and X2 denote, respectively, the number of spots from one roll of the fair die and one roll of the loaded die. Suppose the distribution for the loaded die is 16 Pr(X,-5) = Pr(X2 = 6) =...
Please Only attempt to solve, if you know the Answer., Otherwise I will down vote and report Please write clearly. (10 points) If a constant number h of fish are harvested from a fishery per unit time, then a model for the population P(t) of the fishery at time t is given by = P (a-bP) _ h, P(0) = Po, where a, b, h and Po are positive constants. Since the DE is autonomous, use the phase portrait concept...
fill in the blanks
Type your answer in the box. A buffer solution undergoes only slight changes in PH strong base is added. It contains similar amounts of a when either strong acid or acid and its conjugate Do you know the answer? No idea I know it
Please fill in table below and answer question 2+3.
Thank you very much and I hope you have a great day!
1. A circuit that contains one battery, two switches (labeled S, and S2) and two lamps (labeled Li and L2) is to be designed so that it does the following: 1) If only S is closed, nothing will happen. 2) If only S2 is closed, only L2 will light. 3) If both switches are closed, both lamps will light....
Please answer all please only
If you know it.
Directionsi Write out your legible answers in the space provided. 1. If a wright is hung from a string which has a teusion of 100 N, whuat i the mass of the weight 2. A rocket moving with a constant accleration that has a mass of 45 kg and an initial velocity of Om/s traveled 300 m in 10 . What is the force of the rocket? Chate the anavity of...
please answer 1b only with clear steps
please I need you to answer only the sub question (b)
for me.
l(a) Consider the Linear Programming (LP) problem below, Max Z = 5x + 4y s.t 6x + 4y = 24 6x + 3y < 22.5 x + y = 5 x + 2y 56 -x+ys1 y <2. x, y 2 0. Solve the problem. AN[10] (b) Out of a stock of three engineering components A,B and C given as 200,...
Most questions answered within 3 hours.
-
Where is the error in this code sequence?
String s1 = "Hello";
String s2 = "ello";...
asked 10 months ago -
Financial data for Joel de Paris, Inc., for last year
follow:
Joel de Paris, Inc.
Balance...
asked 10 months ago -
Consider this reaction:
Al2(SO4)3 (aq)+ BaCl3
(aq) Al2Cl6 (aq)- +
3BaSO4(s) . What is the...
asked 10 months ago -
Suppose that Savneet is considering increasing her
recent random sample from 20 car rentals to 40...
asked 10 months ago -
Trucks arrive at an unloading terminal at an average rate of 120
per hour.
Trucks arrive...
asked 10 months ago -
Why are methanol and ethanol completely soluble in water while
octanol is not very little soluble....
asked 10 months ago -
A facilities manager at a university reads in a research report
that the mean amount of...
asked 10 months ago -
When the CuSO4 is rehydrated by adding water to the anhydrous
compound, is this an endothermic...
asked 10 months ago -
A ray of sunlight is passing from diamond into crown glass; the
angle of incidence is...
asked 10 months ago -
A block of mass 0.249 kg is placed on top of a light, vertical
spring of...
asked 10 months ago -
how do the kidneys compensate in the presences of acidosis
a) trigger hyperventilate
b) reserve acid...
asked 10 months ago -
Question 501 pts
The rental rate of capital to the firm increases. Which of the
following...
asked 10 months ago