HomeworkLib
Question

do the part on red please.

1. Validate conclusions regarding the behavior of inductors in transient and steady-state DC network. 2. Verify basic equatioR1 PR2 v 408.16mV 4700 R2 20.408mA V1 10V 두 1 10m 0 Part 2. Parallel RL Circuits Use the circuit of Figure 5 (pick RL=2012- aFigure 4 R2 1K RL 18 to 24 10 V V1 R1 1k L1 10m VL 12 Figure 5 Analysis 1. When the circuit of Figure 4 has reached steady stb. Run the simulation c. Close the switch and mentally start counting in seconds (one-potato, two- potato, three-potato etc..

engineering   Electrical-Engineering   
0 0
Add a comment Improve this question Transcribed image text
Next > < Previous
Sort answers by oldest

Homework Answers

Answer #1

ܠܢ a : R=200 IOV 2,- 10mH Ri 0 Solutions : This is Series RL circuit in which 4708 current i is geren be- i= V (1-78**) A R.2 . 994. Capsfocose full Change) BL - 2 ng 5 = 그 3. It takes 5 fione constant to charge indeector Hore time constant 10x103=L(o-xxx-B) Bit Vė Rit) all V = Lidi (v dt de R R e & = xxy ek t at, $20, v=vell -Rexo Vari Y = lov a v so, at t=0, 12 4 . AH& = 020 Ime Tox jo3 A I2 = 8 ci e se py lo 1020 Ho20001 I= 9.8X003 (1- In = 9.8(1-ěl02000€)ma > at tro ( Steady State) In = 9

0 0
Add a comment
Know the answer?
Add Answer to:
do the part on red please. 1. Validate conclusions regarding the behavior of inductors in transient...
Your Answer:

Post as a guest

Your Name:

What's your source?

Earn Coins

Coins can be redeemed for fabulous gifts.

Log In

Sign Up

Not the answer you're looking for? Ask your own homework help question. Our experts will answer your question WITHIN MINUTES for Free.
Similar Homework Help Questions

  • 60 Lab Quiz circuit shown below, answer the following questions. (Show your calculations) R1 V1 L...

    60 Lab Quiz circuit shown below, answer the following questions. (Show your calculations) R1 V1 L1 R2 Figare 3 lab Quir RL. Cirewir 1. Write the storage phase equations for V1,V2·Yu and IL and calculate each at time 4m NOTE: Use R-1k2 when calculating the time constant.) 2. Calculate Vi, V2. VL. Is, 12, and Iu at steady-state (after the storage phase has passed.) 3. Calculate the voltage across the inductor (VL) just after the switch is opened (just beginning...

  • Consider the circuit in figure 4. a) find the thevenin equivalent of the network connected to...

    Consider the circuit in figure 4. a) find the thevenin equivalent of the network connected to the inductor L1. b) find the mathmatical equations for the transient behavior of the current. iL(t) and the voltage vL(t) following the closing of the switch. c) determine the value of current iL at t= 20?s. Question 5 (10 points) (Obj. 4) Consider the circuit in Figure 4. a) Find the Thevenin equivalent of the network connected to the inductor L1.(4 points) mathematical equations...

  • (1) [21 pts] The RL circuit shown in Figures 1 and 2 has a switch. You...

    (1) [21 pts] The RL circuit shown in Figures 1 and 2 has a switch. You are given I1 =10 mA, R1=R2=1 ks2, and L=10 mH. (a) [3 pts] Using Figure 1, with an open switch, calculate the steady state current through the inductor. (b) [12 pts) Using Figure 2, with a closed switch, derive the differential equation as an expression of the inductor current. (c) [2 pts] Using your answer to Part (b), calculate the time constant. (d) [4...

  • Anything would be help please help me OBJECTIVES Study the behavior of capacitors while charging Learn how changing the...

    Anything would be help please help me OBJECTIVES Study the behavior of capacitors while charging Learn how changing the values of R or C in a series RC circuit affects the charging time Learn the behavior of capacitor and inductor in a DC circuit 1. 2. 3. EQUIPMENT Breadboard, Multimeter, DC power supply, Oscilloscope, Resistor, Capacitor (values will be provided in lab) Connect the given circuit and notice how the capacitor charges Measure the voltage across the resistor, and across...

  • (3) The RL circuit shown in Figure 3 has a switch that is closed att 0....

    (3) The RL circuit shown in Figure 3 has a switch that is closed att 0. Assume that the circuit has reached steady state prior to the switch closing. You are given R1 1 kQ, R2-10 kQ, R3-R4-100 k2, L 10 mH, Vs-5 V. (a) [15 pts] Calculate the steady-state inductor current before the switch is closed (b) [16 pts] Give the differential equation as an expression of the inductor current fort>0 (i.e. write the differential equation) (c) 13 pts]...

  • MENG 207-ELECTRICITY Department of Engineering & Design at Eastern Washington University Lab 6 PRE LAB 1. Print out lab handout and bring to lalb 2. Do calculations for part 1 in RC CIRCUIT s...

    MENG 207-ELECTRICITY Department of Engineering & Design at Eastern Washington University Lab 6 PRE LAB 1. Print out lab handout and bring to lalb 2. Do calculations for part 1 in RC CIRCUIT section. 3. Do calculations for part 1 in RL CIRCUIT section. 4. Do calculations for part 1 in RLC CIRCUIT section OBECTVE:response Use Multisim to study the transient response of an RC and RL circuit, and the frequency response of an RLC circuit. PROCEDURES 1. Record every...

  • Learning Goal EVALUATE your answer To practice Problem-Solving Strategy 30.1: Inductors in Circuits A circuit has...

    Learning Goal EVALUATE your answer To practice Problem-Solving Strategy 30.1: Inductors in Circuits A circuit has a 3.2 V battery connected in series with a switch. When the switch is closed, the battery powers two paths in parallel, one of which has a resistor of resistance R1 = 100 ? in series with an inductor of inductance L Part D In the previous part, you found the current supplied by the battery 0.3 ms after the switch is closed. What...

  • The class E inverter as shown in Figure 7-1 operates at resonance and has Vs-48 V and R-10 Ω The ...

    The class E inverter as shown in Figure 7-1 operates at resonance and has Vs-48 V and R-10 Ω The switching frequency is fs- 20 kHz. Assume a quality factor Q-7. (a) Calculate the parameters and complete Table 7-1. Assume an ideal transistor switch the optimum values on inductor / the optimum value of capacitor C the optimum values on inductor Le the optimum value of capacitor Ce the damping factor δ the peak output voltage Vo for Vi= 12...

  • Determine il(t) for in the circuit of Fig. P12.21 for t=16 ms, given that the switch...

    Determine il(t) for in the circuit of Fig. P12.21 for t=16 ms, given that the switch was opened at t= 0 after it had been closed for a long time, vs = 12 mV, RO = 50, R1 = 10 A, R2 = 20 . L = 0.2 H, and C = 6 mF. Give the current in micro Amperes, Hint, the initial conditions are zero and the steady state current in the inductor will be 800 microAmps. Correct Answer:...

  • A circuit is constructed with four resistors, one inductor, one battery and a switch as shown. The values for the resistors are: R1 = R2 = 48 Ω, R3 = 100 Ω and R4 = 130 Ω.

     A circuit is constructed with four resistors, one inductor, one battery and a switch as shown. The values for the resistors are: R1 = R2 = 48 Ω, R3 = 100 Ω and R4 = 130 Ω. The inductance is L = 330 mH and the battery voltage is V = 12 V. The positive terminal of the battery is indicated with a + sign.1)The switch has been open for a long time when at time t = 0, the...

ADVERTISEMENT
Free Homework Help App
Download From Google Play
Scan Your Homework
to Get Instant Free Answers
Need Online Homework Help?
Ask a Question
Get Answers For Free
Most questions answered within 3 hours.
ADVERTISEMENT
ADVERTISEMENT