The solution of above question is given below...


A DC shunt motor accelerates at very high speed, what would be the problem and a...
Problem 3: DC machine A shunt DC motor rated at V,'. 300 V, with field resistance of Rf 600 0, armature 0.2 , resistance of R, 30.5 A (total current) when rated-load at n, consumes 916.8 rpm. Armature rotational loss (consisting of fan, friction and core loss (consisting of field resistance, armature a) Find Prot (rotational load), Pshaft and efficiency at rated load. - Assume that the rotational loss is constant and P,aft is now 50% in the case of...
Which type rotor of three-phase squirrel-cage motor has low starting torque, high starting current and good running torque? Туре В-Е Type F-V 8. Туре А All above А. В. С. D. Which type of motor is known as a constant speed motor? Series DC Long compound 9. В. Shunt DC А. Short Compound D. С. 10 To what a countertorque is proportional? А. Hysteresis Armature Current Eddy current Shunt Field В. D. For DC machine, what type of field winding...
T u resistance in a DC is decreased while the motor is driving a ii. A 100-hp, 250-V DC shunt motor with compensating winding has an am 0.04 12 and a variable shunt field resistance R; 92. The magn ompensating winding has an armature resistance of shunt field resistance R, 12. The magnetization curve of this motor is shown in Fig. 1. At no load, the field resistor has been a . At no load, the field resistor has been...
A 8250 w shunt DC motor has a terminal voltage of 300 V. A field resistance Rf of 40 Ω, and an armature resistance Ra of 250 mm2. The field winding has 1500 turns. An adjustable resistance Rad is connected in series to the field winding. Rad is set at 20 Ω, but it can vary from 0 to 80 Ω. The magnetization curve is shown in Figure.1 and it is taken at a speed of 1200 rpm. (Armature reaction...
Prelab . Describe what the magnetizing curve of a DC motor that uses windings on the stator to generate magnetic field in the motor is. What is the equivalent circuit of a DC motor that uses windings on the stator to generate magnetic field in the motor? Show the equivalent circuits of both stator and rotor. What are the formulas for the torque and the induced voltage? If the voltage of the external supplies for the stator winding and the...
A 250-V shunt-connected DC motor runs at 1500 rpm when it is not connected to any external load. When the motor is connected to an external load, it draws a line current of 40A. The motor has an armature resistance of 1 ? and a field circuit resistance of 100 ?. Assume that the rotational loss torque is 2 Nm and is independent of the speed (a) Find the line current of the motor when there is no external load....
ing the arhature voltage (with the shunt field voltage held constant) offer a good method of speed control? □Yes □No REVIEW QUESTIONS 1. Explain how to locate the neutral brush position in a DC motor. Would the motor turn if only the armature were excited (had voltage applied across it)? 2. □ Yes □ No 3. Why is it dangerous to supply power to an unloaded series connected DC motor? 4. In what two ways may the rotation of a...
In a shunt-wound dc motor with the field coils and rotor
connected in parallel (see the figure (Figure 1)), the resistance
Rf of the field coils is Rf = 103 Ω and the resistance Rr of the
rotor is Rr = 5.5 Ω. When a potential difference of V = 120 V is
applied to the brushes and the motor is running at full speed
delivering mechanical power, the current supplied to it is 4.90
A.
Part A.) What is...
Question (3) Speed Control [10 Marks A 50 hp, 220 V, 1500 rpm DC shunt motor with an armature resistance of 0.04 Q and a field resistance of 50 Q. The motor has compensating windings, so armature reactance can be ignored. Mechanical and core losses may be ignored also. The moter is driving a load toque that is proportional with speed, Ti a (n). The motor is driving a load with a line current of 80 A and an initial...
Open Book Exam A 220 V, 1000 V dc-sourc rpm, separately dc motor is fed from a dc-dc converter through 550 e with duty cycle 40 %. The motor speed is 1000 rpm when takes ripple free and armature resistance is 1 Ω. The motor constant is 6/π V/A-rad/s. The field circuit with 198 Ω is fed from a controlled single-phase rectifier and set to the maximum possible value. The ac source for field circuit is 220 V, 50 Hz....