Suppose a lab scale consistently measures 2 g too high. How would that effect measurement of...
Suppose a lab scale consistently measures 2 g too
high. How would that effect measurement of specific heat?
Too high, too low, or not at all?
Homework Answers
You have not specified the other details regarding the experiment so the statement is pretty much unclear. I am still giving an answer based on the concept behind similar questins such as this.
Since the lab scale is giving the high measurement consistently, this means every time it is giving this high reading.
So overall there is no effect on specific heat because an error would have been caused if the scale gave a high reading just once and not consistently.
Hope this helps! Revert back if you have any queries!
Add Answer to:
Suppose a lab scale consistently measures 2 g too
high. How would that effect measurement of...
Calorimeter: Post Lab Would the calculated specific heat of the metal be too high or too...
Calorimeter: Post Lab Would the calculated specific heat of the metal be too high or too low if the metal cylinder is not quickly placed into the calorimeter? Explain.
Would the calculated equilibrium constant be too high or too low if some solid calcium hydroxide...
Would the calculated equilibrium constant be too high or too low if some solid calcium hydroxide leaked through the filter paper? Too high Too low No effect In titrating the Ca(OH)2 filtrate. A student consistently went past the end point by about 2.0 mL every time. Will the measured Ksp be too big or too small? Too big because the moles of OH– are overestimated. Too big because the moles of OH– are underestimated. Too small because the moles of...
Suppose the thermometer you used in your Charles's law experiment consistently gave low temperature readings. How...
Suppose the thermometer you used in your Charles's law experiment consistently gave low temperature readings. How would that influence the value of k' you would obtain? a. Make it too high. b. Make it too low. c. Would not influence it.
Question 1 O out of 5 points Would the calculated equilibrium constant be too high or...
Question 1 O out of 5 points Would the calculated equilibrium constant be too high or too low if some solid calcium hydroxide leaked through the filter paper? Selected Answer: Answers: Too low Too high Too low No effect Question 2 O out of 5 points In titrating the Ca(OH)2 filtrate. A student consistently went past the end point by about 2.0 ml every time. Will the measured Ksp be too big or too small? Too big because the moles...
Explain how each of the following would affect the percent sulfate you calculated, i.e., too low,...
Explain how each of the following would affect the percent sulfate you calculated, i.e., too low, too high, no effect. Be specific. 3. You added 15 mL (instead of 10 mL) of 0.25 M BaCI, to your unknown. a. You were in a hurry to get out of lab, so you did not rinse the last traces of solid BaSO, from the reaction beaker into the funnel. b.
EXPERIMENT 2 Each person in the lab group should read each measurement and record it in this tabl...
i
need help on questions 1-5
EXPERIMENT 2 Each person in the lab group should read each measurement and record it in this table to reduce errors t 1 Lab Partner 1 57.7 27.4 24.2 9 242 Partner 121. 100.59 Lab 23.9 1116 2 5 7 Lab Partner 3 57 Average Metal hot lost final T. gained Cup+ Stirrer Ti cold Water % Error QUESTIONS What would be the effect on your calculation of co if there was heat lost...
Indicate how each of the following would affect the value of the absorbance (too high, too low, or not effect) of the indicated solution
Indicate how each of the following would affect the value of the absorbance (too high, too low, or not effect) of the indicated solution. I really need help. I do not understand these questions! This is from a chemistry activity to determine the unknown concentration of an Erythrosin B solution by using a spectrophotometer. a. A student prepares solution A as instructed and pours it into a wet beaker. b. A student rinses the 10.00 mL pipet only with DI...
E AFTER COMPLETING LAB. ANSWER IN SPACE PROVIDED. Suppose the heat of neutralization had been determined using a glass beaker instead of a polystyrene coffee cup How would the measured value have...
E AFTER COMPLETING LAB. ANSWER IN SPACE PROVIDED. Suppose the heat of neutralization had been determined using a glass beaker instead of a polystyrene coffee cup How would the measured value have been affected? The heat of combustion of octane, C,H,. can be measured in a way similar to the method youC used to measure the heat of neutralization. The bomb calorimeter is used instead of a coffee cup. The reaction is 2C,H,1)+ 25 O, (g) 16 CO, (g) +...
Explain what effect the following scenarios would have on the calculated specific heat (i.e. would it...
Explain what effect the following scenarios would have on the calculated specific heat (i.e. would it be calculated artificially high, low, or have no effect). Your explanation should address what variable(s) would be affected by the scenario and how that affects the calculation of specific heat.(1.5pt each) A student accidently dropped the piece of metal on the countertop during the process of transferring it from the boiling water bath to the calorimeter, but was quickly picked up and put into...
QUESTIONS Why do the crucible and lid need to be cooled before weighing? Be specific. 1....
QUESTIONS Why do the crucible and lid need to be cooled before weighing? Be specific. 1. Assume that you failed to clean some grease off of your crucible before doing the percent water determination. If that grease then burned off during the determi- nation, explain how the percent water you calculated would be affected (i.e., to0 low, too high, no effect). Be specific. 2. Explain how each of the following would affect the percent sulfate you calculated, i.e, too low,...
Question 1 O out of 5 points Would the calculated equilibrium constant be too high or too low if some solid calcium hydroxide leaked through the filter paper? Selected Answer: Answers: Too low Too high Too low No effect Question 2 O out of 5 points In titrating the Ca(OH)2 filtrate. A student consistently went past the end point by about 2.0 ml every time. Will the measured Ksp be too big or too small? Too big because the moles...
Explain how each of the following would affect the percent sulfate you calculated, i.e., too low, too high, no effect. Be specific. 3. You added 15 mL (instead of 10 mL) of 0.25 M BaCI, to your unknown. a. You were in a hurry to get out of lab, so you did not rinse the last traces of solid BaSO, from the reaction beaker into the funnel. b.
i
need help on questions 1-5
EXPERIMENT 2 Each person in the lab group should read each measurement and record it in this table to reduce errors t 1 Lab Partner 1 57.7 27.4 24.2 9 242 Partner 121. 100.59 Lab 23.9 1116 2 5 7 Lab Partner 3 57 Average Metal hot lost final T. gained Cup+ Stirrer Ti cold Water % Error QUESTIONS What would be the effect on your calculation of co if there was heat lost...
E AFTER COMPLETING LAB. ANSWER IN SPACE PROVIDED. Suppose the heat of neutralization had been determined using a glass beaker instead of a polystyrene coffee cup How would the measured value have been affected? The heat of combustion of octane, C,H,. can be measured in a way similar to the method youC used to measure the heat of neutralization. The bomb calorimeter is used instead of a coffee cup. The reaction is 2C,H,1)+ 25 O, (g) 16 CO, (g) +...
QUESTIONS Why do the crucible and lid need to be cooled before weighing? Be specific. 1. Assume that you failed to clean some grease off of your crucible before doing the percent water determination. If that grease then burned off during the determi- nation, explain how the percent water you calculated would be affected (i.e., to0 low, too high, no effect). Be specific. 2. Explain how each of the following would affect the percent sulfate you calculated, i.e, too low,...
Most questions answered within 3 hours.
-
Where is the error in this code sequence?
String s1 = "Hello";
String s2 = "ello";...
asked 10 months ago -
Financial data for Joel de Paris, Inc., for last year
follow:
Joel de Paris, Inc.
Balance...
asked 10 months ago -
Consider this reaction:
Al2(SO4)3 (aq)+ BaCl3
(aq) Al2Cl6 (aq)- +
3BaSO4(s) . What is the...
asked 10 months ago -
Suppose that Savneet is considering increasing her
recent random sample from 20 car rentals to 40...
asked 10 months ago -
Trucks arrive at an unloading terminal at an average rate of 120
per hour.
Trucks arrive...
asked 10 months ago -
Why are methanol and ethanol completely soluble in water while
octanol is not very little soluble....
asked 10 months ago -
A facilities manager at a university reads in a research report
that the mean amount of...
asked 10 months ago -
When the CuSO4 is rehydrated by adding water to the anhydrous
compound, is this an endothermic...
asked 10 months ago -
A ray of sunlight is passing from diamond into crown glass; the
angle of incidence is...
asked 10 months ago -
A block of mass 0.249 kg is placed on top of a light, vertical
spring of...
asked 10 months ago -
how do the kidneys compensate in the presences of acidosis
a) trigger hyperventilate
b) reserve acid...
asked 10 months ago -
Question 501 pts
The rental rate of capital to the firm increases. Which of the
following...
asked 10 months ago