Question 1 (i). A car travels between city A and city B, a distance of 45miles at an average speed of 50 mph. on the return journey the average speed is 40 mph. Calculate the average speed for the total journey of city A to city B to city A.
(b). A chemical power plant is rectangular and has a length of 100 m and a width of 60,000mm. A safety zone of uniform width surrounds the plant. (i). If the area of the safety zone equals the area of the plant, calculate the width of the safety zone
We need at least 10 more requests to produce the answer.
0 / 10 have requested this problem solution
The more requests, the faster the answer.
A car making a trip travels first 10 minutes at 60 mph and the last 20 miles at 40 mph. Whats the car average speed for the entire trip? A. 45 mph B. 50 mph C. Cannot be determined because distance wasn't given D. 59.2 mph
I need help with these problems. I’m not sure where to start
off.
2. (10) Calculate the clear zone distance and note any needed run out area (additional recovery area) for the following: Design ADT 3000, Design Speed 40 mph. Tangent alignment. 6, shoulder at 4%, Foreslope (1V:5H) to ditch bottom. Ditch Bottom is 10. from edge of shoulder. Assume EOP and edge of traveled way are the same. (10) Calculate the clear zone distance and note any required run...
A car travels in a straight line a distance of 8.4 km at an average speed of 70 km / h before stopping due to lack of fuel. Following this stop, the driver of this car walks for 30 minutes over a distance of 2.0 km to get to the nearest gas station. at. What is the total distance the driver has traveled between the beginning of the journey of her car and until he arrives at the gas station?...
Section 2.1 Uniform Motion 1. I Alan leaves Los Angeles at 8:00 a.m. to drive to San Fran- cisco, 400 mi away. He travels at a steady 50 mph. Beth leaves Los Angeles at 9:00 a.m. and drives a steady 60 mph. a. Who gets to San Francisco first? b. How long does the first to arrive have to wait for the second? 2. I Larry leaves home at 9:05 and runs at constant speed to the lamppost seen in...
PROBLEMS and QUESTIONS 1. An object moves across the floor and comes to a stop. Explain how Aristotle and Galileo would view this motion differently. 2. Explain the difference between speed and velocity and give examples of each. 3. Explain how an object can have a constant speed and a varying velocity. 4. What are the units of acceleration? 5. If an automobile travels at the rate of 40 miles per hour, how long will it take to travel 400...
Motion diagram question
19. For the following motion diagrams, draw an arrow to indicate the displacement vector between the initial and final positions. b. 40 20. In each part of Exercise 19, is the object's displacement equal to the distance the object travels? Explain. 14. For each of the following motions, draw A motion diagram and Both position and velocity graphs a. A car starts from rest, steadily speeds up to 40 mph in 15 s, moves at a constant...
Supplementary Sheet Velocity Grade & Physics Use the following formulas to perform your calculations: Distance Speed x Time Time Speed Speeds Distance Time 1. Ali is driving along the highway from Tyre to Tripoli. He Travels 150Km in 3 hours a. Calculate the average speed of the car in Km/h b. What is the speed in m/s 2. A car travels with an average speed of 55 km/h for 2.5 hours. What is the distance covered by the car? How...
While waiting to catch a commuter train, I was standing just inside the yellow safety line, about 1 meter from the platform edge. Little did I know that an Acela train was coming through without stopping. That train was moving at about 60 miles per hour (about 28 meters per second). Estimate the velocity in miles per hour that the wind from the train hit me, 10 seconds after the first car has passed. Suppose that I had stood back...
A) A new power plant is proposed for the Great Plains, the details are very sketchy, but the press release says it will heat water to 480 degrees Centigrade, then convert it to electric power, then the left over water will return it to the heating plant at 220 degrees Centigrade. What is the thermal efficiency of the plant, not even knowing HOW they are heating /cooling or converting the energy. B)One big historical use for wind power was water...
battle has erupted over a local power plant owner's decision to raise the power delivered by the plant from 242 MW to 689 MW (The delivered power accounts for energy losses). The local population is increasing, so the area needs more power. However, the plant expends its heated waste water* into the Frustration River, local citizens are concerned that the heated water will raise water temperatures to the point where the endangered river smelt will die from oxygen depletion. Local...