Question

A dehumidifier receives a flow of 025 kgs dry air at 28°C, 80% relative humidity, as shown in the figure. It is cooled down to 20°C as it flows over the evaporator and then is heated up again as it flows over the condenser. The standard refrigeration cycle uses R-22 with an evaporator temperature of5°C and a condensation pressure of 1600 kPa. Determine: (a) the amount of liquid water removed, (10 points) (b) the heat transfer in the cooling process, (10 points) (c) the compressor work, (10 points) (d) the final air ex it temperature (10 points) (e) the final air relative humidity (10 points) Evaporator Valve Condenser Air back to room Air in
0 0
Add a comment Improve this question Transcribed image text
Know the answer?
Add Answer to:
A dehumidifier receives a flow of 025 kgs dry air at 28°C, 80% relative humidity, as...
Your Answer:

Post as a guest

Your Name:

What's your source?

Earn Coins

Coins can be redeemed for fabulous gifts.

Not the answer you're looking for? Ask your own homework help question. Our experts will answer your question WITHIN MINUTES for Free.
Similar Homework Help Questions
  • Dry ambient air, at a flow rate of 10 kg/hr, is to be heated from 50°C...

    Dry ambient air, at a flow rate of 10 kg/hr, is to be heated from 50°C to 72°C. The heating is provided by a condenser from an ideal vapour compression refrigeration cycle, using R134A as the refrigerant. The refrigeration cycle operates with its evaporator at 300 kPa and its condenser at 3 MPa. Calculate the refrigeration cycle compressor power requirement to provide this cooling.

  • Q.3 Outside air at 90°F, 1 atm, and 95% relative humidity with a flow rate of...

    Q.3 Outside air at 90°F, 1 atm, and 95% relative humidity with a flow rate of 4000 cfm is blown over an evaporator of a refrigeration system and exits at 75°F and 60% relative humidity. The refrigeration system has operating with the COP of 2.5. Determine (a) the amount of cooling provided by the evaporator Btu/hr (b) the amount of water condensed in the evaporator, lbm/hr and (c) the power required by the compressor of the refrigerator in kW. 1...

  • 2. An air conditioning system is to take in air at latm 33C, 70% relative humidity...

    2. An air conditioning system is to take in air at latm 33C, 70% relative humidity and flow rate of 50m3/min and deliver it 23C and 60% relative humidity. The air first flows over the cooling coils, where it is cooled and dehumidified, and then over the resistance heating wires, where it is heated to the desired temperature. Assuming that the condensate is removed from the cooling section at 10C, determine: a) The temperature of the air before it enters...

  • Problem 7 O/5 points (0%) Humid air at 1 atm, 42 °C dry bulb and 55 % relative humidity is cooled...

    Problem 7 O/5 points (0%) Humid air at 1 atm, 42 °C dry bulb and 55 % relative humidity is cooled at constant pressure to a temperature 9 °C below its dew-point temperature. Sketch the psychrometric diagram for the process and determine the heat transfer from the air o kJ/kg dry air Cooling coils T2 φ2 T1 ф! 101.3 kPa i H-4」+'Condensate Condensate removal Now Problem (resets attempts) Resets Remaining: 10 Attempts Remaining: 10 Submit Problem 7 O/5 points (0%)...

  • An air conditioner operating at steady state takes in moist air at 30 °C, 1 bar and a wet bulb temperature of 25

    An air conditioner operating at steady state takes in moist air at 30 °C, 1 bar and a wet bulb temperature of 25 °C. The moist air is cooled in the dehumidifier unit and some of the water is removed. There is 10 tons of cooling in the dehumidifier (also called the evaporator of an air conditioner). The condensate and the saturated air stream discharging the section is at 10 °C The moist air is then heated in the heater...

  • The atmospheric air 32 °C dry bulb temperature and 70% relative humidity supplied to the cooling...

    The atmospheric air 32 °C dry bulb temperature and 70% relative humidity supplied to the cooling coil at a rate of 45m3/min. The air cooling to the saturated state and leaving at a temperature of 16 °C. Determine: a- Specific humidity at each state. b- Wet bulb and dew point temperatures at the final state c- Final relative humidity. d- Mass of water condensed. e- Rate of heat removed from the air in kW. f- Show the process on Psychrometric...

  • Atmospheric air at 32°C and 70% relative humidity passes through a cooling section in an air-conditioning...

    Atmospheric air at 32°C and 70% relative humidity passes through a cooling section in an air-conditioning duct where the air is cooled below its dew point and some of the water is removed. The air then passes over a heating section where heat is added until the final temperature is 22°C and the relative humidity is 45%. Assume the process occurs at constant pressure of 1 atm. Using the psychrometric chart, determine: (a) The amount of water removed in the...

  • 11-35.A moist air mixture with a dry bulb temperature of 48°C, a relative humidity of 40...

    11-35.A moist air mixture with a dry bulb temperature of 48°C, a relative humidity of 40 percent, and a total pressure of 160 kPa is contained in a rigid vessel having a volume of 1.65 m3. The air is cooled until the dry bulb temperature reaches 23°C. Determine the amount of heat transferred, the final pressure of the air, and the amount of water vapor condensed during the process.

  • please write neat and include your approach to the problem along with any assumptions youre operating...

    please write neat and include your approach to the problem along with any assumptions youre operating under 14-88 Atmospheric air at 1 atm, 32°C, and 95 percent rela- tive humidity is cooled to 24°C and 60 percent relative humid- ity. A simple ideal vapor-compression refrigeration system using refrigerant-134a as the working fluid is used to provide the cooling required. It operates its evaporator at 4°C and its condenser at a saturation temperature of 39.4°C. The con- denser rejects its heat...

  • Moist air at 30°C, 1 atm, and 42% relative humidity enters an evaporative cooling unit operating...

    Moist air at 30°C, 1 atm, and 42% relative humidity enters an evaporative cooling unit operating at steady state consisting of a heating section followed by a soaked pad evaporative cooler operating adiabatically. The air passing through the heating section is heated to 45°C. Next, the air passes through a soaked pad exiting with 50% relative humidity. A. Determine the specific humidity of the entering moist air (to the heating section). (5 of 45 points. Please input your final answer...

ADVERTISEMENT
Free Homework Help App
Download From Google Play
Scan Your Homework
to Get Instant Free Answers
Need Online Homework Help?
Ask a Question
Get Answers For Free
Most questions answered within 3 hours.
ADVERTISEMENT
ADVERTISEMENT