

L=40cm mred=3kg msquare=9kg 0=45° B 6/4 D &/4 C The following object, made of homogeneous material...
d = 40cm
L = 62cm
P = 36kN
Q = 31kN
Section 3: Force and Stress (30 Points) d L P Consider the stress-strain diagram for the cylindrical specimen undergoing compression. Write your student ID# in the boxes to the left. Diameter and length are in units of centimeters. Loads P and Q are in kiloNewtons. If any of your loads are less than 10, add 30 to the value. o Q 20 MPa (4 pts) a) What is...
A 3 m rigid bar AB is supported with a vertical translational spring at A and a pin at B The bar is subjected to a linearly varying distributed load with maximum intensity g Calculate the vertical deformation of the spring if the spring constant is 700 kN/m. (ans: 21.43 mm) 2. A steel cable with a nominal diameter of 25 mm is used in a construction yard to lift a bridge section weighing 38 kN. The cable has an...
summatize the following info and break them into differeng key points. write them in yojr own words
apartus
6.1 Introduction—The design of a successful hot box appa- ratus is influenced by many factors. Before beginning the design of an apparatus meeting this standard, the designer shall review the discussion on the limitations and accuracy, Section 13, discussions of the energy flows in a hot box, Annex A2, the metering box wall loss flow, Annex A3, and flanking loss, Annex...