Homework Answers
A mixture of two or more liquids can be separated by distillation. Distillation process contains heating the solvent/liquid mixture followed by condensation. In distillation setup the liquid vapour generated by heating the liquid to its boiling temperature & condensed by using water cool condenser.
Sea water salts can be isolated/separated by distillating the sea water.
Add Answer to:
In the distillation set-up, what is the purpose of the water-cooled condenser? Sea water is a...
35. In a distillation set up a) Cold water flows into the condenser from the elevated...
35. In a distillation set up a) Cold water flows into the condenser from the elevated end of the condenser and flows out of the lower end b) Plastic joint clips should not be used to hold the glass joints of the equipment together, equipment clamps are sufficient c) In a properly set up distillation experiment azeotropes will never occur. d) A and C alone e) None of the above 34. If a distillation is carried out under reduced pressure...
Sea water contains about 28.0g of NaCl per liter, what is the molarity? What is the...
Sea water contains about 28.0g of NaCl per liter, what is the molarity? What is the molarity of 5.30g of Na2CO, dissolved in 400.0mL solution? How many moles of Na,Co, are in 10.0L of a 2.00M solution?
What is the purpose of shaking the ether layer with a saturated NaCl solution? What is...
What is the purpose of shaking the ether layer with a saturated NaCl solution? What is the purpose of adding CaCl2 to the ether layer? In this experiment you separated a mixture of benzoic acid, 4-t-butylphenol, and 1,4-dimethoxybenzene. You were instructed to dissolve the mixture in tert-butyl ether and extract with sodium bicarbonate first. Why can’t you extract with sodium hydroxide first? Explain. A mixture of lactic acid (pKa 3.86) and ascorbic acid (pKa 11.80) are dissolved in an organic...
B. Set up a system of equations for the following situation and then use MATLAB to solve the system Tank A contains 50 gallons of water in which 25 pounds of salt are dissolved. A second tank, B, con...
B. Set up a system of equations for the following situation and then use MATLAB to solve the system Tank A contains 50 gallons of water in which 25 pounds of salt are dissolved. A second tank, B, contains 50 gallons of pure water. Liquid is pumped in and out of the tanks at the rates shown in Figure 8.9. Derive the differential equations taerihe themuunds and B, respectively d tm in tanks A mixture pure water 3 gal/min 1...
A tank initially contains 500 gallons of water in which 40 pounds of salt is initially dissolved in the water
A tank initially contains 500 gallons of water in which 40 pounds of salt is initially dissolved in the water. Brine (a water-salt mixture) containing 0.4 pounds of salt per gallon flows into the tank at the rate of 5 gal/min, and the mixture (which is assumed to be perfectly mixed) flows out of the tank at the same rate of 5 gal/min. Let y(t) be the amount of salt (in pounds) in the tank at time t. a) Set up...
What is the purpose of adding water after cooling the reaction mixture in this experiment? I...
What is the purpose of adding water after cooling the reaction mixture in this experiment? I understand it is to precipitate the product, but what exactly does water do in this, what impurity does it get rid of and how? Mesostillbenedibromide crude with KOH and triethyl glycol in a double elimination to produce Diphenylacetylene. Water is added after the reaction mixture is cooled. Then it is put through vacuum filtration, and further recrystallized with 7:3 etoac:water in a hot water...
Remember in experiment 2 you used boiling chips; can the boiling sticks be replaced by boiling...
Remember in experiment 2 you used boiling chips; can the boiling sticks be replaced by boiling chips in this experiment? Explain your answer. Experiment2: Determination of Alcohol content of Wine by Fractional Distillation Introduction If a mixture of ethanol and water are warmed you might expect the more volatile (lower boiling) ethanol to boil first and then the water. This is not exactly true. As the mixture is warmed all the molecules within the flask will gain energy. In fact...
(1) De (2) Wh in water? (3) What is the purpose of washing with water after...
(1) De (2) Wh in water? (3) What is the purpose of washing with water after extraction with a reaction solvent? (4) What is the purpose of using a tared test tube? (5) W (6) What is the purpose of using a porous plate? (7) Why should a piece of weighing paper be put under the porous plate? (8) Why should you not touch the crystals with your fingers? fine: take up, wash with water, drying agent, absorb, mother liquor...
You don’t have to tell me purpose. just where in procedure for each technique. Section/Instructor SN2...
You
don’t have to tell me purpose. just where in procedure for each
technique.
Section/Instructor SN2 Pre-lab (20 points) Answer on a separate piece of paper 1. (6 pts.) What is the purpose of the following experimental techniques and where in the procedure is each used? a. Heating under reflux b. Simple distillation c. Water wash d. Addition of COLD NAOH e. Saturated NaCl solution f. Addition of anhydrous sodium sulfate SN2 Reaction Procedure Set-Up: 100 mL RBF: 11.1 g...
a) When setting up the reflux condenser, does it matter if the water flows into the...
a) When setting up the reflux condenser, does it matter
if the water flows into the bottom or the top of the condenser? If
so, does it have to flow into the bottom or the top, and why? If
not, why does it not matter?
Question pertains to the following reactions:
Reaction 2: Reduction NO2 NH4HCO2 NH2 + NO2 Pd/C NO2 NH2 NH2 m-methylaniline p-methylaniline 0-methylaniline ortho meta para Procedure for Reaction 2: 1) The mixture of ortho, meta, and...
35. In a distillation set up a) Cold water flows into the condenser from the elevated end of the condenser and flows out of the lower end b) Plastic joint clips should not be used to hold the glass joints of the equipment together, equipment clamps are sufficient c) In a properly set up distillation experiment azeotropes will never occur. d) A and C alone e) None of the above 34. If a distillation is carried out under reduced pressure...
Sea water contains about 28.0g of NaCl per liter, what is the molarity? What is the molarity of 5.30g of Na2CO, dissolved in 400.0mL solution? How many moles of Na,Co, are in 10.0L of a 2.00M solution?
B. Set up a system of equations for the following situation and then use MATLAB to solve the system Tank A contains 50 gallons of water in which 25 pounds of salt are dissolved. A second tank, B, contains 50 gallons of pure water. Liquid is pumped in and out of the tanks at the rates shown in Figure 8.9. Derive the differential equations taerihe themuunds and B, respectively d tm in tanks A mixture pure water 3 gal/min 1...
(1) De (2) Wh in water? (3) What is the purpose of washing with water after extraction with a reaction solvent? (4) What is the purpose of using a tared test tube? (5) W (6) What is the purpose of using a porous plate? (7) Why should a piece of weighing paper be put under the porous plate? (8) Why should you not touch the crystals with your fingers? fine: take up, wash with water, drying agent, absorb, mother liquor...
You
don’t have to tell me purpose. just where in procedure for each
technique.
Section/Instructor SN2 Pre-lab (20 points) Answer on a separate piece of paper 1. (6 pts.) What is the purpose of the following experimental techniques and where in the procedure is each used? a. Heating under reflux b. Simple distillation c. Water wash d. Addition of COLD NAOH e. Saturated NaCl solution f. Addition of anhydrous sodium sulfate SN2 Reaction Procedure Set-Up: 100 mL RBF: 11.1 g...
a) When setting up the reflux condenser, does it matter
if the water flows into the bottom or the top of the condenser? If
so, does it have to flow into the bottom or the top, and why? If
not, why does it not matter?
Question pertains to the following reactions:
Reaction 2: Reduction NO2 NH4HCO2 NH2 + NO2 Pd/C NO2 NH2 NH2 m-methylaniline p-methylaniline 0-methylaniline ortho meta para Procedure for Reaction 2: 1) The mixture of ortho, meta, and...
Most questions answered within 3 hours.
-
Where is the error in this code sequence?
String s1 = "Hello";
String s2 = "ello";...
asked 10 months ago -
Financial data for Joel de Paris, Inc., for last year
follow:
Joel de Paris, Inc.
Balance...
asked 10 months ago -
Consider this reaction:
Al2(SO4)3 (aq)+ BaCl3
(aq) Al2Cl6 (aq)- +
3BaSO4(s) . What is the...
asked 10 months ago -
Suppose that Savneet is considering increasing her
recent random sample from 20 car rentals to 40...
asked 10 months ago -
Trucks arrive at an unloading terminal at an average rate of 120
per hour.
Trucks arrive...
asked 10 months ago -
Why are methanol and ethanol completely soluble in water while
octanol is not very little soluble....
asked 10 months ago -
A facilities manager at a university reads in a research report
that the mean amount of...
asked 10 months ago -
When the CuSO4 is rehydrated by adding water to the anhydrous
compound, is this an endothermic...
asked 10 months ago -
A ray of sunlight is passing from diamond into crown glass; the
angle of incidence is...
asked 10 months ago -
A block of mass 0.249 kg is placed on top of a light, vertical
spring of...
asked 10 months ago -
how do the kidneys compensate in the presences of acidosis
a) trigger hyperventilate
b) reserve acid...
asked 10 months ago -
Question 501 pts
The rental rate of capital to the firm increases. Which of the
following...
asked 10 months ago