Homework Answers
From the given input signal we can find the time period 't'
t=0.07-0.03=0.04
Now the frequency =1/t
f=1/(0.04)=25hz
X0=1.5
X1=1.5
X-1=1.5
*** Please give me likes ***
Add Answer to:
PROBLEM: A signal x(t)-A cos (2nfit + ф) įs shown in the figure bclow. x (t)...
No mathematical expression for x(t). Problem 2: A message signal x(t), is illustrated in the graphs...
No mathematical expression for x(t).
Problem 2: A message signal x(t), is illustrated in the graphs below x(t) 1.5 1 0.5 -1 3 -0.5 1 -1.5 Time (s) 2 1 -45 -30 -15 0 15 Frequency (kHz) This signal is applied to a Narrow Band FM generator as shown below; x(t) Ф. (t) NBFM 5.60 MHz. anda frequency deviation The NBFM Signal p(t) has a center frequency f Afi 2.4 kHz - A. Sketch the time-domain signal p1(t) using the...
Q1) Given an analog signal X(t) = 3 cos (2π . 2000t) + 2 cos (2π...
Q1) Given an analog signal X(t) = 3 cos (2π . 2000t) + 2 cos (2π . 5500t) sampled at a rate of 10,000 Hz, a. Sketch the spectrum of the sampled signal up to 20 kHz; b. Sketch the recovered analog signal spectrum if an ideal lowpass filter with a cutoff frequency of 4 kHz is used to filter the sampled signal in order to recover the original signal ; c. Determine the frequency/frequencies of aliasing noise . Q2)...
Problem 1 Consider the sinusoidal signal x(t) shown below. 10 8 4 2 4 6 8...
Problem 1 Consider the sinusoidal signal x(t) shown below. 10 8 4 2 4 6 8 -10 0.2 0.4 0.6 0.8 t (seconds) (i) What is the amplitude of this signal? ii) What is the period of this signal (in seconds)? (iii) What is the frequency of this signal (in Hertz)? (iv) Write an equation for this signal.
In this assignment, you will be working with two sinusoidal signals. The higher-frequency signal c(t)...
In this assignment, you will be working with two sinusoidal signals. The higher-frequency signal c(t) = cos(2*pi*F*t) (where F is in Hertz) will be referred to as "carrier"; while the lower-frequency signal v(t) = 1.5 + cos(2*pi*f*t + q) (f in Hz, again) will be referred to as "envelope". Note that the envelope has a positive offset of 1.5 units. In amplitude modulation (AM), the envelope multiplies the carrier and the resulting product signal is the AM...
Consider a speech signal x() that has the following frequency spectrum: xga) 1 + cos( -/100 a) Se...
Digital Signal Processing
DFT
Consider a speech signal x() that has the following frequency spectrum: xga) 1 + cos( -/100 a) Select appropriate values of N and T that will help us carry out DFT-based spectral analysis of this signal x401@) 800 such that the continuous-time frequencies are sampled no farther than 10 Hz apart. b) Ignore the issue of spectral leakage; under this assumption, provide a closed-form expression for the DFT of the signal using the values selected in...
Problem 2) For a 2 DOF system the equations of motion are given as: [mi 0...
Problem 2) For a 2 DOF system the equations of motion are given as: [mi 0 0 m2 (X2 mig L -m29 L -m29 L m29 L Where m1 =m2 =m g=gravity and L =length a) Determine the frequencies and mode shapes. b) Verify that the natural modes are orthogonal. c) Determine the response fX:(0) Note: x1(t) = xo , x2(t) = 0 and xi(t) = xo , iz(t) = 0 d) If the system is excited by a harmonic...
Problem 1. Equipment ratings and per-unit reactances for the system shown in figure 1. are given...
Problem 1. Equipment ratings and per-unit reactances for the system shown in figure 1. are given as follows Using a 100-MVA, 230-kV base for the transmission lines, draw the per-unit sequence networks Consider the impact of ?-Y phase shifts Synchronous generators: G 100 MVA 25kV X1-X2 0.2Xo 0.05 G2100 MVA 13.8 kV X,-X2 0.2 Xo 0.05 Transformers: TI 100 MVA 25/230 kV Xi-X-Xo-0.05 T2 100 MVA 13.8/230 kV X-X2 = Xo 0.05 Transmission lines: TL 12 100MVA 230 kV X,=X2=0.1...
Signal xo(t) 5 cos (200π1+ 품 ) + 4 sin (300π) is sampled at a rate of Fs = 1 kHz to obtain the discrete-time signal x[n]. (a) Determine the spectrum X(ej ) of x[n] and plot its magnitude as a functi...
Signal xo(t) 5 cos (200π1+ 품 ) + 4 sin (300π) is sampled at a rate of Fs = 1 kHz to obtain the discrete-time signal x[n]. (a) Determine the spectrum X(ej ) of x[n] and plot its magnitude as a function of ω rad sam in tad and as a function of F in Hz. Explain whether the original signal xe(t) can be recovered from xln]. (b) Repeat part (a) for 500 Hz. (c) Repeat part (a) for 100...
Problem 1 A sinusodial signal x(t)- sin2t (t in seconds) is input to a system with frequency resp...
Problem 1 A sinusodial signal x(t)- sin2t (t in seconds) is input to a system with frequency response: H(G What signal y(t) is observed at the output? Problem 2 The inverse Fourier transform of a system frequency response is given by h(t)t. The signal x(t) 3 cos(4t 0.5) is input to the system (t in seconds). (a) What is the expression of the signal y(t) at the system output? (b) What is the power attenuation in dB caused by the...
Problem 3.8 Find and sketch g(t)=x(t)*x(t) for the pair of functions shown below. Did you notice...
Problem 3.8 Find and sketch g(t)=x(t)*x(t) for the pair of functions shown below. Did you notice anything interesting? x(t) xz(t)xz(t) x2(t) - 3 3 -1 -1 of xi(t) xz(t) xz(t)xzt) X(t) xz(t) xz(t) * x2(t) xi(t) xz(t) xi(t) = x2(t) Note: Everlasting signal AAA xi(t) xz(t) xi(t) *xz(t) Note: Everlasting signal AAA xi(t) xalt) xi(t) + x2(t) Note: Everlasting signal АААА
No mathematical expression for x(t).
Problem 2: A message signal x(t), is illustrated in the graphs below x(t) 1.5 1 0.5 -1 3 -0.5 1 -1.5 Time (s) 2 1 -45 -30 -15 0 15 Frequency (kHz) This signal is applied to a Narrow Band FM generator as shown below; x(t) Ф. (t) NBFM 5.60 MHz. anda frequency deviation The NBFM Signal p(t) has a center frequency f Afi 2.4 kHz - A. Sketch the time-domain signal p1(t) using the...
Problem 1 Consider the sinusoidal signal x(t) shown below. 10 8 4 2 4 6 8 -10 0.2 0.4 0.6 0.8 t (seconds) (i) What is the amplitude of this signal? ii) What is the period of this signal (in seconds)? (iii) What is the frequency of this signal (in Hertz)? (iv) Write an equation for this signal.
Digital Signal Processing
DFT
Consider a speech signal x() that has the following frequency spectrum: xga) 1 + cos( -/100 a) Select appropriate values of N and T that will help us carry out DFT-based spectral analysis of this signal x401@) 800 such that the continuous-time frequencies are sampled no farther than 10 Hz apart. b) Ignore the issue of spectral leakage; under this assumption, provide a closed-form expression for the DFT of the signal using the values selected in...
Problem 2) For a 2 DOF system the equations of motion are given as: [mi 0 0 m2 (X2 mig L -m29 L -m29 L m29 L Where m1 =m2 =m g=gravity and L =length a) Determine the frequencies and mode shapes. b) Verify that the natural modes are orthogonal. c) Determine the response fX:(0) Note: x1(t) = xo , x2(t) = 0 and xi(t) = xo , iz(t) = 0 d) If the system is excited by a harmonic...
Problem 1. Equipment ratings and per-unit reactances for the system shown in figure 1. are given as follows Using a 100-MVA, 230-kV base for the transmission lines, draw the per-unit sequence networks Consider the impact of ?-Y phase shifts Synchronous generators: G 100 MVA 25kV X1-X2 0.2Xo 0.05 G2100 MVA 13.8 kV X,-X2 0.2 Xo 0.05 Transformers: TI 100 MVA 25/230 kV Xi-X-Xo-0.05 T2 100 MVA 13.8/230 kV X-X2 = Xo 0.05 Transmission lines: TL 12 100MVA 230 kV X,=X2=0.1...
Signal xo(t) 5 cos (200π1+ 품 ) + 4 sin (300π) is sampled at a rate of Fs = 1 kHz to obtain the discrete-time signal x[n]. (a) Determine the spectrum X(ej ) of x[n] and plot its magnitude as a function of ω rad sam in tad and as a function of F in Hz. Explain whether the original signal xe(t) can be recovered from xln]. (b) Repeat part (a) for 500 Hz. (c) Repeat part (a) for 100...
Problem 1 A sinusodial signal x(t)- sin2t (t in seconds) is input to a system with frequency response: H(G What signal y(t) is observed at the output? Problem 2 The inverse Fourier transform of a system frequency response is given by h(t)t. The signal x(t) 3 cos(4t 0.5) is input to the system (t in seconds). (a) What is the expression of the signal y(t) at the system output? (b) What is the power attenuation in dB caused by the...
Problem 3.8 Find and sketch g(t)=x(t)*x(t) for the pair of functions shown below. Did you notice anything interesting? x(t) xz(t)xz(t) x2(t) - 3 3 -1 -1 of xi(t) xz(t) xz(t)xzt) X(t) xz(t) xz(t) * x2(t) xi(t) xz(t) xi(t) = x2(t) Note: Everlasting signal AAA xi(t) xz(t) xi(t) *xz(t) Note: Everlasting signal AAA xi(t) xalt) xi(t) + x2(t) Note: Everlasting signal АААА
Most questions answered within 3 hours.
-
Where is the error in this code sequence?
String s1 = "Hello";
String s2 = "ello";...
asked 10 months ago -
Financial data for Joel de Paris, Inc., for last year
follow:
Joel de Paris, Inc.
Balance...
asked 10 months ago -
Consider this reaction:
Al2(SO4)3 (aq)+ BaCl3
(aq) Al2Cl6 (aq)- +
3BaSO4(s) . What is the...
asked 10 months ago -
Suppose that Savneet is considering increasing her
recent random sample from 20 car rentals to 40...
asked 10 months ago -
Trucks arrive at an unloading terminal at an average rate of 120
per hour.
Trucks arrive...
asked 10 months ago -
Why are methanol and ethanol completely soluble in water while
octanol is not very little soluble....
asked 10 months ago -
A facilities manager at a university reads in a research report
that the mean amount of...
asked 10 months ago -
When the CuSO4 is rehydrated by adding water to the anhydrous
compound, is this an endothermic...
asked 10 months ago -
A ray of sunlight is passing from diamond into crown glass; the
angle of incidence is...
asked 10 months ago -
A block of mass 0.249 kg is placed on top of a light, vertical
spring of...
asked 10 months ago -
how do the kidneys compensate in the presences of acidosis
a) trigger hyperventilate
b) reserve acid...
asked 10 months ago -
Question 501 pts
The rental rate of capital to the firm increases. Which of the
following...
asked 10 months ago