When verifying the heating effect of an electric current, every 60 seconds, you measured the...
Homework Answers
Heating produced of Electric Current is given by
.....................(1)
where I= current
R= resistance
t= time taken
then since temperature is not that much to change the resistance thus Resistance of the conductor will be constant. Then to measure the heating effect of electric current, we have to measure the electric current(using equation 1)
Hence correct option: d.current.
Add Answer to:
When verifying the heating effect of an electric current, every 60 seconds, you measured the...
When verifying Ohm's law, you found that the electric current was a function of a....
When verifying Ohm's law, you found that the electric current was a function of a. capacitance b. voltage c. milliamps d. time
In the Coulomb's Law experiment, the spheres were charged by touching with a voltmeter ground probe...
In the Coulomb's Law experiment, the spheres were charged by touching with a voltmeter ground probe charging probe ammeter The charges carried by the spheres above were proportional to the potential current resistance temperature By mapping the equipotential lines, you can draw the charge the electric field lines nothing the magnetic field lines In which of the following experiments a galvanometer was NOT used? mapping of the electric field study of a source of emf and terminal voltage the Wheatstone...
When verifying Ohm's law, you plotted a current-voltage graph based on the measured data for an unknown resistor
When verifying Ohm's law, you plotted a current-voltage graph based on the measured data for an unknown resistor, as shown in Fig. 2. Its resistance is estimated to be a. 0.00006 Ω b. 0.00142Ω c.16.7kΩ d, 704 Ω
1 A repelling force must occur between two charged objects under which conditions?
1 A repelling force must occur between two charged objects under which conditions? a. charges are of unlike signs b. charges are of like signs c. charges are of equal magnitude d.charges are of unequal magnitude 2 Two point charges are 4 cm apart. They are moved to a new separation of 2 cm. By what factor does the electric force between them change? a.2 b. 1/2 c.4 d. 1/4 3. By mapping the equipotential lines, you can draw a. the charge b. the electric field...
when verifying ohm’s law, you plotted a current-voltage graph based on the measurements data for unknown...
when verifying ohm’s law, you plotted a current-voltage graph based
on the measurements data for unknown resistor, as show fig 2 it’s
resistance is estimated to be
1.2DE-02 1 10E-02 1.00E-02 9.008-03 8 ODE-03 7.ODE-03 6.0CE-03 5.00E-03 .00E-03 Rx y-0.00142x+0.00006 60 12 Voltage [V] Fig. 1 Fig. 2 When verifying Ohm's law, you plotted a current-voltage graph based on the measured data for an unknown resistor, as shown in Fig. 2. Its resistance is estimated to be 9.
5. An electric heater has a Nichrome heating element with a resistance of 9 Ω at...
5. An electric heater has a Nichrome heating element with a resistance of 9 Ω at 20°C. When l 16 V are applied, the electric current heats the Nichrome wire to 1060 C What is the operating wattage of this heater? The temperature coefficient of resistivity of Nichrome is α-0.0004 C Watts
An electric heater has a Nichrome heating element with a resistance of 7 Ω at 20oC....
An electric heater has a Nichrome heating element with a resistance of 7 Ω at 20oC. When 118 V are applied, the electric current heats the Nichrome wire to 980oC. What is the operating wattage of this heater? (The temperature coefficient of resistivity of Nichrome is α = 0.0004 Co-1)
When an electric heater is turned on, the Nichrome heating element is at 0o C and...
When an electric heater is turned on, the Nichrome heating element is at 0o C and draws a current of 14 A, with a potential difference of 120 V between the ends of the element. The element heats up to 873° C, with the potential difference constant. Find the final current. (The temperature coefficient of resistivity of Nichrome is 4.0 × 10-4 (°C)-1.)
When an electric heater is turned on, the Nichrome heating element is at 0° C and...
When an electric heater is turned on, the Nichrome heating element is at 0° C and draws a current of 17 A, with a potential difference of 120 V between the ends of the element. The element heats up to 794° C, with the potential difference constant. Find the final current. (The temperature coefficient of resistivity of Nichrome is 4.0 10-4 (°C)-1.)
The resistance of an RTD is measured with a DMM that produces an excitation current of...
The resistance of an RTD is measured with a DMM that produces an excitation current of 5mA. The measured resistance is 92.5Ω. Find the temperature of the RTD if it has the following parameters: R0 = 100Ω, T0 = 0°C, α0 = 0.00385 C-1. Also, find the power dissipated in the RTD during the measurement. What is the smallest value of dissipation constant such that the temperature measurement error due to self heating is less than 0.5°C?
In the Coulomb's Law experiment, the spheres were charged by touching with a voltmeter ground probe charging probe ammeter The charges carried by the spheres above were proportional to the potential current resistance temperature By mapping the equipotential lines, you can draw the charge the electric field lines nothing the magnetic field lines In which of the following experiments a galvanometer was NOT used? mapping of the electric field study of a source of emf and terminal voltage the Wheatstone...
when verifying ohm’s law, you plotted a current-voltage graph based
on the measurements data for unknown resistor, as show fig 2 it’s
resistance is estimated to be
1.2DE-02 1 10E-02 1.00E-02 9.008-03 8 ODE-03 7.ODE-03 6.0CE-03 5.00E-03 .00E-03 Rx y-0.00142x+0.00006 60 12 Voltage [V] Fig. 1 Fig. 2 When verifying Ohm's law, you plotted a current-voltage graph based on the measured data for an unknown resistor, as shown in Fig. 2. Its resistance is estimated to be 9.
5. An electric heater has a Nichrome heating element with a resistance of 9 Ω at 20°C. When l 16 V are applied, the electric current heats the Nichrome wire to 1060 C What is the operating wattage of this heater? The temperature coefficient of resistivity of Nichrome is α-0.0004 C Watts
When an electric heater is turned on, the Nichrome heating element is at 0o C and draws a current of 14 A, with a potential difference of 120 V between the ends of the element. The element heats up to 873° C, with the potential difference constant. Find the final current. (The temperature coefficient of resistivity of Nichrome is 4.0 × 10-4 (°C)-1.)
Most questions answered within 3 hours.
-
Where is the error in this code sequence?
String s1 = "Hello";
String s2 = "ello";...
asked 10 months ago -
Financial data for Joel de Paris, Inc., for last year
follow:
Joel de Paris, Inc.
Balance...
asked 10 months ago -
Consider this reaction:
Al2(SO4)3 (aq)+ BaCl3
(aq) Al2Cl6 (aq)- +
3BaSO4(s) . What is the...
asked 10 months ago -
Suppose that Savneet is considering increasing her
recent random sample from 20 car rentals to 40...
asked 10 months ago -
Trucks arrive at an unloading terminal at an average rate of 120
per hour.
Trucks arrive...
asked 10 months ago -
Why are methanol and ethanol completely soluble in water while
octanol is not very little soluble....
asked 10 months ago -
A facilities manager at a university reads in a research report
that the mean amount of...
asked 10 months ago -
When the CuSO4 is rehydrated by adding water to the anhydrous
compound, is this an endothermic...
asked 10 months ago -
A ray of sunlight is passing from diamond into crown glass; the
angle of incidence is...
asked 10 months ago -
A block of mass 0.249 kg is placed on top of a light, vertical
spring of...
asked 10 months ago -
how do the kidneys compensate in the presences of acidosis
a) trigger hyperventilate
b) reserve acid...
asked 10 months ago -
Question 501 pts
The rental rate of capital to the firm increases. Which of the
following...
asked 10 months ago