Question

The device just joined the network, of which network address is 2000:152E:C531/48. If the device is...

  1. The device just joined the network, of which network address is 2000:152E:C531/48. If the device is in the subnet 1185 and its IEEE physical address is 0D-09-E1-D2-A0-5F, what is the IPv6 address this device can use ?
0 0
Add a comment Improve this question Transcribed image text
Know the answer?
Add Answer to:
The device just joined the network, of which network address is 2000:152E:C531/48. If the device is...
Your Answer:

Post as a guest

Your Name:

What's your source?

Earn Coins

Coins can be redeemed for fabulous gifts.

Not the answer you're looking for? Ask your own homework help question. Our experts will answer your question WITHIN MINUTES for Free.
Similar Homework Help Questions
  • The device just joined the network, of which network address is 2000:152E:C531/48. If the device is...

    The device just joined the network, of which network address is 2000:152E:C531/48. If the device is in the subnet 1185 and its IEEE physical address is 0D-09-E1-D2-A0-5F, what is the IPv6 address this device can use ?

  • When an IPv6 device with no pre-configured IPv6 address powers up, it can calculate a global...

    When an IPv6 device with no pre-configured IPv6 address powers up, it can calculate a global 128-bit IPv6 address for itself using Stateless Address Autoconfiguration (SLAAC), which combines two values: (a) a 64-bit IPv6 Prefix for the subnet (link) and (b) a 64-bit Interface ID. 4. (5 points) How does the device learn the value of the IPv6 Prefix for its subnet? (5 points) How does the device determine the value of its Interface ID? Describe 2 ways a) b)

  • Cybersecurity: When an IPv6 device with no pre-configured IPv6 address powers up, it can calculate a...

    Cybersecurity: When an IPv6 device with no pre-configured IPv6 address powers up, it can calculate a global 128- bit IPv6 address for itself using Stateless Address Autoconfiguration (SLAAC), which combines two values: (a) a 64-bit IPv6 Prefix for the subnet (link) and (b) a 64-bit Interface ID. a) (5 points) How does the device learn the value of the IPv6 Prefix for its subnet? b) (5 points) How does the device determine the value of its Interface ID? Describe 2...

  • Is a “subnet” a logical structure or a physical structure”? Why would a network administrator chose...

    Is a “subnet” a logical structure or a physical structure”? Why would a network administrator chose to use a CIDR addressing scheme rather than use the class A, class B, and class C designations usually associated with IPv4? What are some of the major differences between IPv4 and IPv6? Since IPv6 is not backward compatible with IPv4, what are some of the ways in which a network administrators can assure that both IPv4 and IPv6 addresses will be accommodated within...

  • Plz answer 27 to 40 flooding the network with 27. Which of the following is a...

    Plz answer 27 to 40 flooding the network with 27. Which of the following is a type of denial-of-service attack that involves broadcast messages that contain a spoofed source address of an intended victim? a. packet storm b. broadcast flood c. smurf attack d. half-open SYN attack 28. When would you most likely NOT choose to use a leased line connection? a. when high-quality, 24/7 access is needed b. for mission critical applications c. when fast upstream as well as...

  • Refer to the network figure above, showing two Ethernet Subnets connected through an IP Router, for questions #1, #2 and #3. For each device, both its Internet Protocol (IP) address and its MAC addre...

    Refer to the network figure above, showing two Ethernet Subnets connected through an IP Router, for questions #1, #2 and #3. For each device, both its Internet Protocol (IP) address and its MAC address (also called the Physical address or the Ethernet address) are shown. The Subnet Mask used by all devices is 255.255.255.192 (which is same as prefix length “/26”). (5 points) Assuming that Client #1 sent a packet to Client #3 and then Client #3 sent a packet...

  • PART A 21 MARKS SHORT ANSWER QUESTIONS Answer ALL questions from this part. Write your answers...

    PART A 21 MARKS SHORT ANSWER QUESTIONS Answer ALL questions from this part. Write your answers in the Examination Answer Booklet. Each question is worth 1.5 marks (14 x 1.5 = 21 marks). Question 1 An organisation has been granted a block of addresses with the mask /22. If the organisation creates 8 equal-sized subnets, how many addresses (including the special addresses) are available in each subnet? Show your calculations. Question 2 Give an example of a valid classful address...

  • In this lab, we’ll investigate the 802.11 wireless network protocol. Follow the instructions and answers questions...

    In this lab, we’ll investigate the 802.11 wireless network protocol. Follow the instructions and answers questions 7 - 10. http://gaia.cs.umass.edu/wireshark-labs/wireshark-traces.zip In this lab, we'll investigate the 802.11 wireless network protocol. Before beginning this lab, you might want to re-read Section 6.3 in the text. Since we l1 be delving a bit deeper into 802.11 than is covered in the text, you might want to check out "A Technical Tutorial on the 802.11Protocol," by Pablo Brenner (Breezecom Communications) http://www.sss-mag.com/pdf802_11tut.pdf, and "Understanding...

  • Q1 Error detection/correction Can these schemes correct bit errors: Internet checksums, two-dimendional parity, cyclic...

    Q1 Error detection/correction Can these schemes correct bit errors: Internet checksums, two-dimendional parity, cyclic redundancy check (CRC) A. Yes, No, No B. No, Yes, Yes c. No, Yes, No D. No, No, Yes E. Ho, hum, ha Q2 CRC vs Internet checksums Which of these is not true? A. CRC's are commonly used at the link layer B. CRC's can detect any bit error of up to r bits with an r-bit EDC. c. CRC's are more resilient to bursty...

  • I had tried to work with the wireshark interface and cannot navigate it due to network problems a...

    I had tried to work with the wireshark interface and cannot navigate it due to network problems and cannot find the question solutions, if any one can help with detailed steps it would be a great help. Wireshark Lab #2: Ethernet In this lab, we'll investigate the Ethernet protocol and the ARP protocol. Before beginning this lab, you'l1 probably want to review sections 6.4.1 (Link-layer addressing and ARP) and 6.4.2 (Ethernet) in the text. RFC 826 (ftp://ftp.rfc-editor.org/in- notes/std/std37.txt) contains the...

ADVERTISEMENT
Free Homework Help App
Download From Google Play
Scan Your Homework
to Get Instant Free Answers
Need Online Homework Help?
Ask a Question
Get Answers For Free
Most questions answered within 3 hours.
ADVERTISEMENT
ADVERTISEMENT