2. A generator consists of 75 square loops of Copper wire from a single strand 30 meters in length. The diameter of the wire is 1 millimeter.
A) What is the area of each loop of the wire?
B) What is the resistance of the wire?
C) If the wire is spun in a uniform 0.125T magnetic field that varies between parallel and perpendicular to the plane of the loops find an expression for the EMF generated if the angular velocity is 628 radians/second. What is the peak and the rms voltage?
D)If the generator is connected to a 500 Ohm resistor what is the maximum current? What is the RMS current?

Solving the above two equations
I1 = 2.143 A
I2 = 0.238 A
I3 = 1.905 A
I4 = 0.238 A
Comment in case any doubt please rate my answer....
2. A generator consists of 75 square loops of Copper wire from a single strand 30...
An electric generator consists of a circular coil of wire of radius 1.0×10−2 m , with 20 turns. The coil is located between the poles of a permanent magnet in a uniform magnetic field, of magnitude 4.0×10−2 T . The B field is orientated perpendicular to the axis of rotation. The ends of the coil are connected via sliding contacts across a resistor of resistance 1.5 Ω. The peak current measured through the resistor is 1.0×10−3 A What is the...
Please can you do both . #1. A circular loop of wire with cross sectional area 0.20m^2 is exposed to Magnetic Field B that changes at a rate of 4*10^-10 T per second. An emf of ______ V is induced in the loop. #2. An ac circuit consists only of 3 ohm resistor and a capacitor with a reactance of 5 ohm. When connected accross a 10 V rms ac generator, an rms current of ________ passes through the circuit.
2. Suppose you have a AC motor built from the design below. The square metal wire between the magnets has a side length of.05 magnetic field of magnitude 2 tesla, and that the motor is connected to a 10 ohm resistor via a circuit. meters. Assuming that the permanent magnets create a constant a. If the circuit is connected to an alternating voltage source, then (ignoring the back emf), what will the peak voltage of the voltage source have to...
The armature of a small generator consists of a flat, square coil with 200 turns and sides with a length of 1.70 cm. The coil rotates in a magnetic field of 8.55x10-2T. You may want to review (Page) For related problemsolving tips and strategies, you may want to view a Video Tutor Solution of Emf and current induced in a loop. Part A What is the angular speed of the coil if the maximum emf produced is 2.90x10-2 V? Express...
1. A square loop whose sides are 6.0-cm long is made with copper wire of radius 1.0 mm. If a magnetic field perpendicular to the loop is changing at a rate of 5.0 mT/s, what is the current in the loop? 2. A long solenoid with n = 10 turns per centimeter has a cross-sectional area of 5.0 cm2 and carries a current of 0.25 A. A coil with five turns encircles the solenoid. When the current through the solenoid...
4. A charged particle is projected into a uniform B-field. Its velocity vector is perpendicular to the B-field vector. What type of path will the particle travel? Neglect gravity A flexible coil 25 cm long is shaped into a circle with its face perpendicular to a 0.25 T magnetic field. If the coil is then pulled to collapse the area in 2.0 ms, what emf is induced in the coil? 5. A car antenna is 1.5 m long. The car...
In the arrangement shown, a conducting bar of negligible resistance slides along horizontal, parallel. friction less conducting rails connected as shown to a 2.0-ohm resistor. A uniform 1.5-T magnetic field is perpendicular to the plane of the paper. If L = 60 cm, at what rate is thermal energy being generated in the resistor at the instant the speed of the bar is equal to 4.2 m/s? 8.6 W 7.8 W 7.1 W 9.3 W 1.8 W An AC generator...
#16
A 22.0-cm-diameter coil consists of 28 turns of circular copper wire 2.6 mm in diameter. A uniform magnetic field, perpendicular to the plane of the coil, changes at a rate of 8.65 Times 10^-3 T/s. Determine the current in the loop, and the rate at which thermal energy is produced. A power line carrying a sinusoidally varying current with frequency f = 60 Hz and peak value I_0 = 55 kA runs at a height of 7.0 m across...
please help... Thanks in advance I appreciate your help
8 A magnetic field of 2.0 T is directed perpendicular to the face of a circular coil with a radius of 25.0 om. what is the magnetic flux linked with the coil2 © A single urciar loop of wire with radius ab.Dem is perpendicular to a magnetic field which increases from 1,5T to 48T in 23.0ms, what is the induced e. m.f in the coll? 0 A square coil (20.0 cm...
1) The armature of an ac generator is a rectangular coil 2.00 cm by 6.00 cm with 80 turns. It is immersed in a uniform magnetic field of magnitude 0.250 T. If the amplitude of the emf in the coil is 22.0 V, at what angular speed is the armature rotating? _______rad/s 2) The magnetic field between the poles of an electromagnet is 3.30 T. A coil of wire is placed in this region so that the field is parallel...