An open tank 1 meter in diameter and 1.5m in height is filled
with diesel oil (S.G = 0.85).
Assuming 75% of its capacity is occupied by the diesel, calculate
the pressure of the fluid
at the bottom of the tank.
An open tank 1 meter in diameter and 1.5m in height is filled with diesel oil...
An open tank 10m long by 1.5m wide by 1.5m deep is filled with oil (s = 0.80) to a depth of 1.20m. It is accelerated uniformly from rest to 15 m /sec. What is the shortest time in which the tank maybe accelerated without spilling any oil?
A 10 meter tall tank open to the air is filled with a fluid with a density of 1200 kg/m^3. It is located with its bottom 10 meters off the ground. When a hole is open at the bottom, fluid sprays out with an initial horizontal velocity. Determine this initial velocity.
A 10 Meter tall tank open to the air is filled with a fluid with a density of 1200 kg/m^3. It is located with its bottom 10 meters off the ground. When a hole is open at the bottom, fluid sprays out with an initial horizontal velocity. Determine how far (initially) the fluid sprays horizontally before it touches the ground.
A fluid of density 1300 kg/m3 flows out through a 3 meter diameter pipe without friction at a rate of 1500 L/s. Find the velocity of the fluid as it flows out of the 3 meter diameter pipe. Note that the 'speed' sensor does not give enough significant figures... use the sensor, to prove your calculations (and not the opposite!) Submit Answer Tries 0/99 Calculate the velocity of the fluid if the pipe constricts to a diameter of 1 meter....
4. A tank is filled with incompressible oil to a depth of (h) 6.43 m open tank The tank is being drained via a horizontal pipe that is attached at a height of (h2) 0.789 m above the tank bottom. Oil is flowing out of the tank into the pipe at a rate of 2.34 x 10 m'/s, but the tank is so large that the descent speed of the oil level at the top is negligible (0) The gauge...
A manometer is connected to a tank which is partly filled with oil
of specific gravity 0.8 as shown. The manometric fluid is mercury.
Calculate the pressure gauge reading if the barometric pressure is
75 cm of mercury.
AIR PRESSURE GAUGE Fig.1 2.25m 50cm
A tank is filled with incompressible oil to a depth of (h_1) 6.43 m. The tank is being drained via a horizontal pipe (radius 1.92 cm), attached at a height of (h-2) 0.789 m above the tank bottom. Oil is flowing out through the pipe at a rate of 2.34 times 10^-3 m^3/s, but the tank is so large that the descent speed of the oil level at the top is negligible (almostequalto 0). The gauge pressure in the drain...
(3 points) A tank of diameter D is filled with water up to a height h above the bottom of the tank (Figure 3). At the bottom of the tank is a hole of diameter d. Assume that the water flows out of the hole with a laminar flow and that the difference in atmospheric pressure between the top and the bottom of the tank is negligible. Figure 3: A tank draining (c) If you no longer assume that the...
Oil with a specific gravity of 0.80 forms a layer 0.90m deep in an open tank that is otherwise filled with water. The total depth of water and oil is 3m. What is the gage pressure at the bottom of the tank?
3. (3 points) A tank of diameter D is filled with water up to a height h above the bottom of the tank (Figure 3). At the bottom of the tank is a hole of diameter d. Assume that the water flows out of the hole with a laminar flow and that the difference in atmospheric pressure between the top and the bottom of the tank is negligible Figure 3: A lank draining a) What speed will the water have...