A DC current I passes through a resistor R (=100 Ohm). The LE in the resistance is 1%. The 0- 10 A ammeter has 1% of full-scale accuracy. The ammeter reads 8A. Calculate the LE of the DC power measurement in the resistor
A DC current I passes through a resistor R (=100 Ohm). The LE in the resistance...
A galvanometer with a coil resistance of 16.3 is used with a shunt resistor to make a nondigital ammeter that has an equivalent resistance of 0.817 . The current in the shunt resistor is 3.97 mA when the galvanometer reads full scale. Find the full-scale current of the galvanometer.
A dc milli ammeter has internal resistance Rm 45 deflection current Im 1.5 mA and a full scale Design a multi-range dc milli ammeter for a range 0-50 mA
9) The power p dissipated in a resistor of resistance R when a current i flows throw it is given by priʻR (see Lab-1). Write a C++ program that reads the resistance R (in ohms) and then outputs p for all i values between 0 and 5, inclusive, in intervals of 0.5 Amps. Use a for loop.
3. Use Superposition Theorem to solve for the current I through the 10-Ohm resistor. RSD I = 94() R$100 E 18 V
The current through a 50 ohm resistor is I = (0.80 A) sin(240t). What are (a) the current amplitude (maximum current) and (b) the rms current? (c) Id the resistor is replaced by a 10-micro F capacitor, what will be the capacitive resistance of the circuit?
10 Amps of DC current is passed through a 10 OHM resistor in thermal contact with an 6 g block of Arbitrarium. The temperature of the block is raised by 6 K by this process. What is the specific heat of Arbitrarium? Units J/gK
A voltmeter has an inner coil with a resistance (Rv) = 1000 ohm, and a series resistance (Rs) = 2000 ohms, an inductance ( L ) = 1 H, if the ammeter has an accuracy reading of a voltage of 200 Volts DC, calculate the reading at 200 Volts AC !
A 6.0 volt battery is connected to a 3.0 ohm resistor for 1 hour. A) Find the current through the resistor. B) Find the total charge that passes through the resistor. A) Find the power output of the battery in 22.1. B) Find the power used by the resistor in 22.1.
A 10 kilowatt 100 volt 1,000 rpm dc machine has an armature resistance of 0.09 ohm and is connected to a 100 V dc supply. 1.2.1 Determine the starting current and the rated current if no starting resistance is used in the armature circuit. 1.2.2 Determine the value of the starting resistance if the starting current is limited to twice the rated current. (1 mark)
what is the current going through the 2 ohm resistor 8. What is the current through the 2-12 resistor? 3.0 V 20 0 측 9.0V 60 0 b 바 a 40 0 3) For the circuit shown in the figure, calculate (6 points) a) Current in each resistor b) Voltage dropped at each resistor c) Power consumed at each resistor. 25Ω 구 58V 3.0V: 120Ω 74Ω 56Ω 110Ω