HomeworkLib
Question

What velocity of air would be required to draw toxic vapors into a duct 24 inches...

What velocity of air would be required to draw toxic vapors into a duct 24 inches away from a round duct with an airflow rate of 1,500 ft^3/min?

science   physics   
0 0
Add a comment Improve this question Transcribed image text
Next > < Previous
Sort answers by oldest

Homework Answers

Answer #1

0 0
Add a comment
Know the answer?
Add Answer to:
What velocity of air would be required to draw toxic vapors into a duct 24 inches...
Your Answer:

Post as a guest

Your Name:

What's your source?

Earn Coins

Coins can be redeemed for fabulous gifts.

Log In

Sign Up

Not the answer you're looking for? Ask your own homework help question. Our experts will answer your question WITHIN MINUTES for Free.
Similar Homework Help Questions

  • If the air in a 12-inch diameter duct with an air flow of 1,500 ft3/min and...

    If the air in a 12-inch diameter duct with an air flow of 1,500 ft3/min and a velocity of 14 ft/min flows into a 6-inch diameter duct, what are the new flow rate and velocity? What velocity of air would be required to draw toxic vapors into a duct 24 inches away from a 12 inch round duct with an air flow rate of 1,500 ft3/min? Compare the flow rates into a hood that needs to capture a contaminant at...

  • What is the volumetric flow rate for a 15” duct with a velocity pressure of 22” H2O? 1940 cfm&n...

    What is the volumetric flow rate for a 15” duct with a velocity pressure of 22” H2O? 1940 cfm    5249 fpm   4305 cfm    5428 cfm What is the capture velocity at a point that is located 18 inches away from, and directly in front of, the opening of a rectangular flanged hood with dimensions of 2 inches wide by 12 inches long when the air flow servicing the hood is 585 cfm. 34 fpm 145 fpm 150 fpm   160 fpm...

  • Chapter 08, Problem 044 A 3-ft-diameter duct is used to carry ventilating air = 2.373 x...

    Chapter 08, Problem 044 A 3-ft-diameter duct is used to carry ventilating air = 2.373 x 10- slugs/fr", v= 1.57 x 10 ft/s) into a vehicular tunnel at a rate of 8000 ft/min. Tests show that the pressure drop is 1.1 in. of water per 1500 ft of duct. What is (a) the value of the friction factor for this duct and (b) the approximate size of the equivalent roughness of the surface of the duct? Use this figure. (a)f=...

  • Part C In the spaces below perform the calculations requested that pertain to an air distribution...

    Part C In the spaces below perform the calculations requested that pertain to an air distribution system for a single family residence with a floor area of about 2,000 to 3,000 sq. ft. with an airflow of 1000cfm through the ducting, fan and HXs. Based on an air velocity of 15 ft/s, calculate the size of a square duct. Repeat for a rectangular duct with an aspect ratio of 2.0 ( width divided by height ). Also calculate the hydraulic...

  • A rectangular forced air heating duct is suspended from the ceiling of a basement whose air...

    A rectangular forced air heating duct is suspended from the ceiling of a basement whose air and walls are at a temperature of ∞T∞=Tsur= 5°C. The duct is 15 m long, and its cross section is 350 mm × 188 mm. (1) For an uninsulated duct whose average surface temperature is 50°C, estimate the rate of heat loss from the duct. The surface emissivity and convection coefficient are approximately 0.5 and 4 W/m2·K, respectively. (2) If heated air enters the...

  • Water at 20'C flows through a long elliptical duct 36 cm wide and 28 cm high. what average velocity, in m/s, would case the weight flow to be 560 ibf/s? Round the final answer to two decimal place...

    Water at 20'C flows through a long elliptical duct 36 cm wide and 28 cm high. what average velocity, in m/s, would case the weight flow to be 560 ibf/s? Round the final answer to two decimal places. Take the specific weight of water to be y=62.4 ibf/ft^3 and the value of pi as 22/7.

  • 4. Determine the number of filter bags required for an 8-compartment baghouse that uses pulse-jetting as...

    4. Determine the number of filter bags required for an 8-compartment baghouse that uses pulse-jetting as the method to remove particulate matter from the bags. The process gas exhaust rate is 100,000 ft/min and the recommended air-to-cloth ratio is 4 ft/min. The bags specified by the manufacturer have a diameter of 6 inches and height of 10 ft. (a) what is the total required fabric area? (ft)? (b) What number of bags is required? (c) How many bags are in...

  • A worker uses a computer monitor at a viewing distance of 20 inches (a) What would...

    A worker uses a computer monitor at a viewing distance of 20 inches (a) What would be the smallest possible height of the icons and characters on the computer monitor in order for a standard vision worker to see (20/20 vision)? Recall that Snellen defined standard vision as the ability to recognize a letter when the letter subtended 5 arc-min on the retina [6 pts) (b) If all work conditions remained the same, but the worker moved further away from...

  • What constant accelerationis required to increase the speed of a car from 24 mi/h to 59...

    What constant accelerationis required to increase the speed of a car from 24 mi/h to 59 mi/h in 3 seconds? (Round your answer to two decimal places.) A ft/s2 Enter a number.

  • Q1: Heated air at 1 atm, 100F, and 23% relative humidity is to be transported in...

    Q1: Heated air at 1 atm, 100F, and 23% relative humidity is to be transported in a 490 ft long circular plastic duct at a rate of 740 cfm (ft 3 /min). If the head loss in the duct is not to MEC_AMO_TEM_034_01 Page 1 of 8 Design of Thermal System (MECH 0009) - Spring-2020 -Assignment 2- A&B - QP exceed 790 in. of air, determine the minimum diameter of the duct. (Hint: initial guess value for the diameter is...

ADVERTISEMENT
Free Homework Help App
Download From Google Play
Scan Your Homework
to Get Instant Free Answers
Need Online Homework Help?
Ask a Question
Get Answers For Free
Most questions answered within 3 hours.
ADVERTISEMENT
ADVERTISEMENT