R1.73: In an experimental design, there are 8 machines that are run by 4 operators where the switching mechanism with 2 positions will be observed. What is the maximum number of factors in this experiment?
A. 4
B.3
C. 8
D. 2
There are three factors: machine, operator, and switching mechanism.
The answer is,
B. 3
R1.73: In an experimental design, there are 8 machines that are run by 4 operators where...
a bottle cap manufacturer with four machines and six operators wants to see if variation in production is due to the machines and/or the operators. each operator is assigned to each machine with the following analysis of variance table. ll Source sum of squares ll df ll mean square Machines 114 Operators 215 Error 54 Total 383 1. What are the degrees of freedom for the machines? 2. What are the degrees of freedom for the operators? 3. What are...
A plant has four operators to be assigned to four machines. The time (minutes) required by each worker to produce a product on each machine is shown in the following table: Machine (min) Operator A B C D 1 11 13 8 12 2 6 11 8 7 3 13 15 14 10 4 9 16 10 8 a. Formulate a linear programming model for this problem b. Solve it by using the computer. What is an optimal solution?
When comparing Tagucht's approach to the classical approach to experimental design, Taguchi addresses variation caused by noise by: a. b. c. d. Ignoring variation from noise Randomized experiment runs Including noise factors in the design matrix None of the above
Which of the following statements is incorrect. Select one: O a. Hermition operators do not give real eigenvalues O b. Eigenfunctions must go to zero as X goes to infinity O c. The Hamiltonian is a Hermitian operator O d. eigenfunctions of Hermitian operators with different eigenvalues are orthogonal e. As temperature increases, the wavelength corresponds to the maximum intensity in black body radiation shifts to lower wavelength For a particle in a box of length L and in state...
It takes 8 minutes to load and 6 minutes to unload a machine. Inspection, packing, and travel between machines totals 6 minutes. Machines run automatically for 40 minutes. Operators cost $30 per hour; machines cost $55 per hour. a. What is the maximum number of machines that can be assigned to an operator without creating machine idle time? b. What is the number of machines that minimizes the cost? c. If two machines are assigned to an operator, what will...
For a 2-Level design, with 8 factors, a recommended screening design model is: a. Taguchi L12 b. Full factorial c. Central Composite d. None of the above Guidelines indicate that a 2-Level, full factorial design should be used when the number of factors (k) is less than or equal to: a. 8 b. 5 c. 4 d. 10
6. Which experimental evidence would not support the SN2 mechanism for the reaction between (S)-2-bromooctane and sodium acetylide (aka ethynylsodium)? and is it the answer (A) Only (S)-3-methyl-1-nonyne is observed as a product. (B) The reaction rate decreases tenfold when the concentration of bromooctane is reduced from 1.0 M to 0.1 M (C) The reaction rate doubles when the concentration of sodum acetylide is doubled. (D) The rate of reaction is increased by switching from sodium to potassium acetylide.
Four different machines are being considered in an assembly plant. It is decided that 6 different operators are to be used in a randomized block experiment. The machines are assigned in a random order to each operator. The amount of time (in seconds) were recorded. Machine 1 2 3 4 5 6 1 42.5 39.3 39.6 39.9 42.9 43.6 2 39.8 40.1 40.5 42.3 42.5 43.1 3 40.2 40.5 41.3 43.4 44.2 45.1 4 41.3 422.0 43.5 442.0 45.9 42.3...
just need answers. not solutions
(8 pts) In an experiment design, the maximum value of variable 1' is 20 ma (milli corresponding to 7.2 ma? amps). and the minimum value is 4 ma. What is the dimensionless, scaled value of xi 2. (8 pts) A 4 factor, 2 level design of experiments will be used. How many experiments/trials will be run? 3. (8 pts) In an experiment, a process is modeled as y = ao + axi + ax2 +...
489: A six sigma green belt has run a 25-2 fractional factorial design. Only 2 of the 5 factors remained important after the factorial analysis. Escalation of this DOE to an optimization model will be best accomplished by: A. Performing a new full factorial of the 2 factors B. Performing a response surface experiment C. Decreasing the degrees of freedom of the original DOE D. Adding an additional factor level