what is the condition for equilibrium of a particle? if the weight of the mass hanger...

Question

Question

what is the condition for equilibrium of a particle?

if the weight of the mass hanger are all the same, can they be neglected? why or why not?

what was the cause of any possible error?

science physics

Answer 1

Answer #1

Answer 2

Similar Homework Help Questions

2. Why should you include the mass of the weight hanger and/or clamp in your calculations...

2. Why should you include the mass of the weight hanger and/or clamp in your calculations as part of the mass used
1.)In the static equilibrium experiment, a student placed the 107 g mass (including the hanger mass)...

1.)In the static equilibrium experiment, a student placed the 107 g mass (including the hanger mass) at position of 6.6 cm from the fulcrum. Then, placed a 52 g mass (including the hanger mass) on the right side of the fulcrum and adjusted the position until balance is achieved. Calculate the torque (magnitude only) caused by the 107 g mass. (g = 9.80 m/s2) 2.)In the static equilibrium experiment, a student placed the 105 g mass (including the hanger mass)...
6. When the system is in motion how does the acceleration of the hanger compare to...

6. When the system is in motion how does the acceleration of the hanger compare to the acceleration of the cart? (a) The acceleration of the hanger is equal to the acceleration of the cart. (b) The acceleration of the hanger is less than the acceleration of the cart. (c) The acceleration of the hanger is greater than the acceleration of the cart. (d) It depends on the trial. 7. When the system is in motion how does the tension...

In the static equilibrium experiment, a student placed the 114 g mass (including the hanger mass)...

In the static equilibrium experiment, a student placed the 114 g mass (including the hanger mass) at position of 5.3 cm from the fulcrum. Then, placed a 97 g mass (including the hanger mass) on the right side of the fulcrum and adjusted the position until balance is achieved. Calculate the torque (magnitude only) caused by the 97 g mass. (g = 9.80 m/s2)
A) String one has 20 g on its mass hanger and is located at an angular...

A) String one has 20 g on its mass hanger and is located at an angular position of q1= 0°. String two 40 g of mass on the mass hanger and is located at an angular position of q2= 180°. Is there a third string that can be added such that it brings the system into equilibrium if the angular position of this third string is not 0°or 180°? This system refers to the balancing of a force table. Support...
A student uses a weight hanger and string to apply 0.001 newton weights to a cup...

A student uses a weight hanger and string to apply 0.001 newton weights to a cup in the horizontal direction. if the cup is 3 newtons and takes 3 weights to cause motion what is the coefficient of static friction? -0.001 -0.009 -0.03 -0.1 -0.3

Table 4.2: Force and acceleration. kg Total mass of the system Mass on the hanger (kg)...

Table 4.2: Force and acceleration. kg Total mass of the system Mass on the hanger (kg) Net force on the system (N) Acceleration Trial 1 (m/s) Acceleration Trial 2 (m/s) Acceleration Trial 3 (m/s) Average acceleration (m/s) 0.685 0.612 0.655 0.005 0.883 0.857 0.009 0.861 0.948 0.928 0.927 0.013 1.34 1.42 1.43 0.023 1.67 1.77 1.75 0.043 Correlation: Intercept: Slope: MEASUREMENTS 1. Record the total mass of the hanging objects in the first column of Table 4.2. Calculate the weight...
the angular acceleration for the hanger mass (150 g) in the calculated and measured cases. Did...

the angular acceleration for the hanger mass (150 g) in the calculated and measured cases. Did these results agree within uncertainty? Explain your reasoning. Note: i don't need any formulas or anything. just general explanation of what would happen?
he length of a simple pendulum is 0.65 m and the mass of the particle (the...

he length of a simple pendulum is 0.65 m and the mass of the particle (the “bob”) at the end of the cable is 0.20 kg. The pendulum is pulled away from its equilibrium position by an angle of 7.7° and released from rest. Assume that friction can be neglected and that the resulting oscillatory motion is simple harmonic motion. (a) What is the angular frequency of the motion? (b) Using the position of the bob at its lowest point...

The length of a simple pendulum is 0.75 m and the mass of the particle (the...

The length of a simple pendulum is 0.75 m and the mass of the particle (the "bob") at the end of the cable is 0.33 kg. The pendulum is pulled away from its equilibrium position by an angle of 9.1° and released from rest. Assume that friction can be neglected and that the resulting oscillatory motion is simple harmonic motion. (a) What is the angular frequency of the motion? (b) Using the position of the bob at its lowest point...