
A hydrometer consists of a spherical bulb with a cylindrical stem (figure below). The cross-sectional area...
A hydrometer consists of a spherical bulb with a cylindricall stem (figure below). The cross-sectional area of the stem is 0.54 em2. The total volume of bulb and stem is 13.6 cm3. When immersed in water, the hydrometer floats with 8 em of the stem above the water surface. In alcohol, 1 em of the stem is above the surface. Find the density of alcohol. 8.0 cm 1.0 cm water Number Units
98 *°* When the hydrometer of Problem 48 (Figure 13-34) is placed in a liquid whose specific gravity is greater than some minimum value, the device floats with part of the glass tube above the liquid level. Consider a hydrometer that has a spherical bulb 2.4 cm in diameter. The glass tube attached to the bulb is 20 cm long and has a diameter of 7.5 mm. The mass of the hydrometer before lead pellets are dropped into the bulb...
30 in weighs 0.042 lbf in air. Consider the A hydrometer with a stem diameter following: 1) Determine the submerged volume (ft) when the hydrometer floats in water (y = 62.4 lbfift? Calculate the submerged volume (ft) when the hydrometer floats in ethylene glycol (SG = 1.12). Evaluate the height (in.) above the free surface where the 1.0 mark resides when the hydrometer floats in ethylene glycol. 111)
A hydrometer is an instrument used to determine liquid density. A simple one is sketched in the figure below. The bulb of a syringe is squeezed and released to let the atmosphere lift a sample of the liquid of interest into a tube containing a calibrated rod of known density. The rod, of length L and average density rho_0, floats partially immersed in the liquid of density rho. A length h of the rod protrudes above the surface of the...
A U-tube with a cross-sectional area of 1.00 cm2 is open to the atmosphere at both ends, Water is poured into the tube until the water rises part-way along the straight sides, and then 5.00 cm3 of oil is poured into one end. As a result, the top surface of the oil ends up 0.550 cm higher than the water surface on the other side of the U. What is the density of the oil?
A glass tube of cross sectional area 1.3 × 10 4m2 is partially filled with water. An oil with a density of 810 kg ms is slowly with the water and floats on top of it. The height of the oil above the water's surface is l 1 cn. oned into the tube so that does not mi (a) By how much does the pressure change at a depth of 14 cm below the water's surface after the oil s...
A container of cross-sectional area 112 cm2 contains liquid of density 1.85 g/cm3 to a height of 6.60 cm above a small hole of area 1.00 cm2 in the side=2
A cylindrical container with a cross-sectional area of 61.2 cm2 holds a fluid of density 816 kg/m3. At the bottom of the container the pressure is 120 kPa. Assume Pat = 101 kPa. Depth of the fluid = h=2.37m Find the pressure at the bottom of the container after an additional 2.05×10−3 m3 of this fluid is added to the container. Assume that no fluid spills out of the container.
Question 5: [Total 12.5 Marks] a) A cylindrical tank of depth 20 feet and cross-sectional area A of radius 5 feet full of water (density of water 62 lb/ft?). i. Calculate the work done using the following definite integral rule: (2.5) W *wAh. dh ii. What is the work done if the cylinder is only half full? (1.5) iii. Interpret your result of part (i) and part (ii). What did you conclude from these two results? (0.5) b) Using the...
Compare the floating of hydrometer in a diet cola with a regular
soft drink
How could the hydrometer be modified to increase
A large tub of ice and water holds cans of both regular and
diet pop. Some cans some don What can you surmise regarding their
content?
POST-LAB Questions 1. Compare the floating of a hydrometer in a diet cola with a regular soft drink. How could the hydrometer be modified to increase accuracy? A large tub of ice...