We need at least 10 more requests to produce the answer.
0 / 10 have requested this problem solution
The more requests, the faster the answer.
The floating Platform shown is supported at each corner by a hollow sealed cylinder 1 m...
A square wood platform of side-length ? = 2.4 m rests on masonry
walls. The deck of the platform is constructed of 4 cm thick planks
supported on two beams which are 2.4 m long. The beams have a width
of 100 mm and height of 150 mm and are supported at their ends by
the walls. The structure is designed to support a uniformly
distributed load, ?? (kN/m2), acting over the entire top surface of
the platform. The tensile...
Question 2 (25 marks) A square wood platform of side-length L = 2.4 m rests on masonry walls. The deck of the platform is constructed of 4 cm thick planks supported on two beams which are 2.4 m long. The beams have a width of 100 mm and height of 150 mm and are supported at their ends by the walls. The structure is designed to support a uniformly distributed load, wA (kN/m2), acting over the entire top surface of...
Large concrete cylindrical shells sealed at each end are to be used in the construction of an offshore oil drilling rig. These cylinders are floated out to the site and then uprighted to form part of the structure. The cylinders are 20m in diameter and, when floating in the horizontal position (axis horizontal), sink to a depth of 14m (that is, their height above water is 6m). What will be their height above water when erected? The cylinder length is...
EMERGENCY - Geotech plz help
A 2 m wide surface supported strip footing will be used to support a masonry bearing wall for a commercial building. The wall loading imposed onto the foundation will be 300 kN per meter of wall length. The soil under the foundation has a saturated unit weight of 20 kN/m”. If the water table is at the surface. what is the effective vertical stress at 2 m below the centre of the foundation when the...
A U-tube contains liquid of unknown density. An oil of density
770 kg/m³ is poured into one arm of the tube until the oil column
is 13.5 cm high. The oil-air interface is then 4.5 cm above the
liquid level in the other arm of the U-tube. Find the density of
the liquid.
A raft is made of 11 logs lashed together. Each is 38.0 cm in
diameter and has a length of 7.00 m. How many people (whole number)...
1. The mattress of a water bed has a length of 2.00 m, a width of 2.00 m and a depth of 30.0 cm. Find the weight of the water on the mattress and find the pressure exerted by the water on the floor when the bed is in its normal position. Assume that the entire lower part of the bed makes contact with the floor. The water in the mattress has a mass of: a) 1000 kg b) 1200...
i need help with my biology lab
Length 1 km = 1,000 m 1m = .001 km 1m = 100 cm 1 cm = .01 m Weight 1 kg = 1,000 1g-,001 kg 1g - 100 g 1 cg=.018 18 = 1,000 mg 1 mg = .001 g Volume 1 kL = 1,000 L 1L = .001 Ki 1L = 100 CL 1 cl = .01L 1 L = 1,000 mL 1 mL = .001 L 1 mm = .001...
please help ASAP
1.5-7 A hollow, brass circular pipe ABC (oce figure supports a load P, 118 kN acting at the top A second load P -98 kN is uaiformly distributed around the cap plate at B. The diameters and thicknesses of the upper and lower parts of the pipe are 31 mm ,,-12 mm, dae" 57 mm, and tac· 9 mm, respectively. The modulus of clasticity is 96 GPa. When both loads are fully applied, the wall thickness of...
1. Two metal beams are joined together by four rivets, Each rivet has a radius of 5.0*10^-3m and is to be exposed to a shearing stress of no more than 5.0*10^8. What is the maximum tension that can be applied to each beam, assuming that each rivet carries 1/4 the total load? 2. a 0.50 kg ball is attached to one end of an aluminum wire that has a diameter of 1.6mm and an unstretched length of 0.80 m. The...