Homework Answers
1) The density of dichloromethane is higher than that of the water and therefore, it will be in the bottom of aqueous phase. All other solvents ethyl acetate, hexane and diethyl ether are less denser that water therefore they will appear on the top.
2) The combination of solvent should be used is, c) dichloromethane/NaOH. As the the mixture contains carboxylic acid and a non acidic compound, after addition of NaOH the carboxylic acid will form a salt (sodium carboxylate) and will move from dichloromethane layer to NaOH layer. The non acidic compound however will still be in dichloromethane layer. This way we could separate acidic and non-acidic compound.
Add Answer to:
1)When you perform a liquid-liquid extraction using a separatory funnel, which of the following organic solvent...
(4pts) When you perform a liquid-liquid ext 17) which of the following organic solvent is on...
(4pts) When you perform a liquid-liquid ext 17) which of the following organic solvent is on the bottoming a extraction us which is on top? (write your answer by the solvent name p a) Ethyl acetate b) hexane c) Dichloromethane d) diethyl ether a liquid-liquid extraction and you have a 18) (3pts) If you are performing carboxylic acid and a non-acidic compound, which combinat you use for the separation? of solvents a) dichloromethane/HCI b) dichloromethane/methanol c) dicholoromethane/NaOH d) NaOH and...
1) during liquid liquid extraction ( LLE) it is normal to use separatory funnel, and two...
1) during liquid liquid extraction ( LLE) it is normal to use separatory funnel, and two non- miscible phases of solvents , for ex: water as polar phase and ethyl acetate is the organic phase. density of water is 1,0 g/ ml, while density of ethyl acetate is 0.90 g/ ml at 25.0 celsius degrees. which of the two solvents will end up at the buttom of the separatory funnel? 2) ) during liquid liquid extraction ( LLE) it is...
The density of dichloromethane, an organic solvent, is 1.325 g/cm. If you mix 50 mL water...
The density of dichloromethane, an organic solvent, is 1.325 g/cm. If you mix 50 mL water and 50 mL dichloromethane together in a separatory funnel, which layer would be on top? The density of diethyl ether, an organic solvent, is 0.706 g/cm. If you mix 50 mL water and 50 mL diethyl ether together in a separatory funnel, which layer would be on top?
Acid/Base Extraction 1. Provide a flow chart detailing the acid/base extraction/separation of the compounds shown below....
Acid/Base Extraction
1. Provide a flow chart detailing the acid/base
extraction/separation of the compounds shown below. Your answer
must employ the following reagents: methylene chloride,
hydrochloric acid (1M & 6M), sodium hydroxide (1M & 6M),
10% sodium bicarbonate (aq). Clearly indicate the product(s) and
layers formed following each step of your separation scheme.
IMPORTANT: p-cresol is soluble in sodium hydroxide solution but
insoluble in neutral water or sodium bicarbonate solution. 2-
ethylbenzoic acid is soluble in both sodium hydroxide and...
Answer the following before coming to lab: 1.) Based on what you saw last week, which...
Answer the following before coming to lab: 1.) Based on what you saw last week, which enantiomer of tartaric acid would you expect to co- crystallize with (SS)-1,2-diammoniumcyclohexane? 2.) If you had a neutral aqueous solution of triethylamine, would you add acid or base in order to extract it with an organic solvent? 3.) Now, consider a dichloromethane solution of triethylamine. Would you extract with acidic aqueous or basic aqueous solution in order to get the triethylamine out of the...
a) If choosing between Dichloromethane and diethyl ether for an extraction solvent, which presents the least...
a) If choosing between Dichloromethane and diethyl ether for an extraction solvent, which presents the least hazard to your health? b) If choosing between ethyl ether and dichloromethane for an extraction solvent, which is safer when considering flammability? c) Is benzoic acid a solid or liquid at room temperature?
Provide a flow chart detailing the acid/base extraction/separation of the compounds show below. Your answer must...
Provide a flow chart detailing the acid/base extraction/separation of the compounds show below. Your answer must employ the following reagents: methylene chloride, hydrochloric acid (1M & 6M), sodium hydroxide (1M & 6M), 10% sodium bicarbonate (aq). Clearly indicate the product(s) and layers formed following each step of your separation scheme. IMPORTANT: p-cresol is soluble in sodium hydroxide solution but insoluble in neutral water or sodium bicarbonate solution. 2-ethylbenzoic acid is soluble in both sodium hydroxide and sodium bicarbonate solutions. Use...
A) Extraction - when performing liquid - liquid extraction with a combination of an acidified aqueous...
A) Extraction - when performing liquid - liquid extraction with a combination of an acidified aqueous phase and an organic solvent; what phase would a basic compound (e.g., an amine; R-NH 2) prefer amongst the options below: 1- the basic compound will be ionised and prefer the organic phase 2- the basic compound will be nautral and end up in the organic phase 3- the basic compound will be ionised and prefer the acidic aqueous phase B) Extraction - when...
An experiment performed using solid to liquid extraction, liquid-liquid extraction, heating, and recrystallization to isolate caffeine,...
An experiment performed using solid to liquid extraction, liquid-liquid extraction, heating, and recrystallization to isolate caffeine, was not totally successful due to their being very little to no product of caffeine left when the time came to recrystallize the pure caffeine. During the experiment what could of caused there to be not enough caffeine to recrystallize it? ethyl acetate was used as the organic solvent hexane and acetone was used to recrystallize the crude caffeine, through mixture and boiling. Could...
The density of diethyl ether, an organic solvent, is 0.706g/cm3. If you mix 50 mL water...
The density of diethyl ether, an organic solvent, is 0.706g/cm3. If you mix 50 mL water and 50 mL diethylether together in a separatory funnel, which layer would be ontop?
(4pts) When you perform a liquid-liquid ext 17) which of the following organic solvent is on the bottoming a extraction us which is on top? (write your answer by the solvent name p a) Ethyl acetate b) hexane c) Dichloromethane d) diethyl ether a liquid-liquid extraction and you have a 18) (3pts) If you are performing carboxylic acid and a non-acidic compound, which combinat you use for the separation? of solvents a) dichloromethane/HCI b) dichloromethane/methanol c) dicholoromethane/NaOH d) NaOH and...
The density of dichloromethane, an organic solvent, is 1.325 g/cm. If you mix 50 mL water and 50 mL dichloromethane together in a separatory funnel, which layer would be on top? The density of diethyl ether, an organic solvent, is 0.706 g/cm. If you mix 50 mL water and 50 mL diethyl ether together in a separatory funnel, which layer would be on top?
Acid/Base Extraction
1. Provide a flow chart detailing the acid/base
extraction/separation of the compounds shown below. Your answer
must employ the following reagents: methylene chloride,
hydrochloric acid (1M & 6M), sodium hydroxide (1M & 6M),
10% sodium bicarbonate (aq). Clearly indicate the product(s) and
layers formed following each step of your separation scheme.
IMPORTANT: p-cresol is soluble in sodium hydroxide solution but
insoluble in neutral water or sodium bicarbonate solution. 2-
ethylbenzoic acid is soluble in both sodium hydroxide and...
Answer the following before coming to lab: 1.) Based on what you saw last week, which enantiomer of tartaric acid would you expect to co- crystallize with (SS)-1,2-diammoniumcyclohexane? 2.) If you had a neutral aqueous solution of triethylamine, would you add acid or base in order to extract it with an organic solvent? 3.) Now, consider a dichloromethane solution of triethylamine. Would you extract with acidic aqueous or basic aqueous solution in order to get the triethylamine out of the...
Provide a flow chart detailing the acid/base extraction/separation of the compounds show below. Your answer must employ the following reagents: methylene chloride, hydrochloric acid (1M & 6M), sodium hydroxide (1M & 6M), 10% sodium bicarbonate (aq). Clearly indicate the product(s) and layers formed following each step of your separation scheme. IMPORTANT: p-cresol is soluble in sodium hydroxide solution but insoluble in neutral water or sodium bicarbonate solution. 2-ethylbenzoic acid is soluble in both sodium hydroxide and sodium bicarbonate solutions. Use...
Most questions answered within 3 hours.
-
Where is the error in this code sequence?
String s1 = "Hello";
String s2 = "ello";...
asked 10 months ago -
Financial data for Joel de Paris, Inc., for last year
follow:
Joel de Paris, Inc.
Balance...
asked 10 months ago -
Consider this reaction:
Al2(SO4)3 (aq)+ BaCl3
(aq) Al2Cl6 (aq)- +
3BaSO4(s) . What is the...
asked 10 months ago -
Suppose that Savneet is considering increasing her
recent random sample from 20 car rentals to 40...
asked 10 months ago -
Trucks arrive at an unloading terminal at an average rate of 120
per hour.
Trucks arrive...
asked 10 months ago -
Why are methanol and ethanol completely soluble in water while
octanol is not very little soluble....
asked 10 months ago -
A facilities manager at a university reads in a research report
that the mean amount of...
asked 10 months ago -
When the CuSO4 is rehydrated by adding water to the anhydrous
compound, is this an endothermic...
asked 10 months ago -
A ray of sunlight is passing from diamond into crown glass; the
angle of incidence is...
asked 10 months ago -
A block of mass 0.249 kg is placed on top of a light, vertical
spring of...
asked 10 months ago -
how do the kidneys compensate in the presences of acidosis
a) trigger hyperventilate
b) reserve acid...
asked 10 months ago -
Question 501 pts
The rental rate of capital to the firm increases. Which of the
following...
asked 10 months ago