
On a hot day, the temperature of an 82893-L swimming pool increases by 1.6°C. What is...
On a hot day, the temperature of a 33,000 L swimming pool increases by 1.70°C. What is the net heat transfer (in J) during this heating? Ignore any complications, such as loss of water by evaporation. (Enter the magnitude.)
A swimming pool (dimensions: 50m x 2m50 x 16m) has a temperature of 20.00°C. Due to the evaporation of the surface water, this pool loses approximately 910.0 kJ/m2.h. To compensate for this loss, the water is heated by burning methane (CH4). Methane has a pressure of exactly 4 atm and a temperature of 20.00°C. What volume of methane should be burned? Answer [4911 l/h]
On a certain dry sunny day, a swimming pool’s temperature would rise by 2.465ºC if not for evaporation. What percent of the water must evaporate to carry away precisely enough energy to keep the temperature constant? Specific heat of water is 1.00 kcal/kgºC and the heat of vaporization is 580 kcal/kg.
Task 4 It is proposed that the shower facility at a new swimming pool will recover heat from flue of the central boiler to provide a small supply of hot water for the showers using a water-gas heat exchanger. The required water temperature is approximately 38 °C and the flow rate of water per shower is 15 litres per minute. Up to 20 showers will be in use at any one time. If water enters the facility at 15 °C...
T0.43 Chlorine is widely used to purify municipal water supplies and to treat swimming pool waters. Suppose that the volume of a particular sample of Cl2 gas is 8.50 L at 895 torr and 22 °C. Review I Constants I Peric At what temperature will the volume be 15.20L if the pressure is 875 torr? EV ΑΣφ T= K Submit Previous Answers Request Answer Incorrect; Try Again; One attempt remaining Part D At what pressure will the volume equal 6.70...
help me out please ...
2. The temperature of the water in a hot water cylinder is controlled by a two-position (on/off) temperature controller (thermostat). The following data was recorded for the hot water cylinder and heating system during a period of constant load: thermal capacitance of hot water cylinder.. .150 ki/C heat input (thermostat on.... heat loss (load ahd insulation losses)... 500 W desired operating temperature . dead band (neutral zon1-2°C For this period, determine: (a) The amplitude of...
system, hot water at an average temperature of 80°C is flowing through a 15-m section of a cast In a heating iron pipe (k 50 W/m K) whose inner and outer diameters are 4 cm and 5 cm, respectively. The outer surface of the pipe, whose emissivity is 0.75, is exposed to the cold air at 10°C in the basement. with a heat transfer coefficient of 15 W/m2.K. The heat transfer coefficient at the inner surface of the pipe is...
On a summer day, the air temperature is 36°C and the relative humidity is 20%. Water evaporates from the surface of a lake at a rate of 0.20 kg/h per square metre of water surface area. The temperature of water is 25°C. (a) Determine the mass transfer coefficient. (10 marks) (b) Determine the convective heat transfer coefficient. (10 marks) (c) Determine the net heat loss (in W/m2) from the lake. (5 marks) The specific volume of water vapour at 25°C...
On a hot dry day, evaporation from a lake has just enough heat transfer to balance the 1.00 kW/m2 of incoming heat from the Sun. What mass of water in kilograms evaporates in 1.99 h from each square meter? (Use the heat of vaporization for water at 37°C as an approximation in this problem.) ______kg
A geothermal aquifer supplies hot water at a temperature of 70 deg C at a flow rate of 10L/s. The hot water is used in a district heating system at a temperature of 40 deg C. It is assumed that all the thermal energy can be transferred through a heat exchanger. The geothermal aquifer is used 150 days each year. Calculate the amount of heat used for heating during the year. Calculate the amount of oil necessary to get the...