Question

n the Buble sheets for questions 016 to 041 using the words from the indicated Word Bank (WB1 or WB2) on the following page. Y ou can separate the page with the word banks on it, if you like) 016 wb1 is a fixed abrasive process, whileQ1 wb2 is a loose abrasive process 18 wbt grinding wheel bond is a common grinding grit material. Q19_wb2 is a type of In the sheet metal process called 20 wb1 springback is a significant concern. Q21 wb2 is a method used to compensate for springback. In the sheet metal process the workpiece gets significantly longer and thinner, but not much wider. In the sheet metal operation called Q23 wb2 wrinkling is a significant sheet metal operation called Q24 wbi the slug of material removed from considered scrap, whereas in the operation called product. The inside edge of a sheet metal bend experiences the concern. In the the sheet is the slug is the desired Q25 wb1 stresses, while 027 w2 stress conditions on the outside edge may induce metal tearing/cracking The thin section of metal that remains at the parting li forging is called ine of the dies in closed die Q28_wb2 In open die forging, causes the ends Q29_wb1 between the die and the workpiece of the workpiece to expand less than the middle, a phenomenon called w Hot forging takes place at a temperature that is higher than the 031 wb2 Q30 temperature. The small circles that can be seen on a part made by 032 wb2are indicators of the positions of the ejector pins. 3W is an example of the reinforcement material in a composite, while 034 wb1 is an example of the matrix material. Q33_wb1

Please answer all questions

Answer 1