Using MATLAB/OCTAVE and the Method of Moments (MoM), find the charge distribution on a cylindrical conductor whose radius is a=0.01m and length L=1m. The potential on the wire is V=1V. You may assume that the charge is distributed uniformly within each section. Assume that the number of the sections is N=5 and the step size is ΔL=0.2m.
COMPLETE IT IN MATLAB AND SUPPLY CODE.

Using MATLAB/OCTAVE and the Method of Moments (MoM), find the charge distribution on a cylindrical conductor...
4) A very LONG hollow cylindrical conducting shell (in electrostatic equilibrium) has an inner radius R1 and an outer radius R2 with a total charge -5Q distributed uniformly on its surfaces. Asume the length of the hollow conducting cylinder is "L" and L>R1 and L>> R2 The inside of the hollow cylindrical conducting shell (r < R1) is filled with nonconducting gel with a total charge QGEL distributed as ρ-Po*r' ( where po through out the N'L.Rİ volume a) Find...
Consider a cylindrical capacitor like that shown in Fig. 24.6. Let d = rb − ra be the spacing between the inner and outer conductors. (a) Let the radii of the two conductors be only slightly different, so that d << ra. Show that the result derived in Example 24.4 (Section 24.1) for the capacitance of a cylindrical capacitor then reduces to Eq. (24.2), the equation for the capacitance of a parallel-plate capacitor, with A being the surface area of...
Solve problem 2 and 3 with details . Thank you
Notre Dame University-Louaize Faculty of Natural& Applied Sciences Department of Physics& Astronomy PHS 212-Electridity & Magnetism Fall 2018 Final Exam (22Dec18, 120min) Closed-book, Closed-notes, Close-everything Exam List in detail any assumptions that you make. Show all your work. You can use a calcalater Useful Constants: e1.6x 10C, charge of 1 electron k-8.9875x10 Nm/C2 mass of 1 electron: 9.11 x 10 kg 1. Three point charges, q +15 C, q +35...
summatize the following info and break them into differeng key points. write them in yojr own words
apartus
6.1 Introduction—The design of a successful hot box appa- ratus is influenced by many factors. Before beginning the design of an apparatus meeting this standard, the designer shall review the discussion on the limitations and accuracy, Section 13, discussions of the energy flows in a hot box, Annex A2, the metering box wall loss flow, Annex A3, and flanking loss, Annex...