Question

A high-rise is being planned and your company provided the most advantageous bid to the owner, as a contractor in the design build partnership the initial massing concept takes the chillers, boilers, and cooling towers lines all around the perimeter of the structure. Where would you place chillers, boilers, and cooling towers? Why? What problems can be anticipated with the location you suggest? What problems can be anticipated with installing the lines all around the perimeter of the structure, where would you suggest to install the lines, and why?

Answer 1

Answer:-

Chillers, cooling tower and siphons are the fundamental segment of the focal cooling plant of an elevated structure. Chiller and cooling tower are utilized to cool the water by separating the warmth from the water, while kettle is utilized to warm up the water. Area of these segments assumes a significant job in elevated structures and is portray as under.

Chiller: chiller should be found either in storm cellar or on rooftop; the area relies on the kind of chiller to be utilized, on the off chance that the chillers are situated in cellar, then they are of water cooled type and if there are situated at rooftop they are generally air cooled sort of chillers. The capacity of the two sorts of chillers is to produce the cool water for cooling of the structure.

Kettle: evaporator should be utilized for warming the water; the area of the heater in the structure is essentially at the rooftop.

Cooling tower:

The cooling tower are situated at the top of the structure, these are units which goes about as the last goal for the undesirable warmth in the structure. This unit contains a fan which is associated with condenser pipe which transmits warmed water to the cooling tower; this water is then showered noticeable all around stream.

Therefore we accept that we use water cooled type chiller consequently the area for chiller is expected in storm cellar, heater and cooling tower area is expected at rooftop.

For chiller in the storm cellar, ascent of temperature in encompassing and exacting support prerequisite are a portion of the problems that can be experienced.

Installing lines for this framework at the border of the structure can be of no utilization, as the different units like chillers, heater and cooling tower needs unique area for installation, by installing the lines at the edge of the structure can expand the general expense of the cooling framework in the structure and likewise the water voyaging time from various units of the framework will be more and pointless.

Suggestion, the lines should be introduced vertically in the structure according to plan prerequisite of the cooling framework; there must not be any extra funneling other than units' association.

At last the lines should be introduced under the cooling framework involving territory and not at the entire edge of the structure.

Please like the answer......