
Please write the answer for this in a clear way.
MORE WILL BE THE LENGTH OF CABLE (RS 232) , MORE WILL BE THE CAPACITANCE IN IT
THEREFORE THE TRANSMISSION RATE WILL BE LOW DUE TO PRESENCE OF CAPACITANCE
THE TOTAL CAPACITANCE OF THE CABLE SHOULD NOT BE MORE THAN 2500 PICOFARAD
Please write the answer for this in a clear way. 3. In a standard serial connection...
Please help. Thanks
Question 3 [15 marks] In an electric power system, it is given that the effective impedance of the generator station is Rs = 2000, and the effective impedance of the substation is R1 = 300 2. The line is I = 250 km long, and the source rms voltage is Vs = 45 kV operating at frequency f = 60 Hz. You are tasked to design the transmission line connection from the main station to the substation...
please clear hand writing or typing and clear steps
some tutors write in a way that I can't understand what is the
info
Answer all parts Discuss the use of hydrogen as a replacement for fossil fuels under the following headings: The problem with the fuels currently being used. [7 marks] Methods of producing hydrogen and ways of using it as an energy source. [10 marks] is the use of hydrogen as a fuel a solution to the worlds energy...
*** PLEASE WRITE WITH
CLEAR HAND WRITING AND TAKE CLEAR PICTURES****** ALSO PLEASE DOUBLE
CHECK YOUR WORK****** WRITE YOUR FINAL ANSWER IN A BOX WITH CLEAR
UNITS***********
(Use R = 49.5 ohm and C = 30.6 uF)
2. A capacitor is connected in series with a resistor and the connection coupled to the tereminals of a 230 V, 50 Hz voltage source. Calculate the component voltages. ( 208.1 -252' V, 98.0 64.8" V) -25.2P v,
please write the answer shortly and clear handwriting,
I Will rate the answer.
please answer as clear as possible. thank you
3. (2) You are comparing the DNA from a particular gene from two populations of rabbits, the East and West populations. In the East population there is a deletion of 50 nucleotides somewhere within the transcribed region of the gene. When you compare mRNA from the two populations, they are the same length and there is no difference in the protein. Where must this mutation be located and why doesn't it affect...
Could someone please explain the concept of "shepherd's lema" in a clear way? Also, could you provide an example to further illustrate what it is? Also, please write legibly. I don't mean to be rude, but part of the reason why I'm asking this is the last person who answered my question did so through handwriting I couldn't clearly read, so I didn't actually understand the answer. If you write down the answer please be sure your writing is very...
**** PLEASE WRITE WITH CLEAR HAND WRITING AND TAKE CLEAR PICTURES****** ALSO PLEASE DOUBLE CHECK YOUR WORK****** WRITE YOUR FINAL ANSWER IN A BOX WITH CLEAR UNITS************ Four positive charges are placed on the corners of a square and the length of the side is 1.0 m and the magnitude of those charges is +4.0 nC. Calculate or determine the electric field IE (both the magnitude and direction) a) at the ceneter of a square, b) at the center of...
Please answer part #3 of the problem. Yes, there is a way to
solve part #3 please help
Determine forces in the cable AC and strut AB using 3 different approaches 1) forces. Write equilibrium equations in x and y direction. 2) sines. 3) reaction at B (use trig definition and Pythagoras theorem). Sum moments about A to find remaining reaction at C. Sum moments about C to check that equilibrium holds. Draw FBD of A. Use vector decomposition of...
*** PLEASE WRITE WITH
CLEAR HAND WRITING AND TAKE CLEAR PICTURES****** ALSO PLEASE DOUBLE
CHECK YOUR WORK****** WRITE YOUR FINAL ANSWER IN A BOX WITH CLEAR
UNITS************
A square shaped loop (edge length 40 cm, N 20 and I 8.0 A) can rotate with respect to the axis passing through the center of the opposite sides. In the initial situation, the loop is in such a position that the 550 mT field is parallel to the loop plane and the...
please answer in clear writing
Personnel and Safety Management - Due Dec 3, 2019 8:00 AM Construction Mgmt A CET/BR - MGMT-10127-02 1.Why does construction sites have a high rate of injuries and fatalities 2.Are construction firms required to create and implement a safety and health program and what are the key elements?