Homework Answers
Add Answer to:
5. For the crude clove oil that contains eugenol and acetyl eugenol, draw the expected TLC...
5. Suppose you obtained 0.55 g of crude clove oil from 7.0 g of fresh cloves....
5. Suppose you obtained 0.55 g of crude clove oil from 7.0 g of fresh cloves. The eugenol content in this crude sample you obtained was determined to be 89% by using some technique. What was the percentage of pure eugenol in this sample of cloves?
1. Eugenol (clove oil) has a reported boiling point of 255° C at 760 mm Hg....
1. Eugenol (clove oil) has a reported boiling point of 255° C at 760 mm Hg. When making a determination of the boiling point at reduced pressures during vacuum distillations, a nomography chart can be used o determine the corrected boiling point. What would be the boiling point of Eugenol at 25 mm Hg? NOMOGRAPH 2. Aliquid mixture contains two substances whose boiling points are only 10°C apart. Which method of distillation should be utilized to obtain a clean separation...
need work and answers IlI. Preparation of Synthetic Eugenol (10 pts) Eugenol, the main component of clove oil, can be prepared from heating 2-allyl guaiacol (in the absence of oxygen) to tempera...
need work and answers
IlI. Preparation of Synthetic Eugenol (10 pts) Eugenol, the main component of clove oil, can be prepared from heating 2-allyl guaiacol (in the absence of oxygen) to temperatures>205 °C. In practice, however, it is most cost effective to extract eugenol from cloves, its natural source. Given a weight percentage of eugenol in cloves at-15%, calculate the minimum mass of cloves one needs to obtain 1.00 g of eugenol as product? Report your answer below. Show your...
A student monitored the reaction progress of the reduction of 4-Nitrobenzaldehyde to 4-Nitrobenzyl alcohol using TLC....
A student monitored the reaction progress of the reduction of
4-Nitrobenzaldehyde to 4-Nitrobenzyl alcohol using TLC. 30% ethyl
acetate in petroleum ether was used as the elution solvent. TLC
plates available in the laboratory were coated with the common
absorbent silica gel (SiO2.xH2O) which
contains polar hydroxyl (OH-) groups.
c. The crude product moves slower
than the starting material with the mobile
phase in the TLC plate. Briefly
explain a possible reason for the
observation based on the chemical
structures...
4. Predict the TLC behavior to be expected from the three Anacin components (aspirin, caffeine, and...
4. Predict the TLC behavior to be expected from the three Anacin components (aspirin, caffeine, and 1,4-dimethoxybenzene). Assume you spot a plate with three standard solutions, each containing one of the components. Sketch what you expect the developed TLC plate to look like and identify which compound is which spot. 5. Draw a picture of the test tube with the prepared solution of the model compound and the prepared buffer and the beam of the UV spectrometer beam passing through...
CAN SOMONE PLEASE HELP. above is a picture of two TLC plates with spots on them....
CAN SOMONE PLEASE HELP. above is a picture of two TLC plates
with spots on them. could somone PLEASE PLEASE PLEASE help me get
their measurmentS (in milimeters) and help me calculate their Rf
values!!! I promise to rate u good if you could help!!! Im so
confused!!! THANK U SM
-solvent front scluent front Acetaminophen (A Afine (caf) Unknown mixture Phenacetin (Phn) Salicyamide (sal) Plate 2 Untuan unknown ixture mixture duplicate spots Plate 1 ASSIGNMENT In this experiment, TLC...
Please help 2. Consider the TLC plate shown below that was done on silica gel using...
Please help
2. Consider the TLC plate shown below that was done on silica gel using a solvent mixture of 4:1 hexane/EtoAc as the eluent. 4:1 Hexane:EtOAC marked solvent front Spot B Spot A A origin (a) Which of the two organic compounds labeled A and B is less polar? (b) Calculate the Rf value of compound B. (c) How would the following changes affect the Rf values of A and B? i. Change to a more polar solvent mixture...
need work and answers IlI. Preparation of Synthetic Eugenol (10 pts) Eugenol, the main component of...
need work and answers
IlI. Preparation of Synthetic Eugenol (10 pts) Eugenol, the main component of clove oil, can be prepared from heating 2-allyl guaiacol (in the absence of oxygen) to temperatures>205 °C. In practice, however, it is most cost effective to extract eugenol from cloves, its natural source. Given a weight percentage of eugenol in cloves at-15%, calculate the minimum mass of cloves one needs to obtain 1.00 g of eugenol as product? Report your answer below. Show your...
HEDGING (10 Marks) Part A (5 Marks) An oil refiner purchases ·crude oil, which it then...
HEDGING (10 Marks) Part A (5 Marks) An oil refiner purchases ·crude oil, which it then refines (i.e. processes) into finished products like gasoline and diesel. Does the refiner have a long or short exposure to crude oil? How about gasoline (i.e. long or short_ exposure)? What hedging positions would the refiner take with respect to crude oil and gasoline if it wants to increase the certainty of its cash flows? Part B (5 Marks) CanTruck, a Canadian truck manufacturer,...
can you please answer all 1. When you run a TLC of the reaction in ethyl...
can
you please answer all
1. When you run a TLC of the reaction in ethyl acetate : hexanes :: 1:1, the plate below is produced. Give a solvent system that would be expected to produce greater separation and a BRIEF (8 words) justification about your choice. (5 points) 9 10 8 7 LLLLLLL 6 5 4 001 2 3 b. Calculate the R for the bottom spot. (5 points) c. Which compound on the TLC plate is the most...
1. Eugenol (clove oil) has a reported boiling point of 255° C at 760 mm Hg. When making a determination of the boiling point at reduced pressures during vacuum distillations, a nomography chart can be used o determine the corrected boiling point. What would be the boiling point of Eugenol at 25 mm Hg? NOMOGRAPH 2. Aliquid mixture contains two substances whose boiling points are only 10°C apart. Which method of distillation should be utilized to obtain a clean separation...
need work and answers
IlI. Preparation of Synthetic Eugenol (10 pts) Eugenol, the main component of clove oil, can be prepared from heating 2-allyl guaiacol (in the absence of oxygen) to temperatures>205 °C. In practice, however, it is most cost effective to extract eugenol from cloves, its natural source. Given a weight percentage of eugenol in cloves at-15%, calculate the minimum mass of cloves one needs to obtain 1.00 g of eugenol as product? Report your answer below. Show your...
A student monitored the reaction progress of the reduction of
4-Nitrobenzaldehyde to 4-Nitrobenzyl alcohol using TLC. 30% ethyl
acetate in petroleum ether was used as the elution solvent. TLC
plates available in the laboratory were coated with the common
absorbent silica gel (SiO2.xH2O) which
contains polar hydroxyl (OH-) groups.
c. The crude product moves slower
than the starting material with the mobile
phase in the TLC plate. Briefly
explain a possible reason for the
observation based on the chemical
structures...
4. Predict the TLC behavior to be expected from the three Anacin components (aspirin, caffeine, and 1,4-dimethoxybenzene). Assume you spot a plate with three standard solutions, each containing one of the components. Sketch what you expect the developed TLC plate to look like and identify which compound is which spot. 5. Draw a picture of the test tube with the prepared solution of the model compound and the prepared buffer and the beam of the UV spectrometer beam passing through...
CAN SOMONE PLEASE HELP. above is a picture of two TLC plates
with spots on them. could somone PLEASE PLEASE PLEASE help me get
their measurmentS (in milimeters) and help me calculate their Rf
values!!! I promise to rate u good if you could help!!! Im so
confused!!! THANK U SM
-solvent front scluent front Acetaminophen (A Afine (caf) Unknown mixture Phenacetin (Phn) Salicyamide (sal) Plate 2 Untuan unknown ixture mixture duplicate spots Plate 1 ASSIGNMENT In this experiment, TLC...
Please help
2. Consider the TLC plate shown below that was done on silica gel using a solvent mixture of 4:1 hexane/EtoAc as the eluent. 4:1 Hexane:EtOAC marked solvent front Spot B Spot A A origin (a) Which of the two organic compounds labeled A and B is less polar? (b) Calculate the Rf value of compound B. (c) How would the following changes affect the Rf values of A and B? i. Change to a more polar solvent mixture...
need work and answers
IlI. Preparation of Synthetic Eugenol (10 pts) Eugenol, the main component of clove oil, can be prepared from heating 2-allyl guaiacol (in the absence of oxygen) to temperatures>205 °C. In practice, however, it is most cost effective to extract eugenol from cloves, its natural source. Given a weight percentage of eugenol in cloves at-15%, calculate the minimum mass of cloves one needs to obtain 1.00 g of eugenol as product? Report your answer below. Show your...
can
you please answer all
1. When you run a TLC of the reaction in ethyl acetate : hexanes :: 1:1, the plate below is produced. Give a solvent system that would be expected to produce greater separation and a BRIEF (8 words) justification about your choice. (5 points) 9 10 8 7 LLLLLLL 6 5 4 001 2 3 b. Calculate the R for the bottom spot. (5 points) c. Which compound on the TLC plate is the most...
Most questions answered within 3 hours.
-
Where is the error in this code sequence?
String s1 = "Hello";
String s2 = "ello";...
asked 10 months ago -
Financial data for Joel de Paris, Inc., for last year
follow:
Joel de Paris, Inc.
Balance...
asked 10 months ago -
Consider this reaction:
Al2(SO4)3 (aq)+ BaCl3
(aq) Al2Cl6 (aq)- +
3BaSO4(s) . What is the...
asked 10 months ago -
Suppose that Savneet is considering increasing her
recent random sample from 20 car rentals to 40...
asked 10 months ago -
Trucks arrive at an unloading terminal at an average rate of 120
per hour.
Trucks arrive...
asked 10 months ago -
Why are methanol and ethanol completely soluble in water while
octanol is not very little soluble....
asked 10 months ago -
A facilities manager at a university reads in a research report
that the mean amount of...
asked 10 months ago -
When the CuSO4 is rehydrated by adding water to the anhydrous
compound, is this an endothermic...
asked 10 months ago -
A ray of sunlight is passing from diamond into crown glass; the
angle of incidence is...
asked 10 months ago -
A block of mass 0.249 kg is placed on top of a light, vertical
spring of...
asked 10 months ago -
how do the kidneys compensate in the presences of acidosis
a) trigger hyperventilate
b) reserve acid...
asked 10 months ago -
Question 501 pts
The rental rate of capital to the firm increases. Which of the
following...
asked 10 months ago