A 12 liter volume of oil is subjected to pressure which produces
a volume strain of −3.0×10−4 . The bulk modulus of the oil is
6.0×109Paand is independent of the pressure.
In situation above, the change in the pressure of the oil, in atm,
is closest to:
| 18 atm |
| 16 atm |
| 12 atm |
| 14 atm |
| 20 atm |
delta P = -B * deltaV/V
deltaV/V = -3 x 10^-4
B = 6 x 10^9
deltaP = 1.8 x 10^6 pa = 17.8 atm = 18 atm
A 12 liter volume of oil is subjected to pressure which produces a volume strain of...
A 12-L volume of oil is subjected to pressure which produces a volume strain of-30 104 The bulk modulus of the olil 9 Pa and is independent of the pressure. The change in the pressure of the oil in megapascals is closest to O 1.2 MPa O 1.4 MPa e 1.6 MP O 1.8 MPa 曲2.0 MPa QUESTION 5 A 120-kg refrigerator that is 2.0 m tall and 85 cm wide has its center of mass at its geometrical center....
#1 please answer asap!!!!
1) A specimen of oil having an initial volume of 600 cm3 is subjected to a pressure increase of 3.6x106 Pa, and the volume is found to decrease by 0.45 cm3. a - 6pts) What is the bulk modulus of the material? b - 4 pts) What is the compressibility of the material?
1) A specimen of oil having an initial volume of 600 cm3 is subjected to a pressure increase of 3.6x106 Pa, and the...
Q1. A circular rod of 12 mm diameter was tested for tension. The total elongation on a 300 mm length was 0.22 mm under a tensile load of 17 KN. Find the value of E. (2.5 Marks) Answer: Q2. A prismatic bar has a cross section of 25 mm x 50 mm and a length of 2m under an axial force of 90 KN. The measured elongation of the bar is 1.5 mm. Compute the tensile stress and strain in...
which brother is taking which oil and which oil contains a large percentage of odd-numbered fatty acids. What is a critical physiological consequence of this difference? (Hint: Before answering this question, consider answers to previous questions and the important molecules that connect metabolic pathways) The oil consumed by Dave (from the flathead (striped) mullet Mugil cephalus) contained: 11% - 16:0 5% - 16:1∆7 15% - 18:1∆9 36% - 20, 22, or 24 carbon ω-3 or ω-6 fatty acids 25% - ...
finish all of them and show process
(g) What is the volume of the oil displaced by the block, in terms of the variables of the problem? Vo= Problem 2 - Pressure and Buoyancy with Oil and Water You have a block of a light wood that is 10 cm by 10 cm by 10 cm. You also have a bucket that you fill with a depth of 20 cm of water (has a density of 1000 kg/m'), and then...
xperiment 2 Record the pairs of data for pressure (atm) and volume (mL), 2 Points Experiment Data Volume 1/Volume (mL) X-axis Pressure (atm) Y-axis (mL) 150 130 1/150-0.0067 1/130-0.0077 1.00 1.15 L30 I/ 10 /10 D.DIII 14 3.00 Law, pressure is inversely proportional to volume 1. Prepare a graph of the data, with [1/volume] (units-1/mL) on the X-axis and pressure (atm) on the Y-axis. 2. Click the graphing tool in the Latenite Lab assignment section. 3 Points 3. Draw a...
Question 12 (1 point) Saved Suppose a small island near the Middle East produces oil, which is extracted from the ground, and olive oil, from all of the olives grown on the island. The information in the following table shows the amount of oil, olive oil, and olives produced in 2008, 2018, and 2019. Calculate real GDP for 2019 using 2008 as the base year for the calculations. Provide your answer in dollars rounded to two decimal places. Do not...
Question 20 1 points Saved The following is the torque versus angle of twist diagram for a 0.75 inch diameter steel bar tested in torsion. The gage length of the bar is 3 inches. The angle of rotation and torque at points and Pare (0.8 radian, 1500 in-Ib) and (11.3 radian, 4000 in-lb) respectively. The power-law curve fitting relation for the data above the yield point is given by T-329800.21, where is in in-Ib and is in radian. Torque T...
37. Which of the following pairs does NOT exhibit a direct relationship? A pressure and volume D. all are direct B. pressure and temperatureC. volume and temperature 38. Determine what the pressur is inside of a 15.0L container holding 3.5 moles of H gas at 298.15 . E. 5.7 atm D. 1.4 atm A. 4.8 atm C. 86 atm 8.110 atm 39. If volume and the amount of gas within a container remains constant, what will happen to the pressure...
Identify the material. that fits the stress-strain
curve.
A)
MILD STEEL
Yield Strength: 30 kN, Ultimate Strength: 40 kN, Young Modulus:
30/0.7 kN/mm = 43 kN/mm
B)
ALUMINUM
Yield Strength: 20 kN, Ultimate Strength: 26 kN, Young Modulus:
20 kN/mm
C)
CAST IRON
Yield Strength: N/A, Ultimate Strength: 20 kN, Young Modulus:
20/0.4 kN/mm = 50 kN/mm
D)
COPPER
Yield Strength: 30 kN, Ultimate Strength: 35 kN, Young Modulus:
30 kN/mm
Instructions CLI Tesile TesTeR Test Specimens Material - Mild...