Question

In MPLS, if two packets arrive in order going to the same IP address, MPLS will...

In MPLS, if two packets arrive in order going to the same IP address, MPLS will ________.

send the second on doing a simple cache lookup

go through the entire routing process for the second packet

do a simple table lookup for the second packet

none of the above

0 0
Add a comment Improve this question Transcribed image text
Answer #1


c)

do a simple table lookup for the second packet

Add a comment
Know the answer?
Add Answer to:
In MPLS, if two packets arrive in order going to the same IP address, MPLS will...
Your Answer:

Post as a guest

Your Name:

What's your source?

Earn Coins

Coins can be redeemed for fabulous gifts.

Not the answer you're looking for? Ask your own homework help question. Our experts will answer your question WITHIN MINUTES for Free.
Similar Homework Help Questions
  • 1. To which of the following subnets does IP address 225.3.2.22 belong? 225.3.2.0/24 225.3.2.22/24 225.2.3.0/24 225.0.0.0/24...

    1. To which of the following subnets does IP address 225.3.2.22 belong? 225.3.2.0/24 225.3.2.22/24 225.2.3.0/24 225.0.0.0/24 none of the above Question 2 On which of the following devices does the transport layer NOT run? laptop router cellphone A, B and C none of the above Question 3 What is the source address contained in the discover message sent by a host that is wanting to obtain an IP address? 255.255.255.255 0.0.0.0 the IP address of the server the last IP...

  • Refer to the network figure above, showing two Ethernet Subnets connected through an IP Router, for questions #1, #2 and #3. For each device, both its Internet Protocol (IP) address and its MAC addre...

    Refer to the network figure above, showing two Ethernet Subnets connected through an IP Router, for questions #1, #2 and #3. For each device, both its Internet Protocol (IP) address and its MAC address (also called the Physical address or the Ethernet address) are shown. The Subnet Mask used by all devices is 255.255.255.192 (which is same as prefix length “/26”). (5 points) Assuming that Client #1 sent a packet to Client #3 and then Client #3 sent a packet...

  • At this stage, you should be a Wireshark expert. Thus, we are not going to spell...

    At this stage, you should be a Wireshark expert. Thus, we are not going to spell out the steps as explicitly as in earlier labs. In particular, we are not going to provide example screenshots for all the steps. 1.   Start capturing packets in Wireshark and then do something that will cause your host to send and receive several UDP packets (Note that DNS is using UDP for communications. You can use nslookup commands in Lab 4 to generate DNS...

  • An IP address is a 32-bit number that uniquely identifies a host (computer or other device,...

    An IP address is a 32-bit number that uniquely identifies a host (computer or other device, such as a printer or router) on a TCP/IP network. IP addresses are normally expressed in dotted-decimal format, with four numbers separated by periods, such as 192.168.123.132. To understand how subnet masks are used to distinguish be- tween hosts, networks, and subnetworks, examine an IP address in binary notation. For example, the dotted-decimal IP address 192.168.123.132 is (in binary notation) the 32 bit num-...

  • construction of a physical address, page tables are stored in a special cache calied a A....

    construction of a physical address, page tables are stored in a special cache calied a A. Page translation lookup table 8 Translation look aside buffer C. Set associative address cache D. Page table associative block A system that uses virtual addresses contains a special 1P block to construct and manage address A. Memory Management Unit B. Rapid Address Constructor Unit ALU bypass Address Generator D. All the above E. None of the above peripheral devices connected to the ARM are...

  • QUESTION 1 "A single router is transmitting packets, each of length L bits, over a single...

    QUESTION 1 "A single router is transmitting packets, each of length L bits, over a single link with transmission rate R Mbps to another router at the other end of the link. Suppose that the packet length is L= 12000 bits, and that the link transmission rate along the link to router on the right is R = 1000 Mbps. What is the maximum number of packets per second that can be transmitted by the link (use a whole number)?"...

  • Q1 Error detection/correction Can these schemes correct bit errors: Internet checksums, two-dimendional parity, cyclic...

    Q1 Error detection/correction Can these schemes correct bit errors: Internet checksums, two-dimendional parity, cyclic redundancy check (CRC) A. Yes, No, No B. No, Yes, Yes c. No, Yes, No D. No, No, Yes E. Ho, hum, ha Q2 CRC vs Internet checksums Which of these is not true? A. CRC's are commonly used at the link layer B. CRC's can detect any bit error of up to r bits with an r-bit EDC. c. CRC's are more resilient to bursty...

  • check my answers for Networking I came up with these answers, can check my answers Question...

    check my answers for Networking I came up with these answers, can check my answers Question 1: General What data rate is needed to transmit an uncompressed 4" x 6" photograph every second with a resolution of 1200 dots per inch and 24 bits per dot (pixel)? 691,200 kb/s 28.8 kb/s 8.29 Mb/s 829 Mb/s Question 2: Layering "Layering" is commonly used in computer networks because (check all that apply): -It forces all network software to be written in ‘C’....

  • can you please help me with this homework. DCOM 101 – Introduction to Data Communications Final Project Instructions: In this Final Project, you will test the skills and knowledge gained throughout th...

    can you please help me with this homework. DCOM 101 – Introduction to Data Communications Final Project Instructions: In this Final Project, you will test the skills and knowledge gained throughout this course. The steps listed below are loosely based on the Assignments you have completed thus far, so don’t hesitate to look back and use those resources. Follow the steps in each section, and paste screenshots when prompted. This assignment is worth 10% of your final grade. Basic Network...

  • 166 Chapter 8: TCP/IP Applications Getting Down to Business The way network communication all those ls...

    166 Chapter 8: TCP/IP Applications Getting Down to Business The way network communication all those ls and Os) goes in and out of a machine physically is through the NIC (network interface card). The way network communication goes in and out of a machine logically though, is through a program or service. A service is a program that runs in the background, independent of a logon, that provides functionalities to a system. Windows client machines, for instance, have a Workstation...

ADVERTISEMENT
Free Homework Help App
Download From Google Play
Scan Your Homework
to Get Instant Free Answers
Need Online Homework Help?
Ask a Question
Get Answers For Free
Most questions answered within 3 hours.
ADVERTISEMENT
ADVERTISEMENT