Water flows from a tank located above the ground through a pipe to the turbine and then flows out of the turbine to a process unit that is lower than the turbine. with a rate of 3600 tons / h and the electric power generated from the turbine rotation is 1000hp. If the turbine is 90% efficient?
Water flows from a tank located above the ground through a pipe to the turbine and...
1) Water at "standard" conditions flows from the tank through a 6" schedule 40 pipe of length Land drains into an open reservoir at a rate of 500 gal min1. The water in the tank is h 10 m above the open end of the pipe. With all other conditions the same, we replace the 6" pipe with an 8" pipe. What is the new flowrate, Q lgal min']? (assume entrance losses and kinetic energy are negligible.) - -0 Gven...
Single pipe with turbine) Water drains from a pressurized tank through a pipe system as shown in the figure below. The head of the turbine is equal to 116 m. If entrance effects are negligible, determine the flowrate. 50 kPa e 200 m, D 0.1 m -0.0010 m Valve (K1 -5.0) 200 m Turbine 90 elbows (K 1.0) 0-L :0389 m3/s
Water at 27℃ flows from a storage tank through 170 m of a steel pipe with an internal diameter of 154 mm. Taking the energy loss due to friction into account, calculate the required head h above the pipe inlet to produce a volume flow rate of 70.8 L/s.
Question in the picture
smooth pipe: Total length, L Diameter, d -25 mm 4 m tank water (pa 1,000 kg/m3, μ 0.001 kg/ms) flows from a very large tank (that is open to atmosphere) through an L 4 m total length of smooth pipe of d = 25 mm diameter at a bulk velocity of 6 m/s. The water then exits the pipe at 3 m above ground as a free jet. The pipe network contains a gate valve (V),...
water 248 m 945 ml 2 Water Pipe GENERATOR TURBINE 1) A dam in somewhere with a height of 248 m, is one of the tallest dam in the world. Water flows with a volumetric flow rate of 65 m'ls to a turbine, where electric power is generated. The total irreversible head los in the piping system from point 1 to point 2 (excluding the turbine unit) is determined to be 95 m. The pressure difference due to elevation cannot...
Unit Operation and Fluid Homework.
Please help!
4. Water is circulated from a large tank through a pipe made of steel and back to the tank as shown in the following figure. The inner diameter of the pipe is 0.03m. The suction line is 20m long, and the discharge line is 40m long. The power output of the pump is 300W, and the pump's efficiency is 75%. The vapor pressure of water is 2300Pa. (a) Use the info in the...
A 45%-efficient hydro turbine/generator is located 100ft below a water source. If water is taken from the source at 200gal/min through a 3-in PVC pipe and there is 800 ft of pipe, 4. Find the power delivered by the generator. What diameter pipe would be needed to keep the flow speed around 5 ft/sec or less? a. b.
Water flows from the upper tank to the lower tank through a cast iron pipe of total length L-1100 ft through one half-closed gate valve, four regular 90° flanged elbows, and entrance/exit as shown. For 2 cases with the same pipe perimeter P 12 in., compute the volume flow rate (ft /s) through: circular pipe of diameter D, and equilateral triangular pipe with each side a. a) b) Note that the flow areas and hydraulic diameters will be different. Find...
A Review Water in the reservoir flows through the 8-in.-diameter pipe at A into the turbine as shown in (Figure 1). Part A If the discharge at B is 600 ft/min, determine the power output of the turbine. Assume the turbine runs with an efficiency of 50%. Neglect frictional losses in the pipe. Express your answer using three significant figures. O AL "vec oi? Wout = hp Figure < 1 of 1 Submit Request Answer Provide Feedback Next > 36...
Water flows steadily from a large tank as shown in the figure. The height of water in the tank is H = 4 m represents the height from the centerline of the horizontal pipe to the surface of the water in the tank. The water flows out of the tank through a pipe with diameter of 4 cm. The stream of water flows through a bend (= 30 degrees, L = 2.88 m) and exits as a free jet through...