The volume of an empty flask with a one-holed stopper was 285 ml (V1). You heated...
The volume of an empty flask with a one-holed stopper was 285 ml (V1). You heated the flask for 1 minute (T1) and then cooled it in a 22.0°C water reservoir (T2). A volume of 85.0 mL of water was drawn into the flask as the air in the flask cooled (V2 = V1-85.0mL).
a. What was the temperature of the hot air in the flask?
b. What is the value of Charles’ Law constant for the experiment above? k = V1/T1 (that's k = v1 over T1))
Homework Answers
Add Answer to:
The volume of an empty flask with a one-holed stopper was 285 ml
(V1). You heated...
1) A weather balloon filled with He gas to a volume of 262 L on a...
1) A weather balloon filled with He gas to a volume of 262 L on a day when the temperature was 18°C. The balloon was only released the next day when the temperature was -10°C. Calculate the new volume of the weather balloon. Assume that the atmospheric pressure remained the same on both days. 2) The volume of an empty flask with a one-holed stopper was 285 ml (V1). You heated the flask for 1 minute (T1) and then cooled...
In Discussion #1, you calculated the volume of gas that your explosive would produce if 1...
In Discussion #1, you calculated the volume of gas that your explosive would produce if 1 g of it was used, assuming standard temperature and pressure (STP)and any water produced in the gaseous state. Is this actually accurate, as the gas is usually heated as a result of the explosion, resulting in a much larger volume of gas? But what temperature will the gas reach? Calculate the final volume of the gas produced from 1.00 g of your explosive using...
please answer number 8 thank you 3 Fastan a ctanp at the top of the flask...
please
answer number 8
thank you
3 Fastan a ctanp at the top of the flask and position it as the stopper assembily securely into the Rask Fils the water bath wt heat the water bath unu 5 With the stoppock open to the air with the red arms positioned verticallwater n the water while heating a stopper in the sink and fw it with cold water Close the stopoock (wilth the red ama positioned horizontally) and turn a Transfer...
Charles' Law (help with 2 and 4 please) thank you! Calculate the percent error, when comparing...
Charles' Law (help with 2 and 4 please)
thank you!
Calculate the percent error, when comparing your experimental final volume to your calculated theoretical final volume. Show all calculations. Percent error = vf=194.87 MI b) List some sources of error that you might have made in this experiment. & Thononggonaffecha anthehoren can causing #bantiepachtleeruder different. There has to be constant pressure, the air inside con be too cooled, which con case the flost to implode. 1. Repeat the calculations in...
In a collision of sufficient force, automobile air bags respond by electrically triggering the ex...
In a collision of sufficient force, automobile air bags respond
by electrically triggering the explosive decomposition of sodium
azide (NaN3) to its elements. A 43.398 g sample of
sodium azide was decomposed, and the nitrogen gas generated was
collected over water at 22°C. The total pressure was 798.8 mmHg.
How many liters of dry N2 were generated?
An atmospheric chemist studying the pollutant SO2
places a mixture of SO2 and O2 in a1.14 L
container at 825.7 K and 2.3...
i dont understand why the molecular weight i calculated (42.012 g/mol) for my unknown liquid (acetone)...
i dont understand why the molecular weight i calculated
(42.012 g/mol) for my unknown liquid (acetone) is less than the
actual molecular weight (58.08 g/mol). what errors could i have
made in my lab that would account for the difference.
Molecular Weight of a Volatile Liquid In this experiment, an amount of liquid more than sufficient to fill the flask when vaporized is placed in a flask of measured volume and mass. The flask is then heated in a boiling...
Help? Q2) In a collision of sufficient force, automobile air bags respond by electrically trigger...
Help?
Q2) In a collision of sufficient force, automobile air bags
respond by electrically triggering the explosive decomposition of
sodium azide (NaN3) to its elements. A 43.398 g sample
of sodium azide was decomposed, and the nitrogen gas generated was
collected over water at 22°C. The total pressure was 798.8 mmHg.
How many liters of dry N2 were generated?
Q3) An atmospheric chemist studying the pollutant SO2
places a mixture of SO2 and O2 in a1.14 L
container at 825.7...
please find the purpse, Discussion, conclusion un 27 Phoenix June 20 8:10 PM a 35AEXPERIMENT 35A...
please find the purpse, Discussion, conclusion
un 27 Phoenix June 20 8:10 PM a 35AEXPERIMENT 35A Triphenylmethanol PROCEDURE ether MgBr+ C-OH + MgBr(OH) OMgBr 0 Addct Addition of Benzophenone While the phenylmagnesium bromide solution is being heated and stirred under reflux, make a solution of 1.09 g benzophenone in 2 mL of anhrudrous ether in a 5-mL conical vial. Cap the vial until the reflux period is over. Once the Grignard reagent is cooled to room temperature, draw some of...
With the data given, help on the calculations please - Tes Name Determination of the Gas...
With the data given, help on the calculations please
- Tes Name Determination of the Gas Constant, R, and the Purity of KCIO, Data Unknown number or letter Mass of test tube and iron (IIT) oxide 44.5928 Mass of test tube, iron (III) oxide and sample 44.979 8 Mass of test tube and contents after heating 44.8488 Volume of water displaced Barometric pressure 976 mbar Temperature of water temperature of O, 23 Vapor pressure of water at this temperature 21.068_mm...
Please answer all the blanks (volume if H2 and everything in analysis). TIA! Data 5 1...
Please answer all the blanks (volume if H2 and
everything in analysis). TIA!
Data 5 1 oong 0.00 10.5ml 2 o.olag 0.00 11.0 Trial 3 o.org 0.00 12.00 o Daag o.albg 0.00 10.0 ml 11.5ml Mass of Mg (g) Initial volume of Syringe (mL) Final volume of Syringe (mL) Volume of H (mL) Barometric pressure (torr) Ambient temperature (°C) Vapor pressure of H2O (torr) 779.314har 23. Oi 21.0 forr TA.314tar 23.0c 179.3 14ton 23.0¢ 779.314 ton 23.0c 779.31472 23.0c 21.0...
please
answer number 8
thank you
3 Fastan a ctanp at the top of the flask and position it as the stopper assembily securely into the Rask Fils the water bath wt heat the water bath unu 5 With the stoppock open to the air with the red arms positioned verticallwater n the water while heating a stopper in the sink and fw it with cold water Close the stopoock (wilth the red ama positioned horizontally) and turn a Transfer...
Charles' Law (help with 2 and 4 please)
thank you!
Calculate the percent error, when comparing your experimental final volume to your calculated theoretical final volume. Show all calculations. Percent error = vf=194.87 MI b) List some sources of error that you might have made in this experiment. & Thononggonaffecha anthehoren can causing #bantiepachtleeruder different. There has to be constant pressure, the air inside con be too cooled, which con case the flost to implode. 1. Repeat the calculations in...
In a collision of sufficient force, automobile air bags respond
by electrically triggering the explosive decomposition of sodium
azide (NaN3) to its elements. A 43.398 g sample of
sodium azide was decomposed, and the nitrogen gas generated was
collected over water at 22°C. The total pressure was 798.8 mmHg.
How many liters of dry N2 were generated?
An atmospheric chemist studying the pollutant SO2
places a mixture of SO2 and O2 in a1.14 L
container at 825.7 K and 2.3...
i dont understand why the molecular weight i calculated
(42.012 g/mol) for my unknown liquid (acetone) is less than the
actual molecular weight (58.08 g/mol). what errors could i have
made in my lab that would account for the difference.
Molecular Weight of a Volatile Liquid In this experiment, an amount of liquid more than sufficient to fill the flask when vaporized is placed in a flask of measured volume and mass. The flask is then heated in a boiling...
Help?
Q2) In a collision of sufficient force, automobile air bags
respond by electrically triggering the explosive decomposition of
sodium azide (NaN3) to its elements. A 43.398 g sample
of sodium azide was decomposed, and the nitrogen gas generated was
collected over water at 22°C. The total pressure was 798.8 mmHg.
How many liters of dry N2 were generated?
Q3) An atmospheric chemist studying the pollutant SO2
places a mixture of SO2 and O2 in a1.14 L
container at 825.7...
please find the purpse, Discussion, conclusion
un 27 Phoenix June 20 8:10 PM a 35AEXPERIMENT 35A Triphenylmethanol PROCEDURE ether MgBr+ C-OH + MgBr(OH) OMgBr 0 Addct Addition of Benzophenone While the phenylmagnesium bromide solution is being heated and stirred under reflux, make a solution of 1.09 g benzophenone in 2 mL of anhrudrous ether in a 5-mL conical vial. Cap the vial until the reflux period is over. Once the Grignard reagent is cooled to room temperature, draw some of...
With the data given, help on the calculations please
- Tes Name Determination of the Gas Constant, R, and the Purity of KCIO, Data Unknown number or letter Mass of test tube and iron (IIT) oxide 44.5928 Mass of test tube, iron (III) oxide and sample 44.979 8 Mass of test tube and contents after heating 44.8488 Volume of water displaced Barometric pressure 976 mbar Temperature of water temperature of O, 23 Vapor pressure of water at this temperature 21.068_mm...
Please answer all the blanks (volume if H2 and
everything in analysis). TIA!
Data 5 1 oong 0.00 10.5ml 2 o.olag 0.00 11.0 Trial 3 o.org 0.00 12.00 o Daag o.albg 0.00 10.0 ml 11.5ml Mass of Mg (g) Initial volume of Syringe (mL) Final volume of Syringe (mL) Volume of H (mL) Barometric pressure (torr) Ambient temperature (°C) Vapor pressure of H2O (torr) 779.314har 23. Oi 21.0 forr TA.314tar 23.0c 179.3 14ton 23.0¢ 779.314 ton 23.0c 779.31472 23.0c 21.0...
Most questions answered within 3 hours.
-
Where is the error in this code sequence?
String s1 = "Hello";
String s2 = "ello";...
asked 10 months ago -
Financial data for Joel de Paris, Inc., for last year
follow:
Joel de Paris, Inc.
Balance...
asked 10 months ago -
Consider this reaction:
Al2(SO4)3 (aq)+ BaCl3
(aq) Al2Cl6 (aq)- +
3BaSO4(s) . What is the...
asked 10 months ago -
Suppose that Savneet is considering increasing her
recent random sample from 20 car rentals to 40...
asked 10 months ago -
Trucks arrive at an unloading terminal at an average rate of 120
per hour.
Trucks arrive...
asked 10 months ago -
Why are methanol and ethanol completely soluble in water while
octanol is not very little soluble....
asked 10 months ago -
A facilities manager at a university reads in a research report
that the mean amount of...
asked 10 months ago -
When the CuSO4 is rehydrated by adding water to the anhydrous
compound, is this an endothermic...
asked 10 months ago -
A ray of sunlight is passing from diamond into crown glass; the
angle of incidence is...
asked 10 months ago -
A block of mass 0.249 kg is placed on top of a light, vertical
spring of...
asked 10 months ago -
how do the kidneys compensate in the presences of acidosis
a) trigger hyperventilate
b) reserve acid...
asked 10 months ago -
Question 501 pts
The rental rate of capital to the firm increases. Which of the
following...
asked 10 months ago