Question

Could you please write the equation and plot the cosine graph containing the following features:

(Please show four periods)

(Fo is frequency while theta is phase shift)

A 170 V fo 50 Hz θ 120°

0 0
Add a comment Improve this question Transcribed image text
Answer #1

eruohon Voltage, 그 下-3 2 go rt うう+ o 3.33 18.33 0 8.33 28.33 0

Add a comment
Know the answer?
Add Answer to:
Could you please write the equation and plot the cosine graph containing the following features: (Please...
Your Answer:

Post as a guest

Your Name:

What's your source?

Earn Coins

Coins can be redeemed for fabulous gifts.

Not the answer you're looking for? Ask your own homework help question. Our experts will answer your question WITHIN MINUTES for Free.
Similar Homework Help Questions
  • please show all steps The graph of one complete period of a cosine curve is given....

    please show all steps The graph of one complete period of a cosine curve is given. (a) Find the amplitude, period, and horizontal shift. (Assume the absolute value of the horizontal shift is less than the period.) amplitude period horizontal shift (b) Write an equation that represents the curve in the form y = a cos((x - b)).

  • Could you please plot its graph? A hollow spherical conductor, carrying a net charge +Q. has...

    Could you please plot its graph? A hollow spherical conductor, carrying a net charge +Q. has inner radius r_1 and outer radius r_1 = 2r_1 (see the figure. At the center of the sphere is a point charge +Q/2. Plot V as a function of r from r 0 to r = 2r_2. Assume V_0 = 3Q/8 pi r_2.

  • Rs 100Ω resistor C- 10 uF capacitor L- 120 mH inductor Write the impedance Z [Q] equation for the...

    Rs 100Ω resistor C- 10 uF capacitor L- 120 mH inductor Write the impedance Z [Q] equation for the circuit shown in Figure 1. This formula should be in term of the frequency (f), not for angular frequency (). (using MATLAB) 1. From the above formula, plot power factor versus frequency over the frequency range 0 Hz to 1000 Hz. You may use a MATLAB program to do the plotting. 2. Find the frequencies for; Maximum power factor, Minimum power...

  • please show steps 5. GH(s) is a minimum-phase system which has the Bode plot shown below. It is desired to increase the phase margin by 40 degrees and also increase the closed-loop system bandwidth....

    please show steps 5. GH(s) is a minimum-phase system which has the Bode plot shown below. It is desired to increase the phase margin by 40 degrees and also increase the closed-loop system bandwidth. Design a lead compensator for this purpose. Determine (1) the ratio of the pole to the zero, α , (2) the frequency where the maximum phase shift from the compensator should be placed, and then (3) the pole and zero. You need not draw the Bode...

  • In Lab 2, you learned - various plotting techniques - how to create an exponentially faded...

    In Lab 2, you learned - various plotting techniques - how to create an exponentially faded version of a given sinusoidal signal. In this assignment, you will be working with two sinusoidal signals. The higher-frequency signal c(t) = cos(2*pi*F*t) (where F is in Hertz) will be referred to as "carrier"; while the lower-frequency signal v(t) = 1.5 + cos(2*pi*f*t + q) (f in Hz, again) will be referred to as "envelope". Note that the envelope has a positive offset of...

  • Please help me write the commands 2) Plot a graph that describes the following texting plan...

    Please help me write the commands 2) Plot a graph that describes the following texting plan You pay $40 for the first 1500 text messages. After the first 1500 messages, you pay 45 cents per text. Draw a graph for messages between 0 and 3000 messages. (Write your commands and sketch your graph)

  • Please show detailed work and write clearly. Thank you. 6. A four-pole squirrel-cage motor has the...

    Please show detailed work and write clearly. Thank you. 6. A four-pole squirrel-cage motor has the following characteristics: Power input at a rated load is 5200 W with a power factor of 0.70. Rated speed is 1150 rpm. Resistance of each stator windings (there are three) is Rs-: 0.195 Ω. . The motor is supplied by a three-phase source with a line-to-line voltage of 460 V and a frequency of 50 Hz. The windings of the motor have a Y-connection....

  • Please use the equation sheet. Write neat please. Draw a picture please (draw forces (FBD))Please show...

    Please use the equation sheet. Write neat please. Draw a picture please (draw forces (FBD))Please show how you got the equation. Show step by step please. Box in answers please. Note: thermal expansion in (°C) gasses in (K) pressure in (pa) and volume in (m³) Dis PlocMut Equations for Physics 201 Some important algebraic equations: re) ditch啤a a x +bx +C 0 -btyb2-4ac (a+b)z=a2 + b2 + 2 a b 2a Chapter 2 V+V SPlacomn 2 9 9.8 m/s2 0...

  • Could you please help solve this question. The following generator supplying rated load into a large...

    Could you please help solve this question. The following generator supplying rated load into a large grid at rated voltage (11kV) and 0.85 PF lagging Generator: 20 MVA, X = j15%. Voltage 11kV i) Determine the internal generator voltage. ii) The load suddenly drops to 50% rated power. If the rotating energy of the generator and its associated turbine is 2.0 p.u-seconds when running at its synchronous speed. It has 2 poles and system frequency is 50 Hz. Determine: (ii-a)...

  • soooo completely lost, please show your work thank you :-) (2nd attempt, unfortunately could not read...

    soooo completely lost, please show your work thank you :-) (2nd attempt, unfortunately could not read first's tutor handwriting) Record in Table 2 the measured values of t(v) and (U) at the three frequencies Table 2 Measured values of t(Ux) and (U) at the three frequencies (L = 3.3 mH, C = 0,39 uF, R = 100 2 ) f = 1000 Hz f = f(theory) f = 8000 Hz 1x) (8) (0) 3. Data from Measurements #1 to #3...

ADVERTISEMENT
Free Homework Help App
Download From Google Play
Scan Your Homework
to Get Instant Free Answers
Need Online Homework Help?
Ask a Question
Get Answers For Free
Most questions answered within 3 hours.
ADVERTISEMENT
ADVERTISEMENT