Draw a program on the rungs below that uses a timer functions to turn a coil on for 500ms and then off for 500ms in a repeating process.
Draw a program on the rungs below that uses a timer functions to turn a coil...
Draw a program on the rungs below that uses a timer function. When a NO contact (I-0) is closed a coil is energized and stays energized for 10 seconds. Clearly indicate which timer function was used and what inputs and preset values were used.
Draw a program on the rungs below for the motor controller from the previous problem. When a NO contact (I-0) is closed the motor rotates in the “forward” direction, and when a different NO contact (I-1) is closed the motor rotates in the “reverse” direction. If both contacts are closed at the same time the motor should do nothing.
PLC 7. Given a temperature control application where if the temperature at a sensor becomes closed when the temperature is below 55°F. Use a 15 minute timer/delay relay to keep the heater coil on once the temperature is below 55° F. Write a ladder logic program to achieve this. Temp switch Timer 15 min Keep output high for 15 min once activated Heater Coil Turn on to increase temperature Closed if <55 F
PLC 7. Given a temperature control application...
Draw a compact ladder logic diagram for an XOR function on the rungs below using only contacts and coils.
Draw a state diagram of the AC/Heater controller described below It has a switch to turn it on or off; A user can select either program P1 or program P2 and can switch from one to another; P1(68F for heat and 78F for cool) and P2( 66F for heat and 76F for cool); There is a sensor for measuring the room temperature; If the controller is set to program P1 and the room temperature <68, then the heater is turned...
6. Consid shown in the discharge pump to show when they are on and off. er the ladder program shown. The graph below shows a 35 second interval of e run switch is closed at 5 seconds and opened back up at 25 seconds as graph. On the graph, add a line for the heat coil, stir motor, and RUN SWITCH T4:2 HEAT COIL STIR MOTOR Timer On Delay Timer Time Base T4:2 1.0 10 TOF Timer Off Delay Timer...
i would like a C++ program please
Write a program using void functions to draw a house by printing characters to the screen. . Your main should look like below Printintersectingo: Ildraw the roof • PrintHorizontalo: f/draw the base of the roof . PrintParallell) draw the sides of the house . PrintHorizontali): /draw the base of the house Hint: Use void functions Writo function that calculatos tho standard deviation of 3 intogor young and
Please show in PLC programming or draw out ladder rungs
A PLC controls five sets of stage lights for an auditorium. For one particular stage production, the various acts and scenes require six different lighting sequences, each involving a different combination of the five light sets. The stagehand in charge of lighting has a control panel that controls the PLC. There are two switches on the panel: STEP a momentary N/O pushbutton switch that makes the PLC step to the...
Using Omron relay and a small 5 VDC motor, construct a circuit to turn the motor ON or OFF by applying a voltage to the coil leads of the relay. Draw a schematic of the circuit below.
Write a latter logic program that will: a) Turn OUT.1.0 on while IN.2.0 or IN.2.1 is on, but only if IN.2.2 is off at the same time. b) Turn OUT.1.1 on each time the conditions for turning OUT.1.0 on becoming true, but OUT.1.1 must remain on even if those conditions cease to be true. c) Turn OUT.1.0 back of again each time IN.2.3 goes on. The conditions for turning OUT.1.1 on must override the conditions for turning OUT.1.1 off if...