Question 12 (1 point)
For a bus-type switching fabric, what factor mainly limits the switching speed?
Question 12 options:
|
a. memory bandwidth |
|
|
b. bus bandwidth |
|
|
c. CPU speed |
|
|
d. hard-drive RPM |
Question 13 (1 point)
The datagram network does not rely on call set up in the network layer.
Question 13 options:
| True | |
| False |
Question 14 (1 point)
The Internet service model is "best effort" with no guarantees of bandwidth, loss, and ordering.
Question 14 options:
| True | |
| False |
Question 15 (1 point)
Virtual circuit routers maintain connection state information for switching.
Question 15 options:
| True | |
| False |
Question 16 (1 point)
For a virtual circuit, the number assigned to that virtual circuit can be changed on each link.
Question 16 options:
| True | |
| False |
Question 17 (1 point)
What is the data unit exchanged in the network layer?
Question 17 options:
|
a. frame |
|
|
b. datagram |
|
|
c. segment |
|
|
d. message |
Question 18 (1 point)
Each router has a forwarding table (or tables).
Question 18 options:
| True | |
| False |
Question 19 (1 point)
Which of the following is unlikely to be one of the key components of a router?
Question 19 options:
|
a. input port module |
|
|
b. output port module |
|
|
c. error detection module |
|
|
d. switching fabric |
Answers)
12.b
13. True
14. False
15. False
16. True
17. Frame
18. True
19. Error detection module
Question 12 (1 point) For a bus-type switching fabric, what factor mainly limits the switching speed?...
a)
b)
c)
This chapter ("data plane") is all about forwarding packets at a router. Check all the statements that apply to Forwarding: Forwarding tables are computed by the control plane, in software. Forwarding tables are typically stored at every input port of a router. Forwarding tables are typically stored at every output port of a router. Forwarding tables are stored in the switching fabric. Destination-based forwarding means that we use the destination address of an IP datagram, to look...
1. To which of the following subnets does IP address 225.3.2.22 belong? 225.3.2.0/24 225.3.2.22/24 225.2.3.0/24 225.0.0.0/24 none of the above Question 2 On which of the following devices does the transport layer NOT run? laptop router cellphone A, B and C none of the above Question 3 What is the source address contained in the discover message sent by a host that is wanting to obtain an IP address? 255.255.255.255 0.0.0.0 the IP address of the server the last IP...
I need the answer
I
need the answer
i nned the answer
QUESTION 1 A good routing path means choosing the fastest path between the sender and receiver if and only if it is the least cost and congested. True False QUESTION 2 There are two approaches to structuring network control planes, which are per-router control (traditional) and logically centralized control (software defined networking). True False in the network layer, the data plane identifies: The way they get processed inside...
Please answer me as soon as possible Quiz Question 1 (1 point) Saved What metric is used to measure bandwidth? Question 1 options: a. msec b. bit/sec c. bytes d. number of packets/sec Question 2 (1 point) Saved Ethernet is one of access network technologies. Question 2 options: True False Question 3 (1 point) Saved Consider two hosts, A and B, connected by a single link of rate R bps. Suppose that the two hosts are separated by m meters,...
2) IP and MAC addressing. True or False. One point for each correct answer, zero points for each incorrect answer. Many of the questions refer to the following network consisting of three 10Mbps Ethernet segments, one switch, and one router. Assume all ARP tables are up-to-date unless otherwise stated. a) Consider a network consisting of Ethernets, hubs, switches, and routers. Suppose one of the hubs is replaced with a switch. Then the network administrator must redefine some IP addresses. True...
EXPLAIN in details why is it true or false. need to be 100%
POSTIVE OF ANSWER. SOLVE D E F G H I J
2) (10 points) IP and MAC addressing. True or False. Circle True or False. One point for each correct answer, zero points for each incorrect answer. Many of the questions refer the folowing network consisting of three 10Mbps Ethernet segments, one switch, and one router. Assume all ΛΕΡ tables are up-to-date unless otherwise stated Switch Ronter...
Q1 Error detection/correction Can these schemes correct bit errors: Internet checksums, two-dimendional parity, cyclic redundancy check (CRC) A. Yes, No, No B. No, Yes, Yes c. No, Yes, No D. No, No, Yes E. Ho, hum, ha Q2 CRC vs Internet checksums Which of these is not true? A. CRC's are commonly used at the link layer B. CRC's can detect any bit error of up to r bits with an r-bit EDC. c. CRC's are more resilient to bursty...
QUESTION 1 "A single router is transmitting packets, each of length L bits, over a single link with transmission rate R Mbps to another router at the other end of the link. Suppose that the packet length is L= 12000 bits, and that the link transmission rate along the link to router on the right is R = 1000 Mbps. What is the maximum number of packets per second that can be transmitted by the link (use a whole number)?"...
Question 41 (1 point) A good example of fiber lines are multiplexed and demultiplexed. is the SONET network, in which multiple optical Frequency Division Multiplexing Time Division Multiplexing Wave Division Multiplexing Analog division multiplexing Save Question 42 (1 point) The role of the address field in a network defines end to end addressing. virtual circuit datagram circuit switching all of the above Save Question 43 (1 point) Analog to analog conversion (modulation) is the representation of analog information by an...