Which electrical cord would have more resistance: a 100-m cord or a 50-m cord? Explain
Which electrical cord would have more resistance: a 100-m cord or a 50-m cord? Explain
Explain how you would measure the following electrical quantities i. Low resistance ii. High resistance iii. Electrical energy
Suppose that you have a mass of 50 kg. When you pull the rip cord and the parachute opens, the air resistance force on you increases drastically and equals 2000 N upward. The magnitude of the acceleration is ______ m/s/s
An unreliable company produces a large shipment of blenders where 15% have a defective motor, and 23% have a defective electrical cord and 11% have both defects.If you randomly select a blender in this shipment, find the probability that it has...a) only a defective electrical cord. %Write your answer as a percent rounded to 1 decimal place, i.e. 86.2%. Do not include the percent symbol. b) a good motor. %Write your answer as a percent rounded to 1 decimal place, i.e. 86.2%. Do not include the percent...
Electrical resistors have a design resistance. The resistors are produced by a machine with an output that is Normally distributed with mean 501 ohms and standard deviation 3 ohms. Resistance below 498 ohms and above 508 ohms are rejected. Find: ( The proportion that will be rejected: (4marks) (1) How much the standard deviation would need to be reduced (leaving the mean at 501 ohms) so that the proportion of rejected below 498 ohms would be halved. (8marks)
The ball has a mass \(m\) and is attached to the cord of length \(I\). The cord is tied at the top to a swivel and the ball is given a velocity \(\mathbf{v}_{0}\). Show that the angle \(\theta\) which the cord makes with the vertical as the ball travels around the circular path must satisfy the equation tan \(\theta \sin \theta=v_{0}^{2} / g l\). Neglect air resistance and the size of the ball.
The ball has a mass m and is attached to the cord of length I. The cord is tied at the top to a swivel and the ball is given a velocity. Show that the angle which the cord makes with the vertical as the ball travels around the circular path must satisfy the equation. Neglect air resistance and the size of the ball.
2. [5pts] Write a MATLAB script that can calculate the equivalent resistance in a circuit that all electrical resistors are connected in parallel: . Print the title 'Equivalent Resistance for Resistors Connected in Parallel' on your output. . Check the size of vector resistor to see how many resistors in the circuit. .Check each individual resistance to see any 0 or negative resistance. If there is any, print message 'ERROR', then finish the program. . Otherwise, calculate the equivalent resistance...
If a certain machine makes electrical resistors that have an average resistance of 40 ohms and a standard deviation of 2 ohms, what is the probability that a random sample of 32 of these resistors has an average resistance of at most 39.5 ohms? Write the result with up to 4 decimals.
#1050 of LethalDose-101 The administration of 100 mmoles or more of potassium ions to a patient would probably be lethal. Which of the following would you consider to be a safe dose of potassium chloride (molar mass 74.55)? Select one: a. 500 ml of a 5 percent solution (w/v) b. 50 ml of a 2 M solution C. 125 ml of a 10g/100ml solution d. 25 ml of a 200 mM solution e.none of above #1085 of LethalDose-101 The administration...
7. A bungee jumper with mass m 50 kg leaps fron a bridge. The jumper is attached to the bridge by an elastic cord with axial stiffness k = 0.10 kN m-1. The cord unravels to its ful unstretched length 3.0s after the jumper has left the bridge. Starting from when the jumper leaves the bridge, determine the earliest time at which the elastic cord reaches its maximum extension. Neglect air resistance.[15