You connect a battery to a bulb, with one ammeter before the bulb in the circuit and one ammeter after the bulb, as shown. Will they read the same currents, or different currents
a. Current is not the same
b. Current is not the same because of charge conservation.
c.Current is the same because of electron conservation.
d. Current is the same as charge conservation
Solution:
option d should be right,
Current in the series circuit is same because of conservation of charge.
thanks.
You connect a battery to a bulb, with one ammeter before the bulb in the circuit...
1. A battery is connected to a light bulb, lighting the bulb. Where in the circuit is the current the greatest? A) inside the battery B) it's the same at all these points C) inside the light bulb filament D) between the light bulb and the negative terminal of the battery E) between the positive terminal of the battery and the light bulb 2. The emf of a battery is: A) its internal resistance B) the voltage difference it provides...
18 in detail please.
14. To charge a dead battery do you connect the (+) of the good battery to (+) of the dead battery and (-) of good to () of bad or the (+) of good battery to (-) of dead battery and () of good to (+) of bad battery? 15. Two copper wires of the same length and different diameters are connected in parallel In which case is (a) the resistance and (b) current in the...
1.A single light bulb is connected to a 12 V battery. The light bulb uses 55 W of power (which is about what a car’s headlight uses). (a) What is the current flowing out of the high-voltage (+) end of the battery? (b) What is the current flowing into the low-voltage (-) end of the battery? (c) The battery has a sticker on it that says “This 12V battery contains 50 Amp-hours.” This indicates Amps × hours that the battery...
5. Circuit B has battery voltage Vo-9.0 Volts and three identical bulbs. With the switch open, lamps 1 and 2 are in series, and the ammeter reads an initial current of 0.60 A. CirouitLamo 1 Lamp 1 (a) What will voltmeters V, and V2 read? Lamp 3 ) Lamp 2 (b) Determine the power in each lamp with the switch still open, as shown in the diagram. 2.7 w 2 2.7 (c) Now you close the switch so that lamps...
Consider a simple circuit with a light bulb, wires and battery, which of the following is true? The energy stored in the battery is dissipated energy The voltage gain at the battery is the same value as the voltage drop across the circuit The voltage can be measured at any one place in the circuit The current is smaller in the light bulb than on either side None of the above are true
A 6.0 V battery is connected to two 7.70 kilo-Ohm resistors in series. An ammeter of internal resistance 0.570 Ohm measures the current and at the same time a voltmeter with internal resistance 15.2 kilo-Ohm measures the voltage across one of the 7.70 kilo-Ohm resistors in the circuit. What does the ammeter read? What does the voltmeter read?
Part
II: Wheatstone Bridge
Procedure:
1) Before connecting the
circuit, use the multimeter as an ohmeter to verify the values of
all the resistances. Use the voltmeter measure the terminal voltage
of the battery. Use these measured values in all calculations.
R1 = 100 Ω
R2 = 200 Ω
R3 = 300 Ω
R4 = 200 Ω
R5 = 20 Ω
ξ = 6 V
Connect the circuit shown using
the multimeter as the ammeter.
2) Use a voltmeter to...
For the circuit shown in the figure, both meters are idealized, the battery has no appreciable internal resistance, and the ammeter reads 1.45 A.a) What does the voltmeter read?b) What is the emf ε of the battery?
For the circuit shown in (Figure 1) both meters are idealized, the battery has no appreciable internal resistance, and the ammeter reads 1.40 A. Part A What does the voltmeter read?Part B What is the emf & of the battery?
just the answer needed
You are given a circuit that contains a battery with three cells, wires and a light bulb. Which change would make the bulb shine less brightly? Choose all that apply. Select one or more: a decrease the resistance of the circuit b. increase the resistance of the circuit c. increase the voltage of the battery (add another cell) d. decrease the voltage of the battery (remove a cell) Check You should not touch electrical appliances with...