
9. If0.634C ofcharge crosses cross-sectional area of a in 0.41 seconds, calculate the average current flowing...
there is a velocity head flowing through a pipe with a calculated cross sectional area (6 inch schedule 460) If the pipe’s cross sectional area is doubled from calculated cross section to an unknown ft2 in, then calculate the velocity and velocity head. Note: acceleration due to gravity is 32 ft/s2
Acceleration EMF (a) A long straight rod with cross sectional area A and conductivity σ accelerates parallel to its length with acceleration a. Write down the Drude-like equation of motion for the average velocity v of an electron of mass m in the rod relative to the motion of the rod itself. Show that, in the absence of an external electric field, there is a steady solution that corresponds to a current 1 Aơma/e flowing in the wire. Assume that...
A large pipe with a cross sectional area A1=1.2 m2 has water flowing through it. The pressure in the pipe there is maintained at atmospheric pressure. The pipe then descends 3.7 m and narrows to a new cross sectional area A2. Water exits the pipe there into an environment at atmospheric pressure. What must the cross sectional area A2 of the pipe be in m2 if the water is exiting the pipe with a speed of 9.8 m/s?
The maximum rated current for a copper wire of cross-sectional
area 2 mm^2 is 20A. (a) What is the corresponding current density
in A/m^2? (b) On the assumption that each copper atom contributes
one conduction electron, calculate the electronic drift velocity
corresponding to this current density. (Avogadro's number =
6.02E10^23 atoms per mole; atomic weight of copper = 63.5; density
of copper = 8.92 g/cm^3.) (c) Use the observed conductivity to
calculate the average collision time for an electron in...
if a pipe flowing water has a cross sectional area nine times greater at point 2 than point 1, what would be the relation of flow of speed at the two points
A net charge of 20 C passes through the cross-sectional area of a wire in 1.7 min . What is the current in the wire?
An aluminum wire has a mobile charge density is 8.0e28 electrons/m3, and a cross-sectional area of 2.3e-6 m2. When a current flows through the wire, the average drift speed of the electrons is 1.7e-4 m/s. What is the current in the wire?
Question 9 (1 point) A long straight gold wire has a cross-sectional area of 5.69 x10-7m2. It carries a current f 2.98 A. What is the potential difference between two points in the wire 32.4 m apart? Provide your answer in Volts (V) Your Answer: Answer
water is flowing in a cylindrical pipe of varying circular cross sectional area and at all points the water completely fills the pipe a. at one point in the pipe, the radius is 0.150 m what is the speed of thecwater at this point if the volume flow rate in the pipe is 1.20 m^3/s ? b. at a second point in the pipe the water spped is 3.80 m/s What is the radius of the pipe at this point?...
QUESTION 7 A current-carrying ohmic metal wire has a cross-sectional area that gradually becomes smaller from one end (A) of the wire to the other end (B). A current / is passing through the wire. How does the current density vary along the wire as the area becomes smaller from end (4) to end (B)? A B Jincreases. decreases Not enough information OJ remains constant