what is better to choose Ge,GaAs,Si diode to implement logic circuit ? explain why?
Germanium(Ge) diode is better than the remaining given for implementing logic circuits.
what is better to choose Ge,GaAs,Si diode to implement logic circuit ? explain why?
what would you choose Ge, GaAs, Si for implementing logic gate circut ? explain why ?
(10) choose Si or Ge? Why? If you were to specify a Photo Diode for 850nm operation, would you
A GaAs varactor diode with a linearly graded junction is used to tune the oscillator circuit shown below. At zero applied bias voltage, the varactor has a junction capacitance C, of3 pF. VM1.3V for GaAs. The negative resistance oscillator diode has Cp- 2 pF. The load has L,-10nH. a. What is the oscillation frequency with 0V applied to the varactor? b. What is the oscillation frequency with -20V applied to the varactor? C. v Co 0
A GaAs varactor diode...
what is the bonding type in Si=Ge polar/nonpolar covalent donor acceptor multi center multi electron explain
e Calculate the position of EF with respect to E. 5. Explain why holes are found wny holes are found near the top of the valence band, whereas conduction electrons are found at the bottom of the conduction band. O. Using the Figure 3-17 in your text (also attached), fill in the following table: Semiconductor 300°K 400°K 500°K Ge GaAs For Ge at 500°K and Si at 400°K, show on the attached graph how you determined the value you put...
This problem is again about anti-windup logic. . Explain, in your own words, what anti-windup logic is and why is it used. Do you need to implement anti-windup logic if the actuator does not have saturation? Do you need anti-windup if there is no integral action in the controller? Do you need anti-windup if the plant has an integrator?
Taking pure silicon (Si) as an example, explain what is meant by the terms electron-hole generation and recombination, how they affect the electrical conductivity, and define what is meant by the "intrinsic carrier density", n. [5 marks] Q3. a) b) With the aid of both lattice and energy band diagrams, explain how n-type doping of Si is achieved and state two types of suitable dopant atoms. [7 marks] c) An n-type region on a Si wafer has a donor concentration...
3.1 What is the functional difference between a normal diode and a Zener diode? 3.4 What are the three states of operation of a BJT? 3.8 What information does a timing diagram give? 3.9 What is the difference between combinational and sequential logic circuits? 3.10 What is a Karnaugh map? 3.11 Why do many digital circuits have clocked input? 3.12 Explain the function of a multiplexer. 3.13 What is the difference between an SR and a JK flip-flop? 3.14 How...
4. In the diode circuit below diodes Day and Da2 are identical have a voltage of 0.7V at ImA current. The diodes Dbị and Db2 are identical and have 10 times the junction area of Dal. Also all diodes have n=2 and VI = 25mV. The circuit employs a supply current ISUPPLY=20mA. (a) Draw the i-v curve for diodes Da and D. Label axes and all relevant points. [8] (b) Find the value of Vout at nominal supply and no...
1. [15] Consider the schematic below. a) [5] What Boolean function does the circuit implement? b) (5) If the circuit has any logic hazards, draw a K-map showing the original function as implemented along with any additional terms needed to remove them. c) [5] Write logic hazard-free function.